參數資料
型號: ADL5387-EVALZ1
廠商: Analog Devices, Inc.
英文描述: 50 MHz to 2 GHz Quadrature Demodulator
中文描述: 50兆赫至2千兆赫正交解調器
文件頁數: 14/28頁
文件大小: 648K
代理商: ADL5387-EVALZ1
ADL5387
CIRCUIT DESCRIPTION
The ADL5387 can be divided into five sections: the local
oscillator (LO) interface, the RF voltage-to-current (V-to-I)
converter, the mixers, the differential emitter follower outputs,
and the bias circuit. A detailed block diagram of the device is
shown in Figure 45.
Rev. 0 | Page 14 of 28
RFIP
RFIN
BIAS
DIVIDE-BY-TWO
QUADRATURE
PHASE SPLITTER
IHI
ILO
LOIP
LOIN
QHI
QLO
0
Figure 45. Block Diagram
The LO interface generates two LO signals at 90° of phase
difference to drive two mixers in quadrature. RF signals are
converted into currents by the V-to-I converters that feed into
the two mixers. The differential I and Q outputs of the mixers
are buffered via emitter followers. Reference currents to each
section are generated by the bias circuit. A detailed description
of each section follows.
LO INTERFACE
The LO interface consists of a buffer amplifier followed by a
frequency divider that generate two carriers at half the input
frequency and in quadrature with each other. Each carrier is
then amplified and amplitude-limited to drive the double-
balanced mixers.
V-TO-I CONVERTER
The differential RF input signal is applied to a resistively
degenerated common base stage, which converts the differential
input voltage to output currents. The output currents then
modulate the two half-frequency LO carriers in the mixer stage.
MIXERS
The ADL5387 has two double-balanced mixers: one for the
in-phase channel (I channel) and one for the quadrature channel
(Q channel). These mixers are based on the Gilbert cell design
of four cross-connected transistors. The output currents from
the two mixers are summed together in the resistive loads that
then feed into the subsequent emitter follower buffers.
EMITTER FOLLOWER BUFFERS
The output emitter followers drive the differential I and Q
signals off-chip. The output impedance is set by on-chip 25 Ω
series resistors that yield a 50 Ω differential output impedance
for each baseband port. The fixed output impedance forms a
voltage divider with the load impedance that reduces the effective
gain. For example, a 500 Ω differential load has 1 dB lower
effective gain than a high (10 kΩ) differential load impedance.
BIAS CIRCUIT
A band gap reference circuit generates the proportional-to-
absolute temperature (PTAT) as well as temperature-independent
reference currents used by different sections. The mixer current
can be reduced via an external resistor between the BIAS pin
and ground. When the BIAS pin is open, the mixer runs at
maximum current and hence the greatest dynamic range. The
mixer current can be reduced by placing a resistance to ground;
therefore, reducing overall power consumption, noise figure,
and IIP3. The effect on each of these parameters is shown in
Figure 10, Figure 13, and Figure 14.
相關PDF資料
PDF描述
ADL5390-EVAL RF/IF Vector Multiplier
ADL5390ACPZ-REEL71 RF/IF Vector Multiplier
ADL5390ACPZ-WP1 RF/IF Vector Multiplier
ADL5390 RF/IF Vector Multiplier
ADL5391 DC to 2.0 GHz Multiplier
相關代理商/技術參數
參數描述
ADL5390 制造商:AD 制造商全稱:Analog Devices 功能描述:400 MHz to 6 GHz Broadband Quadrature Modulator
ADL5390ACPZ 制造商:Analog Devices 功能描述:RF/IF VECTOR MLTPLR 24LFCSP - Tape and Reel 制造商:Analog Devices 功能描述:RF VECTOR MULTIPLIER 2.3GHZ SMD 制造商:Analog Devices 功能描述:RF Vector Multiplier,wideband,ADL5390
ADL5390ACPZ-REEL7 功能描述:IC MULTIPLIER VECTOR 24LFCSP RoHS:是 類別:RF/IF 和 RFID >> RF 其它 IC 和模塊 系列:- 標準包裝:100 系列:*
ADL5390ACPZ-REEL71 制造商:AD 制造商全稱:Analog Devices 功能描述:RF/IF Vector Multiplier
ADL5390ACPZ-WP 功能描述:IC MULTIPLIER RF VECTOR 24-LFCSP RoHS:是 類別:RF/IF 和 RFID >> RF 其它 IC 和模塊 系列:- 標準包裝:100 系列:*