- 您現在的位置：買賣IC網 > PDF目錄12057 > AT90USB82-16MU (Atmel)IC AVR MCU 8K FLASH 32QFN PDF資料下載
參數資料
| 型號： | AT90USB82-16MU |
| 廠商： | Atmel |
| 文件頁數： | 13/38頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AVR MCU 8K FLASH 32QFN |
| 產品培訓模塊： | MCU Product Line Introduction megaAVR Introduction |
| 標準包裝： | 2,450 |
| 系列： | AVR® 90USB |
| 核心處理器： | AVR |
| 芯體尺寸： | 8-位 |
| 速度： | 16MHz |
| 連通性： | EBI/EMI，PS/2，SPI，UART/USART，USB |
| 外圍設備： | 欠壓檢測/復位，POR，PWM，WDT |
| 輸入/輸出數： | 22 |
| 程序存儲器容量： | 8KB（8K x 8） |
| 程序存儲器類型： | 閃存 |
| EEPROM 大?。?/td> | 512 x 8 |
| RAM 容量： | 512 x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 32-VFQFN 裸露焊盤 |
| 包裝： | 托盤 |
| 產品目錄頁面： | 611 (CN2011-ZH PDF) |
| 配用： | ATSTK600-TQFP32-ND - STK600 SOCKET/ADAPTER 32-TQFP ATSTK526-ND - KIT STARTER FOR AT90USB82/162 ATAVRDRAGON-ND - KIT DRAGON FLASH MEM AVR ATSTK525-ND - KIT STARTER FOR AT90USB AT90USBKEY2-ND - KIT DEMO FOR AT90USB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁
20
7707F–AVR–11/10
AT90USB82/162
5.3.4
The EEPROM Control Register – EECR
Bits 7..6 – Res: Reserved Bits
These bits are reserved bits in the AT90USB82/162 and will always read as zero.
Bits 5, 4 – EEPM1 and EEPM0: EEPROM Programming Mode Bits
The EEPROM Programming mode bit setting defines which programming action that will be trig-
gered when writing EEPE. It is possible to program data in one atomic operation (erase the old
value and program the new value) or to split the Erase and Write operations in two different
operations. The Programming times for the different modes are shown in Table 5-1. While EEPE
is set, any write to EEPMn will be ignored. During reset, the EEPMn bits will be reset to 0b00
unless the EEPROM is busy programming.
Bit 3 – EERIE: EEPROM Ready Interrupt Enable
Writing EERIE to one enables the EEPROM Ready Interrupt if the I bit in SREG is set. Writing
EERIE to zero disables the interrupt. The EEPROM Ready interrupt generates a constant inter-
rupt when EEPE is cleared.
Bit 2 – EEMPE: EEPROM Master Programming Enable
The EEMPE bit determines whether setting EEPE to one causes the EEPROM to be written.
When EEMPE is set, setting EEPE within four clock cycles will write data to the EEPROM at the
selected address If EEMPE is zero, setting EEPE will have no effect. When EEMPE has been
written to one by software, hardware clears the bit to zero after four clock cycles. See the
description of the EEPE bit for an EEPROM write procedure.
Bit 1 – EEPE: EEPROM Programming Enable
The EEPROM Write Enable Signal EEPE is the write strobe to the EEPROM. When address
and data are correctly set up, the EEPE bit must be written to one to write the value into the
EEPROM. The EEMPE bit must be written to one before a logical one is written to EEPE, other-
wise no EEPROM write takes place. The following procedure should be followed when writing
the EEPROM (the order of steps 3 and 4 is not essential):
1.
Wait until EEPE becomes zero.
2.
Wait until SELFPRGEN in SPMCSR becomes zero.
3.
Write new EEPROM address to EEAR (optional).
Bit
7
6
5432
10
–
EEPM1
EEPM0
EERIE
EEMPE
EEPE
EERE
EECR
Read/Write
R
R/W
Initial Value
0
X
0
X
0
Table 5-1.
EEPROM Mode Bits
EEPM1
EEPM0
Programming
Time
Operation
0
3.4 ms
Erase and Write in one operation (Atomic Operation)
0
1
1.8 ms
Erase Only
1
0
1.8 ms
Write Only
1
–
Reserved for future use
相關PDF資料 |
PDF描述 |
|---|---|
| ATMEGA48P-20PU | MCU AVR 4K ISP FLASH 20MHZ 28DIP |
| VI-JT3-IX-B1 | CONVERTER MOD DC/DC 24V 75W |
| P89LPC935FA,129 | IC 80C51 MCU FLASH 8K 28-PLCC |
| P89LPC932A1FA,129 | IC 80C51 MCU FLASH 8K 28-PLCC |
| AT89C51RC-24JU | IC 8051 MCU FLASH 32K 44PLCC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AT90USB82-16MUR | 功能描述:8位微控制器 -MCU 8K Flash RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| AT90USBKEY | 功能描述:開發板和工具包 - AVR Demo board f/AVR MCU & AT90USB RoHS:否 制造商:Arduino 產品:Evaluation Boards 工具用于評估:ATMega32U4 核心:AVR 接口類型:I2C, UART, USB 工作電源電壓:6 V to 20 V |
| AT90USBKEY2 | 功能描述:開發板和工具包 - AVR AVR USB Eval Kit RoHS:否 制造商:Arduino 產品:Evaluation Boards 工具用于評估:ATMega32U4 核心:AVR 接口類型:I2C, UART, USB 工作電源電壓:6 V to 20 V |
| AT-910 | 制造商:HRS 制造商全稱:HRS 功能描述:Stripline Mounting Fixed Attenuators (DC to 8 GHz) |
| AT-910(40) | 功能描述:衰減器 -IC RoHS:否 制造商:Skyworks Solutions, Inc. 最大衰減:18 dB 容差: 阻抗: 功率額定值:30 dBm 安裝風格:SMD/SMT 工作溫度范圍:- 40 C to + 85 C |
發布緊急采購，3分鐘左右您將得到回復。