參數資料
型號： AD9750-EB
廠商： Analog Devices, Inc.
英文描述： 10-Bit, 125 MSPS High Performance TxDAC D/A Converter
中文描述： 10位，125 MSPS的TxDAC系列高性能D / A轉換
文件頁數： 13/22頁
文件大?。?/td> 302K
代理商： AD9750-EB
AD9750
–13–
REV. 0
POWER DISSIPATION
The power dissipation, P
D
, of the AD9750 is dependent on
several factors which include: (1) AVDD and DVDD, the
power supply voltages; (2) I
OUTFS
, the full-scale current output;
(3) f
CLOCK
, the update rate; (4) and the reconstructed digital
input waveform. The power dissipation is directly proportional
to the analog supply current, I
AVDD
, and the digital supply cur-
rent, I
DVDD
. I
AVDD
is directly proportional to I
OUTFS
as shown in
Figure 25 and is insensitive to f
CLOCK
.
Conversely, I
DVDD
is dependent on both the digital input wave-
form, f
CLOCK
, and digital supply DVDD. Figures 26 and 27
show I
DVDD
as a function of full-scale sine wave output ratios
(f
OUT
/f
CLOCK
) for various update rates with DVDD = 5 V and
DVDD = 3 V, respectively. Note, how I
DVDD
is reduced by more
than a factor of 2 when DVDD is reduced from 5 V to 3V.
I
OUTFS
– mA
35
52
20
4
6
8
10
12
14
16
18
30
25
20
15
10
I
A
Figure 25. I
AVDD
vs. I
OUTFS
RATIO (f
CLOCK
/f
OUT
)
18
16
0
0.01
1
0.1
I
D
8
6
4
2
12
10
14
125MSPS
100MSPS
50MSPS
25MSPS
5MSPS
Figure 26. I
DVDD
vs. Ratio @ DVDD = 5 V
RATIO (f
CLOCK
/f
OUT
)
8
0
0.01
1
0.1
I
D
6
4
2
125MSPS
100MSPS
50MSPS
25MSPS
5MSPS
Figure 27. I
DVDD
vs. Ratio @ DVDD = 3 V
APPLYING THE AD9750
OUTPUT CONFIGURATIONS
The following sections illustrate some typical output configura-
tions for the AD9750. Unless otherwise noted, it is assumed
that I
OUTFS
is set to a nominal 20 mA. For applications requir-
ing the optimum dynamic performance, a differential output
configuration is suggested. A differential output configuration
may consist of either an RF transformer or a differential op amp
configuration. The transformer configuration provides the opti-
mum high frequency performance and is recommended for any
application allowing for ac coupling. The differential op amp
configuration is suitable for applications requiring dc coupling, a
bipolar output, signal gain and/or level shifting.
A single-ended output is suitable for applications requiring a
unipolar voltage output. A positive unipolar output voltage will
result if IOUTA and/or IOUTB is connected to an appropri-
ately sized load resistor, R
LOAD
, referred to ACOM. This con-
figuration may be more suitable for a single-supply system
requiring a dc coupled, ground referred output voltage. Alterna-
tively, an amplifier could be configured as an I-V converter thus
converting IOUTA or IOUTB into a negative unipolar voltage.
This configuration provides the best dc linearity since IOUTA
or IOUTB is maintained at a virtual ground. Note, IOUTA
provides slightly better performance than IOUTB.
DIFFERENTIAL COUPLING USING A TRANSFORMER
An RF transformer can be used to perform a differential-to-
single-ended signal conversion as shown in Figure 28. A
differentially coupled transformer output provides the optimum
distortion performance for output signals whose spectral content
lies within the transformer’s passband. An RF transformer such
as the Mini-Circuits T1-1T provides excellent rejection of
common-mode distortion (i.e., even-order harmonics) and noise
over a wide frequency range. It also provides electrical isolation
and the ability to deliver twice the power to the load. Trans-
formers with different impedance ratios may also be used for
impedance matching purposes. Note that the transformer
provides ac coupling only.
相關PDF資料
PDF描述
AD9750AR 10-Bit, 125 MSPS High Performance TxDAC D/A Converter
AD9750ARU 10-Bit, 125 MSPS High Performance TxDAC D/A Converter
AD9750 10-Bit D/A Converter(100MSPS,10位D/A轉換器)
AD9752* 12-Bit. 125 MSPS High Performance TxDAC D/A Converter
AD9752-EB 12-Bit, 125 MSPS High Performance TxDAC D/A Converter
相關代理商/技術參數
參數描述
AD9750-EBZ 功能描述:BOARD EVAL FOR AD9750 RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:TxDAC® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581
AD9751 制造商:AD 制造商全稱:Analog Devices 功能描述:10-Bit, 300 MSPS High-Speed TxDAC+ D/A Converter
AD9751AST 制造商:Analog Devices 功能描述:DAC 1-CH Segment 10-bit 48-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:10-BIT, 300 MSPS TXDAC+ D/A CONVERTER - Bulk 制造商:Analog Devices 功能描述:IC 10-BIT DAC
AD9751ASTRL 制造商:Analog Devices 功能描述:DAC 1-CH Segment 10-bit 48-Pin LQFP T/R 制造商:Rochester Electronics LLC 功能描述:10-BIT, 300 MSPS TXDAC+ D/A CONVERTER - Tape and Reel
AD9751ASTZ 功能描述:IC DAC 10BIT 300MSPS 48-LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:TxDAC+® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*