- 您現在的位置：買賣IC網 > PDF目錄9088 > ADF4351BCPZ-RL7 (Analog Devices Inc)IC SYNTH PLL VCO 32LFCSP PDF資料下載
參數資料
| 型號： | ADF4351BCPZ-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SYNTH PLL VCO 32LFCSP |
| 標準包裝： | 1,500 |
| 類型： | 扇出配送，分?jǐn)?shù)-N，整數-N，時鐘/頻率合成器（RF） |
| PLL： | 是 |
| 輸入： | CMOS，TTL |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 1:3 |
| 差分 - 輸入:輸出： | 無/無 |
| 頻率 - 最大： | 4.4GHz |
| 除法器/乘法器： | 是/是 |
| 電源電壓： | 3 V ~ 3.6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 32-LFCSP（5x5） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ADF4351
Data Sheet
Rev. 0 | Page 12 of 28
MUXOUT AND LOCK DETECT
The multiplexer output on the ADF4351 allows the user to access
various internal points on the chip. The state of MUXOUT is
controlled by the M3, M2, and M1 bits in Register 2 (see Figure 26).
Figure 19 shows the MUXOUT section in block diagram form.
DGND
DVDD
CONTROL
MUX
MUXOUT
ANALOG LOCK DETECT
DIGITAL LOCK DETECT
R COUNTER OUTPUT
N DIVIDER OUTPUT
DGND
RESERVED
THREE-STATE OUTPUT
DVDD
09800-
008
Figure 19. MUXOUT Schematic
INPUT SHIFT REGISTERS
The ADF4351 digital section includes a 10-bit RF R counter,
a 16-bit RF N counter, a 12-bit FRAC counter, and a 12-bit
modulus counter. Data is clocked into the 32-bit shift register
on each rising edge of CLK. The data is clocked in MSB first.
Data is transferred from the shift register to one of six latches
on the rising edge of LE. The destination latch is determined by
the state of the three control bits (C3, C2, and C1) in the shift
register. As shown in Figure 2, the control bits are the three LSBs:
DB2, DB1, and DB0. Table 6 shows the truth table for these bits.
Figure 23 summarizes how the latches are programmed.
Table 6. Truth Table for the C3, C2, and C1 Control Bits
Control Bits
Register
C3
C2
C1
0
Register 0 (R0)
0
1
Register 1 (R1)
0
1
0
Register 2 (R2)
0
1
Register 3 (R3)
1
0
Register 4 (R4)
1
0
1
Register 5 (R5)
PROGRAM MODES
modes are set up in the ADF4351.
The following settings in the ADF4351 are double buffered: phase
value, modulus value, reference doubler, reference divide-by-2,
R counter value, and charge pump current setting. Before the part
uses a new value for any double-buffered setting, the following
two events must occur:
1. The new value is latched into the device by writing to the
appropriate register.
2. A new write is performed on Register 0 (R0).
For example, any time that the modulus value is updated,
Register 0 (R0) must be written to, to ensure that the modulus
value is loaded correctly. The divider select value in Register 4
(R4) is also double buffered, but only if the DB13 bit of
Register 2 (R2) is set to 1.
VCO
The VCO core in the ADF4351 consists of three separate VCOs,
each of which uses 16 overlapping bands, as shown in Figure 20,
to allow a wide frequency range to be covered without a large
VCO sensitivity (KV) and resultant poor phase noise and spur-
ious performance.
3.0
2.5
2.0
1.5
1.0
0.5
0
2.0
2.5
3.0
3.5
4.0
4.5
V
T
UNE
(V)
FREQUENCY (GHz)
09800-
120
Figure 20. VTUNE vs. Frequency
The correct VCO and band are selected automatically by the
VCO and band select logic at power-up or whenever Register 0
(R0) is updated.
VCO and band selection take 10 PFD cycles multiplied by the
value of the band select clock divider. The VCO VTUNE is discon-
nected from the output of the loop filter and is connected to an
internal reference voltage.
相關PDF資料 |
PDF描述 |
|---|---|
| V24A24H300BF2 | CONVERTER MOD DC/DC 24V 300W |
| M83723/95R10057 | CONN PLUG 5POS STRAIGHT W/SCKT |
| V24A15H300BL | CONVERTER MOD DC/DC 15V 300W |
| D38999/20JC4JN | CONN RCPT 4POS WALL MNT W/SCKT |
| MS27474E16B6SD | CONN RCPT 6POS JAM NUT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4351BCPZ-U5 | 制造商:Analog Devices 功能描述:- Rail/Tube |
| ADF4351BCPZ-U6 | 制造商:Analog Devices 功能描述:WIDEBAND SYNTHESIZER WITH INTEGRATED VCO - Rail/Tube |
| ADF4355-2BCPZ | 功能描述:IC INTEGRATED SYNTH/VCO 32LFCSP 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:有效 類型:* PLL:是 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:2 差分 - 輸入:輸出:無/無 頻率 - 最大值:4.4GHz 分頻器/倍頻器:是/是 電壓 - 電源:3.15 V ~ 3.45 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:32-WFQFN 裸露焊盤，CSP 供應商器件封裝:32-LFCSP-WQ（5x5） 標準包裝:1 |
| ADF4355-2BCPZ-RL7 | 功能描述:IC INTEGRATED SYNTH/VCO 32LFCSP 制造商:analog devices inc. 系列:- 包裝:帶卷（TR） 零件狀態:有效 類型:* PLL:是 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1:2 差分 - 輸入:輸出:無/無 頻率 - 最大值:4.4GHz 分頻器/倍頻器:是/是 電壓 - 電源:3.15 V ~ 3.45 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:32-WFQFN 裸露焊盤，CSP 供應商器件封裝:24-LFCSP-WQ（4x4） 標準包裝:1,500 |
| ADF4355-3BCPZ | 功能描述:IC INTEGRATED SYNTH/VCO 32LFCSP 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:有效 類型:* PLL:是 輸入:時鐘 輸出:時鐘 電路數:1 比率 - 輸入:輸出:1：3 差分 - 輸入:輸出:是/是 頻率 - 最大值:6.6GHz 分頻器/倍頻器:是/是 電壓 - 電源:3.15 V ~ 3.45 V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:32-WFQFN 裸露焊盤，CSP 供應商器件封裝:32-LFCSP-WQ（5x5） 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。