- 您現在的位置：買賣IC網 > PDF目錄385093 > AK4561 (Asahi Kasei Microsystems Co.,Ltd) 16bit CODEC with built-in ALC and MIC/HP-Amp PDF資料下載
參數資料
| 型號： | AK4561 |
| 廠商： | Asahi Kasei Microsystems Co.,Ltd |
| 元件分類： | Codec |
| 英文描述： | 16bit CODEC with built-in ALC and MIC/HP-Amp |
| 中文描述： | 16位編解碼器在ALC和內置麥克風/惠普放大器 |
| 文件頁數： | 15/48頁 |
| 文件大?。?/td> | 332K |
| 代理商： | AK4561 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
ASAHI KASEI
AKM CONFIDENTIAL
[AK4561]
Rev. 0.9
2000/09
- 15 -
OPERATION OVERVIEW
n
System Clock
The clock which are required to operate are MCLK (256fs/384fs), LRCK (fs), BCLK (32fs
～
). The master clock (MCLK)
should be synchronized with LRCK but the phase is free of care.
The MCLK can be input 256fs or 384fs. When 384fs is input, the internal master clock is divided into 2/3 automatically.
* fs is sampling frequency.
When the synchronization is out of phase by changing the clock frequencies during normal operation, the AK4561 may
occur click noise. In case of DAC, click noise is avoided by setting the inputs to “0”.
All external clocks (MCLK, BCLK and LRCK) should always be present. If these clocks are not provided, the AK4561
may draw excess current and it is not possible to operate properly because utilizes dynamic refreshed logic internally. If
the external clocks are not present, the AK4561 should be in the power-down mode. (Refer to the “Power Management
Mode”.)
n
System Reset
AK4561 should be reset once by bringing PD pin “L” upon power-up. After the system reset operation, the all internal
AK4561 registers become initial value.
Initializing cycle is 8224/fs=171.3ms@fs=48kHz. During initializing cycle, the ADC digital data outputs of both
channels are forced to a 2's compliment, “0”. Output data of ADC settles data equivalent for analog input signal after
initializing cycle. This cycle is not for DAC.
As a normal initializing cycle may not be executed, nothing writes at address 02H during initializing cycle.
n
Digital High Pass Filter
The ADC has HPF for the DC offset cancel. The cut-off frequency of HPF is 3.7Hz (@fs=48kHz) and it is -0.15dB at
22Hz. It also scales with the sampling frequency (fs).
相關PDF資料 |
PDF描述 |
|---|---|
| AK4561VQ | 16bit CODEC with built-in ALC and MIC/HP-Amp |
| AK4562 | LOW POWER 20BIT CODEC WITH PGA |
| AK4562VN | LOW POWER 20BIT CODEC WITH PGA |
| AK4563A | Low Power 16bit 4ch ADC & 2ch DAC with ALC |
| AK4563AVF | Low Power 16bit 4ch ADC & 2ch DAC with ALC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AK4561VQ | 制造商:AKM 制造商全稱:AKM 功能描述:16bit CODEC with built-in ALC and MIC/HP-Amp |
| AK4562 | 制造商:AKM 制造商全稱:AKM 功能描述:EVALUATION BOARD REV.A FOR AK4562 |
| AK4562VN | 制造商:AKM 制造商全稱:AKM 功能描述:LOW POWER 20BIT CODEC WITH PGA |
| AK4563A | 制造商:AKM 制造商全稱:AKM 功能描述:Low Power 16bit 4ch ADC & 2ch DAC with ALC |
| AK4563AVF | 制造商:AKM 制造商全稱:AKM 功能描述:Low Power 16bit 4ch ADC & 2ch DAC with ALC |
發布緊急采購，3分鐘左右您將得到回復。