- 您現在的位置：買賣IC網 > PDF目錄8627 > ADL5310ACPZ-REEL7 (Analog Devices Inc)IC CONV DUAL LOGARITHMIC 24LFCSP PDF資料下載
參數資料
| 型號： | ADL5310ACPZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC CONV DUAL LOGARITHMIC 24LFCSP |
| 設計資源： | Interfacing ADL5315 to Translinear Logarithmic Amplifier (CN0056) Interfacing ADL5317 High Side Current Mirror to a Translinear Logarithmic Amplifier in an Avalanche Photodiode Power Detector |
| 標準包裝： | 1 |
| 類型： | 對數轉換器 |
| 應用： | 光纖 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 24-LFCSP-VQ（4x4） |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 772 (CN2011-ZH PDF) |
| 其它名稱： | ADL5310ACPZ-REEL7DKR |
ADL5310
Rev. A | Page 12 of 20
The voltage VLOG is generated by applying ILOG to an internal
resistance of 4.55 k, formed by the parallel combination of a
6.69 k resistor to ground and a 14.2 k resistor to Pin VRDZ
(typically tied to the 2.5 V reference, VREF). At the LOG1
(LOG2) pin, the output current ILOG generates a voltage of
VLOG = ILOG × 4.55 k
= 44 A × 4.55 k × log10(IPD/IINTC)
(5)
= VY log10(IPD/IINTC)
where VY = 200 mV/decade or 10 mV/dB. Note that any resis-
tive loading on LOG1 (LOG2) lowers this slope and results in
an overall scaling uncertainty. This is due to the variability of
the on-chip resistors compared to the off-chip load. As a con-
sequence, this practice is not recommended.
VLOG may also swing below ground when dual supplies (VP and
VN) are used. When VN = 0.5 V or larger, the input Pins INP1
(INP2) and IRF1 (INP2) may be positioned at ground level
simply by grounding VSUM. Care must be taken to limit the
power consumed by the input BJT devices when using a larger
negative supply, because self-heating degrades the accuracy at
higher currents.
MANAGING INTERCEPT AND SLOPE
When using a single supply, VRDZ should be directly connected
to VREF to allow operation over the entire 6-decade input
current range. As noted in the Theory section, this introduces
an accurate offset voltage of 0.8 V at the LOG1 and LOG2 pins,
equivalent to four decades, resulting in a logarithmic transfer
function that can be written as
VLOG = VY log10(104 × IPD/IREF)
= VY log10(IPD/IINTC)
(6)
where IINTC = IREF/104.
Thus, the effective intercept current IINTC is only one ten-
thousandth of IREF, corresponding to 300 pA when using the
recommended value of IREF = 3 A.
The slope can be reduced by attaching a resistor between the log
amp output pin, LOG1 or LOG2, and ground. This is strongly
discouraged given that the on-chip resistors do not ratio
correctly to the added resistance. Also, it is rare that one would
wish to lower the basic slope of 10 mV/dB; if this is needed, it
should be effected at the low impedance output of the buffer
amps, which are provided to avoid such miscalibration and to
allow higher slopes to be used.
Each of the ADL5310’s buffers is essentially an uncommitted
operational amplifier with rail-to-rail output swing, good load-
driving capabilities, and a typical unity-gain bandwidth of
15 MHz. In addition to allowing the introduction of gain, using
standard feedback networks and thereby increasing the slope
voltage VY, the buffer can be used to implement multipole, low-
pass filters, threshold detectors, and a variety of other functions.
Further details on these applications can be found in the
AD8304 data sheet.
RESPONSE TIME AND NOISE CONSIDERATIONS
The response time and output noise of the ADL5310 are funda-
mentally a function of the signal current, IPD. For small currents,
output low frequency voltage-noise spectral-density is a
values of IREF. Details of the noise and bandwidth performance
of translinear log amps can be found in the AD8304 data sheet.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-2WK-IV-F4 | CONVERTER MOD DC/DC 40V 150W |
| VI-27K-MW-B1 | CONVERTER MOD DC/DC 40V 100W |
| VE-2WK-IV-F3 | CONVERTER MOD DC/DC 40V 150W |
| VI-27J-MW-B1 | CONVERTER MOD DC/DC 36V 100W |
| AD8332ACPZ-R7 | IC AMP VAR GAIN 2CHAN 32-LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADL5310-EVAL | 制造商:Analog Devices 功能描述:DEV TOOLS, EVAL BD, 120DB RANGE (3 NA TO 3 MA) DUAL LOGARITH - Bulk |
| ADL5315 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision Wide Range (3 nA to 3 mA) High-Side Current Mirror |
| ADL5315ACPZ-R2 | 制造商:Analog Devices 功能描述: |
| ADL5315ACPZ-R7 | 功能描述:IC CURRENT MONITOR 8LFCSP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩流/電流管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 功能:電流開關 檢測方法:- 精確度:±10% 輸入電壓:1.7 V ~ 5.5 V 電流 - 輸出:600mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-UFQFN 供應商設備封裝:10-UTQFN（1.4x1.8） 包裝:管件 |
| ADL5315ACPZ-WP | 制造商:Analog Devices 功能描述:SP AMP LOG AMP SGL 8V 8LFCSP EP - Bulk |
發布緊急采購，3分鐘左右您將得到回復。