- 您現在的位置：買賣IC網 > PDF目錄5428 > ADA4861-3YRZ-RL (Analog Devices Inc)IC OPAMP CF TRPL LP 100MA 14SOIC PDF資料下載
參數資料
| 型號： | ADA4861-3YRZ-RL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP CF TRPL LP 100MA 14SOIC |
| 標準包裝： | 2,500 |
| 放大器類型： | 電流反饋 |
| 電路數： | 3 |
| 轉換速率： | 910 V/µs |
| -3db帶寬： | 370MHz |
| 電流 - 輸入偏壓： | 2.9µA |
| 電壓 - 輸入偏移： | 100µV |
| 電流 - 電源： | 17.9mA |
| 電流 - 輸出 / 通道： | 100mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 12 V，±2.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 14-SOIC |
| 包裝： | 帶卷 (TR) |
ADA4861-3
Rev. A | Page 15 of 16
SINGLE-SUPPLY OPERATION
POWER SUPPLY BYPASSING
The ADA4861-3 can also be operated from a single power
supply.
Careful attention must be paid to bypassing the power supply
pins of the ADA4861-3. High quality capacitors with low
equivalent series resistance (ESR), such as multilayer ceramic
capacitors (MLCCs), should be used to minimize supply voltage
ripple and power dissipation. A large, usually tantalum, 2.2 μF
to 47 μF capacitor located in proximity to the ADA4861-3 is
required to provide good decoupling for lower frequency
signals. The actual value is determined by the circuit transient
and frequency requirements. In addition, 0.1 μF MLCC
decoupling capacitors should be located as close to each of the
power supply pins as is physically possible, no more than 1/8
inch away. The ground returns should terminate immediately
into the ground plane. Locating the bypass capacitor return
close to the load return minimizes ground loops and improves
performance.
Figure 53 shows the schematic for a single 5 V supply
video driver. The input signal is ac-coupled into the amplifier
via C1. Resistor R2 and Resistor R4 establish the input midsupply
reference for the amplifier. Capacitor C5 prevents constant
current from being drawn through the gain set resistor and
enables the ADA4861-3 at dc to provide unity gain to the input
midsupply voltage, thereby establishing the output voltage dc
operating point. Capacitor C6 is the output coupling capacitor.
For more information on single-supply operation of op amps,
0
57
08
-0
54
C2
1F
R2
50k
R4
50k
R3
1k
C1
22F
R1
50
C6
220F
R5
75
R6
75
C5
22F
ADA4861-3
+5V
VOUT
VIN
–VS
C3
2.2F
C4
0.01F
+5V
LAYOUT
As is the case with all high-speed applications, careful attention
to printed circuit board (PCB) layout details prevents associated
board parasitics from becoming problematic. The ADA4861-3
can operate at up to 730 MHz; therefore, proper RF design
techniques must be employed. The PCB should have a
ground plane covering all unused portions of the component
side of the board to provide a low impedance return path.
Removing the ground plane on all layers from the area near
and under the input and output pins reduces stray capacitance.
Signal lines connecting the feedback and gain resistors should
be kept as short as possible to minimize the inductance and
stray capacitance associated with these traces. Termination
resistors and loads should be located as close as possible to their
respective inputs and outputs. Input and output traces should
be kept as far apart as possible to minimize coupling (crosstalk)
through the board. Adherence to microstrip or stripline design
techniques for long signal traces (greater than 1 inch) is
recommended. For more information on high speed board
layout, go to:
Figure 53. Single-Supply Video Driver Schematic
www.analog.com and
相關PDF資料 |
PDF描述 |
|---|---|
| AD8604ARZ-REEL | IC OPAMP GP CMOS 8.4MHZ 14SOIC |
| MMK25-009 | CONN RACK/PANEL 9POS 5A |
| OP1177ARM-REEL | IC OPAMP GP 1.3MHZ PREC LN 8MSOP |
| TSW-121-08-L-S | CONN HEADER 21POS .100" SGL GOLD |
| AD8601ARTZ-R2 | IC OPAMP GP CMOS 8.4MHZ SOT23-5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADA4861-3YRZ-RL7 | 功能描述:IC OPAMP CF TRPL LP 100MA 14SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR) |
| ADA4862-3 | 制造商:AD 制造商全稱:Analog Devices 功能描述:High Speed, G = +2, Low Cost, Triple Op Amp |
| ADA4862-3YR-EBZ | 功能描述:BOARD EVAL FOR ADA4862-3YR RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| ADA4862-3YRZ | 功能描述:IC OPAMP CF TRPL LP 115MA 14SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:MicroAmplifier™ 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:5pA 電壓 - 輸入偏移:1500µV 電流 - 電源:220µA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 36 V，±2.25 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:剪切帶 (CT) 其它名稱:296-29363-1 |
| ADA4862-3YRZ-RL | 功能描述:IC OPAMP CF TRPL LP 115MA 14SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:0.11 V/µs 增益帶寬積:350kHz -3db帶寬:- 電流 - 輸入偏壓:4nA 電壓 - 輸入偏移:20µV 電流 - 電源:260µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SO 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。