參數資料
型號： ADM6996L
廠商： INFINEON TECHNOLOGIES AG
英文描述： 6 port 10/100 Mb/s Single Chip Ethernet Switch Controller
中文描述： 6端口10/100 Mb / s的單芯片以太網交換機控制器
文件頁數： 20/61頁
文件大小： 1743K
代理商： ADM6996L
ADM6996L
Function Description
3.4.8 Receive Errors
The RXER signal is used to communicate receiver error conditions. While the receiver is
in a state of holding RXDV asserted, the RXER will be asserted for each code word that
does not map to a valid code-group.
3.4.9 100Base-X Link Monitor
The 100Base-X link monitor function allows the receiver to ensure that reliable data is
being received. Without reliable data reception, the link monitor will halt both transmit
and receive operations until such time that a valid link is detected.
The ADM6996L performs the link integrity test as outlined in IEEE 100Base-X (Clause
24) link monitor state diagram. The link status is multiplexed with 10Mbits/s link status
to form the reportable link status bit in serial management register 1h, and driven to the
LNKACT pin.
When persistent signal energy is detected on the network, the logic moves into a Link-
Ready state after approximately 500 us, and waits for an enable from the auto negotiation
module. When receive, the link-up state is entered, and the transmission and reception
logic blocks become active. Should auto negotiation be disabled, the link integrity logic
moves immediately to the link-up state after entering the link-ready state.
3.4.10 Carrier Sense
Carrier sense (CRS) for 100Mbits/s operation is asserted upon the detection of two
noncontiguous zeros occurring within any 10-bit boundary of the received data stream.
The carrier sense function is independent of symbol alignment. In switch mode, CRS is
asserted during either packet transmission or reception. For repeater mode, CRS is
asserted only during packet reception. When the idle symbol pair is detected in the
received data stream, CRS is de-asserted. In repeater mode, CRS is only asserted due to
receive activity. CRS is intended to encapsulate RXDV.
3.4.11 Bad SSD Detection
A bad start of stream delimiter (Bad SSD) is an error condition that occurs in the
100Base-X receiver if carrier is detected (CRS asserted) and a valid /J/K set of code-
group (SSD) is not received.
If this condition is detected, then the ADM6996L will assert RXER and present
RXD[3:0] = 1110 to the internal MII for the cycles hat correspond to received 5B code-
groups until at least two idle code-groups are detected. Once at least two idle code groups
are detected, RXER and CRS become de-asserted.
Infineon-ADMtek Co. Ltd.
3-4
相關PDF資料
PDF描述
ADM8262 Wireless LAN 802.11a/b/g Controller
AIC1383B 3A TERMINATION REGULATOR
AIC1383BCE5TR 3A TERMINATION REGULATOR
AIC1383BCM5TR 3A TERMINATION REGULATOR
AIC1383BCSTR 3A TERMINATION REGULATOR
相關代理商/技術參數
參數描述
ADM6996LAAT1 功能描述:IC SWITCH CTRLR 10/100 128PQFP RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A
ADM6996L-AA-T-1 制造商:Rochester Electronics LLC 功能描述:ETHERNET SWITCH - Bulk
ADM6996LAAT1NP 制造商:Infineon Technologies AG 功能描述:Ethernet CTLR Single Chip 10Mbps/100Mbps 3.3V 128-Pin MQFP Tray
ADM6996LC 制造商:Infineon Technologies AG 功能描述:
ADM6996LC-AC-R-1 功能描述:IC ETHERNET SW CTRLR 128-PQFP RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*