- 您現在的位置：買賣IC網 > PDF目錄2138 > AD8632ARMZ-REEL (Analog Devices Inc)IC OPAMP GP R-R 5MHZ DUAL 8MSOP PDF資料下載
參數資料
| 型號： | AD8632ARMZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 3/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP R-R 5MHZ DUAL 8MSOP |
| 標準包裝： | 1 |
| 放大器類型： | 通用 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 3 V/µs |
| 增益帶寬積： | 5MHz |
| 電流 - 輸入偏壓： | 250nA |
| 電壓 - 輸入偏移： | 800µV |
| 電流 - 電源： | 300µA |
| 電流 - 輸出 / 通道： | 10mA |
| 電壓 - 電源，單路/雙路(±)： | 1.8 V ~ 6 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 標準包裝 |
| 其它名稱： | AD8632ARMZ-REELDKR |
AD8631/AD8632
–11–
REV. 0
Table II. Snubber Network Values for Large Capacitive Loads
CLOAD
Rx
Cx
600 pF
300
1 nF
300
1 nF
10 nF
90
8 nF
TOTAL HARMONIC DISTORTION + NOISE
The AD863x family offers a low total harmonic distortion, which
makes this amplifier ideal for audio applications. Figure 27 shows
a graph of THD + N, which is ~0.02% @ 1 kHz, for a 1.8 V supply.
At unity gain in an inverting configuration the value of the Total
Harmonic Distortion + Noise stays consistently low over all volt-
ages supply ranges.
FREQUENCY – Hz
0.1
0.001
10
20k
THD
+
N
–
%
0.01
1
10
100
1k
10k
VS = 1.8V
VS = 5V
INVERTING
AV = 1
Figure 27. THD + N vs. Frequency Graph
AD8632 Turn-On Time
The low voltage, low power AD8632 features an extraordinary turn
on time. This is about 500 ns for VSY = 5 V, which is impressive
considering the low supply current (300
A typical per amplifier).
Figure 28 shows a scope picture of the AD8632 with both channels
configured as followers. Channel A has an input signal of 2.5 V and
channel B has the input signal at ground. The top waveform shows
the supply voltage and the bottom waveform reflects the response
of the amplifier at the output of Channel A.
TIME – 200ns/DIV
0
VOLTAGE
–
1V/DIV
0
VS = 5V
AV = 1
VIN = 2.5V STEP
0V
Figure 28. AD8632 Turn-On Time
A MICROPOWER REFERENCE VOLTAGE GENERATOR
Many single-supply circuits are configured with the circuit biased
to one-half of the supply voltage. In these cases, a false-ground
reference can be created by using a voltage divider buffered by an
amplifier. Figure 28 shows the schematic for such a circuit.
The two 1 M
resistors generate the reference voltages while
drawing only 0.9
A of current from a 1.8 V supply. A capacitor
connected from the inverting terminal to the output of the op
amp provides compensation to allow a bypass capacitor to be
connected at the reference output. This bypass capacitor helps
establish an ac ground for the reference output.
AD8631
10k
0.022 F
VREF
0.9V TO 2.5V
1 F
1M
1.8V TO 5V
100
1M
Figure 29. A Micropower Reference Voltage Generator
MICROPHONE PREAMPLIFIER
The AD8631 is ideal to use as a microphone preamplifier.
Figure 30 shows this implementation.
AD8631
VOUT
R3
220k
1.8V
VREF = 0.9V
R2
22k
C1
0.1 F
1.8V
R1
2.2k
ELECTRET
MIC
AV =
R3
R2
VIN
Figure 30. A Microphone Preamplifier
R1 is used to bias an electret microphone and C1 blocks dc voltage
from the amplifier. The magnitude of the gain of the amplifier is
approximately R3/R2 when R2
≥ 10 R1. VREF should be equal to
1/2
1.8 V for maximum voltage swing.
Direct Access Arrangement for Telephone Line Interface
Figure 31 illustrates a 1.8 V transmit/receive telephone line interface
for 600
transmission systems. It allows full duplex transmission of
signals on a transformer-coupled 600
line in a differential manner.
Amplifier A1 provides gain that can be adjusted to meet the modem
output drive requirements. Both A1 and A2 are configured to apply
the largest possible signal on a single supply to the transformer.
Amplifier A3 is configured as a difference amplifier for two reasons:
(1) It prevents the transmit signal from interfering with the receive
signal and (2) it extracts the receive signal from the transmission line
for amplification by A4. A4’s gain can be adjusted in the same
manner as A1’s to meet the modem’s input signal requirements.
Standard resistor values permit the use of SIP (Single In-line
Package) format resistor arrays. Couple this with the AD8631/
相關PDF資料 |
PDF描述 |
|---|---|
| AD8639ARMZ | IC OPAMP CHOPPER R-R DUAL 8MSOP |
| AD8642ARMZ | IC OPAMP JFET R-R 3.5MHZ 8MSOP |
| AD8643TRZ-EP | IC OPAMP JFET R-R ENH 14SOIC |
| AD8644ARZ-REEL7 | IC OPAMP GP R-R 5.5MHZ 14SOIC |
| AD8648ARZ | IC OPAMP GP R-R 24MHZ LN 14SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8632AR-REEL | 制造商:Analog Devices 功能描述:OP Amp Dual GP R-R I/O 6V 8-Pin SOIC N T/R |
| AD8632AR-REEL7 | 制造商:Analog Devices 功能描述:OP Amp Dual GP R-R I/O 6V 8-Pin SOIC N T/R |
| AD8632ARZ | 制造商:Analog Devices 功能描述:OP Amp Dual GP R-R I/O 6V 8-Pin SOIC N 制造商:Analog Devices 功能描述:OP AMP DUAL LOW POWER RRI/O 8632 |
| AD8632ARZ-REEL | 制造商:Analog Devices 功能描述:OP Amp Dual GP R-R I/O 6V 8-Pin SOIC N T/R |
| AD8632ARZ-REEL7 | 制造商:Analog Devices 功能描述:OP Amp Dual GP R-R I/O 6V 8-Pin SOIC N T/R |
發布緊急采購，3分鐘左右您將得到回復。