參數資料
型號: ADM6996F
廠商: INFINEON TECHNOLOGIES AG
英文描述: 6 port 10/100 Mb/s Single Chip Ethernet Switch Controller
中文描述: 6端口10/100 Mb / s的單芯片以太網交換機控制器
文件頁數: 25/69頁
文件大?。?/td> 2099K
代理商: ADM6996F
ADM6996F
Function Description
and timing measurements (as specified in the IEEE 802.3 10Base-T standard) to
determine the validity of data on the twisted-pair inputs.
The signal at the start of the packet is checked by the analog squelch circuit and any
pulses not exceeding the squelch level (either positive or negative, depending upon
polarity) will be rejected. Once this first squelch level is overcome correctly, the opposite
squelch level must then be exceeded within 150ns. Finally, the signal must exceed the
original squelch level within an additional 150ns to ensure that the input waveform will
not be rejected.
Only after all these conditions have been satisfied will a control signal be generated to
indicate to the remainder of the circuitry that valid data is present.
Valid data is considered to be present until the squelch level has not been generated for a
time longer than 200 ns, indicating end of packet. Once good data has been detected, the
squelch levels are reduced to minimize the effect of noise, causing premature end-of-
packet detection. The receive squelch threshold level can be lowered for use in longer
cable applications. This is achieved by setting bit 10 of register address 11h.
3.7 Carrier Sense
Carrier Sense (CRS) is asserted due to receive activity once valid data is detected via the
smart squelch function. For 10 Mbits/s half duplex operation, CRS is asserted during
either packet transmission or reception. For 10 Mbits/s full duplex and repeater mode
operations, the CRS is asserted only due to receive activity.
3.8 Jabber Function
The jabber function monitors the ADM6996F output and disables the transmitter if it
attempts to transmit a longer than legal sized packet. If TXEN is high for greater than
24ms, the 10Base-T transmitter will be disabled. Once disabled by the jabber function,
the transmitter stays disabled for the entire time that the TXEN signal is asserted. This
signal has to be de-asserted for approximately 256 ms (The un-jab time) before the jabber
function re-enables the transmit outputs. The jabber function can be disabled by
programming bit 4 of register address 10h to high.
3.9 Link Test Function
A link pulse is used to check he integrity of the connection with the remote end. If valid
link pulses are not received, the link detector disables the 10Base-T twisted-pair
transmitter, receiver, and collision detection functions.
The link pulse generator produces pulses as defined in IEEE 802.3 10Base-T standard.
Each link pulse is nominally 100ns in duration and is transmitted every 16 ms, in the
absence of transmit data.
Infineon-ADMtek Co Ltd.
3-7
相關PDF資料
PDF描述
ADM6996L 6 port 10/100 Mb/s Single Chip Ethernet Switch Controller
ADM8262 Wireless LAN 802.11a/b/g Controller
AIC1383B 3A TERMINATION REGULATOR
AIC1383BCE5TR 3A TERMINATION REGULATOR
AIC1383BCM5TR 3A TERMINATION REGULATOR
相關代理商/技術參數
參數描述
ADM6996FAAT1 功能描述:IC SWITCH CTRLR 10/100 128PQFP RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN(6x6) 包裝:* 其它名稱:Q6396337A
ADM6996FCX-AC-T-1 功能描述:IC ETHERNET SW CTRLR 128-PQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN(6x6) 包裝:* 其它名稱:Q6396337A
ADM6996FCXACT1XP 制造商:Infineon Technologies AG 功能描述:GREEN, SWITCH / PHY
ADM6996FCX-AD-R-1 功能描述:開關變換器、穩壓器與控制器 SWITCH / PHY RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel
ADM6996FCXADR1XT 制造商:Infineon Technologies AG 功能描述:SWITCH / PHY