
51
6175H–ATARM–03-Dec-07
AT91SAM7S Series Preliminary
12.5
Functional Description
12.5.1
Test Pin
One dedicated pin, TST, is used to define the device operating mode. The user must make sure
that this pin is tied at low level to ensure normal operating conditions. Other values associated
with this pin are reserved for manufacturing test.
12.5.2
EmbeddedICE
(Embedded In-circuit Emulator)
The ARM7TDMI EmbeddedICE is supported via the ICE/JTAG port.The internal state of the
ARM7TDMI is examined through an ICE/JTAG port.
The ARM7TDMI processor contains hardware extensions for advanced debugging features:
In halt mode, a store-multiple (STM) can be inserted into the instruction pipeline. This exports
the contents of the ARM7TDMI registers. This data can be serially shifted out without
affecting the rest of the system.
In monitor mode, the JTAG interface is used to transfer data between the debugger and a
simple monitor program running on the ARM7TDMI processor.
There are three scan chains inside the ARM7TDMI processor that support testing, debugging,
and programming of the Embedded ICE. The scan chains are controlled by the ICE/JTAG port.
EmbeddedICE mode is selected when JTAGSEL is low. It is not possible to switch directly
between ICE and JTAG operations. A chip reset must be performed after JTAGSEL is changed.
For further details on the EmbeddedICE, see the ARM7TDMI (Rev4) Technical Reference Man-
ual (DDI0210B).
12.5.3
Debug Unit
The Debug Unit provides a two-pin (DXRD and TXRD) USART that can be used for several
debug and trace purposes and offers an ideal means for in-situ programming solutions and
debug monitor communication. Moreover, the association with two peripheral data controller
channels permits packet handling of these tasks with processor time reduced to a minimum.
The Debug Unit also manages the interrupt handling of the COMMTX and COMMRX signals
that come from the ICE and that trace the activity of the Debug Communication Channel.The
Debug Unit allows blockage of access to the system through the ICE interface.
A specific register, the Debug Unit Chip ID Register, gives information about the product version
and its internal configuration.
Table 12-2.
AT91SAM7S Series Debug Unit Chip ID
Chip Name
Chip ID
AT91SAM7S16
0x27050240
AT91SAM7S161
0x27050241
AT91SAM7S32
0x27080340
AT91SAM7S321
0x27080342
AT91SAM7S64
0x27090540
AT91SAM7S128
0x270A0740
AT91SAM7S128 Rev B
0x270C0741