- 您現在的位置：買賣IC網 > PDF目錄1988 > AD9748ACPZRL7 (Analog Devices Inc)IC DAC 8BIT 210MSPS 32LFCSP PDF資料下載
參數資料
| 型號： | AD9748ACPZRL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC 8BIT 210MSPS 32LFCSP |
| 標準包裝： | 1,500 |
| 系列： | TxDAC® |
| 設置時間： | 11ns |
| 位數： | 8 |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 電壓電源： | 模擬和數字 |
| 功率耗散（最大）： | 145mW |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 32-LFCSP-VQ（5x5） |
| 包裝： | 帶卷 (TR) |
| 輸出數目和類型： | 2 電流，單極；2 電流，雙極 |
| 采樣率（每秒）： | 210M |
AD9748
Data Sheet
Rev. B | Page 16 of 24
DIFFERENTIAL COUPLING USING AN OP AMP
An op amp can also be used to perform a differential-to-single-
ended conversion, as shown in Figure 26. The AD9748 is
configured with two equal load resistors, RLOAD, of 25 . The
differential voltage developed across IOUTA and IOUTB is
converted to a single-ended signal via the differential op amp
configuration. An optional capacitor can be installed across
IOUTA and IOUTB, forming a real pole in a low-pass filter. The
addition of this capacitor also enhances the op amp’s distortion
performance by preventing the DAC’s high slewing output from
overloading the op amp’s input.
AD9748
IOUTA
IOUTB
COPT
500
225
500
25
AD8047
032
1
1-
023
Figure 26. DC Differential Coupling Using an Op Amp
The common-mode rejection of this configuration is typically
determined by the resistor matching. In this circuit, the differential
op amp circuit using the AD8047 is configured to provide some
additional signal gain. The op amp must operate off a dual
supply because its output is approximately ±1 V. A high speed
amplifier capable of preserving the differential performance
of the AD9748 while meeting other system level objectives (that
is, cost or power) should be selected. The op amp’s differential
gain, gain setting resistor values, and full-scale output swing
capabilities should all be considered when optimizing this circuit.
The differential circuit shown in Figure 27 provides the
necessary level shifting required in a single-supply system. In
this case, AVDD, which is the positive analog supply for both
the AD9748 and the op amp, is also used to level shift the
differential output of the AD9748 to midsupply (that is,
AVDD/2). The AD8041 is a suitable op amp for this application.
AD9748
IOUTA
IOUTB
COPT
500
225
1k
25
AD8041
1k
AVDD
032
1
1-
024
Figure 27. Single-Supply DC Differential Coupled Circuit
SINGLE-ENDED, UNBUFFERED VOLTAGE OUTPUT
output range of approximately 0 V to 0.5 V for a doubly
terminated 50
cable
because the nominal full-scale current,
IOUTFS, of 20 mA flows through the equivalent RLOAD of 25 .
In this case, RLOAD represents the equivalent load resistance seen
by IOUTA or IOUTB. The unused output (IOUTA or IOUTB)
can be connected to ACOM directly or via a matching RLOAD.
Different values of IOUTFS and RLOAD can be selected as long as
the positive compliance range is adhered to. One additional
consideration in this mode is the integral nonlinearity (INL),
discussed in the Analog Outputs section. For optimum INL
performance, the single-ended, buffered voltage output
configuration is suggested.
AD9748
IOUTA
IOUTB
50
25
VOUTA = 0V TO 0.5V
IOUTFS = 20mA
50
032
1
1-
025
Figure 28. 0 V to 0.5 V Unbuffered Voltage Output
SINGLE-ENDED, BUFFERED VOLTAGE OUTPUT
CONFIGURATION
Figure 29 shows a buffered single-ended output configuration
in which the op amp U1 performs an I-V conversion on the
AD9748 output current. U1 maintains IOUTA (or IOUTB) at a
virtual ground, minimizing the nonlinear output impedance
effect on the DAC’s INL performance as described in the
Analog Outputs section. Although this single-ended
configuration typically provides the best dc linearity
performance, its ac distortion performance at higher DAC
update rates can be limited by U1’s slew rate capabilities. U1
provides a negative unipolar output voltage, and its full-scale
output voltage is simply the product of RFB and IOUTFS. The full-
scale output should be set within U1’s voltage output swing
capabilities by scaling IOUTFS and/or RFB. An improvement in ac
distortion performance can result with a reduced IOUTFS because
U1 is required to sink less signal current.
AD9748
IOUTA
IOUTB
COPT
200
U1
VOUT = IOUTFS × RFB
IOUTFS = 10mA
RFB
200
032
1
1-
026
Figure 29. Unipolar Buffered Voltage Output
相關PDF資料 |
PDF描述 |
|---|---|
| AD9750ARUZRL7 | IC DAC 10BIT 125MSPS 28TSSOP |
| AD9751ASTZRL | IC DAC 10BIT 300MSPS 48LQFP |
| AD9752AR | IC DAC 12BIT 125MSPS 28-SOIC |
| AD9753ASTZRL | IC DAC 12BIT 300MSPS 48LQFP |
| AD9754AR | IC DAC 14BIT 125MSPS HP 28-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD9748XCP | 制造商:AD 制造商全稱:Analog Devices 功能描述:8-Bit, 165 MSPS TxDAC D/A Converter |
| AD974AN | 功能描述:IC DAS 16BIT 4CH 200KSPS 28-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD974ANZ | 功能描述:IC DAS 16BIT 4CH 200KSPS 28DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD974AR | 功能描述:IC DAS 16BIT 4CH 200KSPS 28-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD974ARS | 制造商:Analog Devices 功能描述:ADC Single 200ksps 16-bit Serial 28-Pin SSOP 制造商:Rochester Electronics LLC 功能描述:4-CHANNEL 16 BIT 200KSPS DATA ACQ SYSTEM - Bulk |
發布緊急采購，3分鐘左右您將得到回復。