- 您現在的位置：買賣IC網 > PDF目錄385093 > AK4561 (Asahi Kasei Microsystems Co.,Ltd) 16bit CODEC with built-in ALC and MIC/HP-Amp PDF資料下載
參數資料
| 型號： | AK4561 |
| 廠商： | Asahi Kasei Microsystems Co.,Ltd |
| 元件分類： | Codec |
| 英文描述： | 16bit CODEC with built-in ALC and MIC/HP-Amp |
| 中文描述： | 16位編解碼器在ALC和內置麥克風/惠普放大器 |
| 文件頁數： | 31/48頁 |
| 文件大?。?/td> | 332K |
| 代理商： | AK4561 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁當前第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
ASAHI KASEI
AKM CONFIDENTIAL
[AK4561]
Rev. 0.9
2000/09
- 31 -
1. Pre-Amp
Pre-Amp is non-inverting amplifier and internally biased to MVCM voltage with 100k
(typ.). Gain value of Pre-Amp is
adjusted by S6-5 bits. Their value is +12dB
～
+24dB and 4dB step.
Input impedance is changed by the set of gain. Input impedance value is precision in typ
±
30%.
S6
0
0
1
1
S5
0
1
0
1
Gain
+12dB
+16dB
+20dB
+24dB
Ri (typ)
2.4k
1.5k
950
600
RESET
An external capacitor needs to cancel DC gain. Cut-off frequency is decided by internal input resistor (Ri) and an external
capacitor (C).
Figure 13. Pre-Amp Block
2. EQ-Amp
EQ-Amp is block to emphasize a stereo feeling at using Internal MIC Mode. EQ-Amp can be emphasized by adding the
output signal from pre-amplifier and the opposite channel differentially.
When External MIC Mode is selected, EQ-Amp does not connect.
Power ON/OFF of EQ-Amp and Inverter-Amp is enabled by EQ bit. When EQ bit is “1”, they can be ON/OFF by PM0
bit. When EQ bit is “0”, these amplifiers are OFF then PM0 bit is not relative.
3. HPF-Amp
To cancel wind-noise, AK4561 has the HPF-Amp which is non-inverting amplifier, 2
nd
order high pass filter and gain of
0dB. The HPF-Amp can be ON/OFF by controlling the internal registers. In case of OFF, HPF-Amp becomes a unity gain
buffer. This HPF-Amp can use when Internal MIC Mode is selected. In case of External MIC Mode, the control of
HPF-Amp is invalid and becomes a unity gain buffer.
4. Power Supply for MIC
Power Supply for microphone is supplied from MPWR pin. Output voltage is typically 2.0V and MPWR pin can supply
the current until 3mA.
When PM0 bit is “0”, the power supply current can be stopped.
+
-
Pre Amp
INT_MIC
EXT_MIC
Ri
Ci
相關PDF資料 |
PDF描述 |
|---|---|
| AK4561VQ | 16bit CODEC with built-in ALC and MIC/HP-Amp |
| AK4562 | LOW POWER 20BIT CODEC WITH PGA |
| AK4562VN | LOW POWER 20BIT CODEC WITH PGA |
| AK4563A | Low Power 16bit 4ch ADC & 2ch DAC with ALC |
| AK4563AVF | Low Power 16bit 4ch ADC & 2ch DAC with ALC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AK4561VQ | 制造商:AKM 制造商全稱:AKM 功能描述:16bit CODEC with built-in ALC and MIC/HP-Amp |
| AK4562 | 制造商:AKM 制造商全稱:AKM 功能描述:EVALUATION BOARD REV.A FOR AK4562 |
| AK4562VN | 制造商:AKM 制造商全稱:AKM 功能描述:LOW POWER 20BIT CODEC WITH PGA |
| AK4563A | 制造商:AKM 制造商全稱:AKM 功能描述:Low Power 16bit 4ch ADC & 2ch DAC with ALC |
| AK4563AVF | 制造商:AKM 制造商全稱:AKM 功能描述:Low Power 16bit 4ch ADC & 2ch DAC with ALC |
發布緊急采購，3分鐘左右您將得到回復。