- 您現在的位置：買賣IC網 > PDF目錄16924 > AD8310-EVALZ (Analog Devices Inc)BOARD EVAL FOR AD8310 PDF資料下載
參數資料
| 型號： | AD8310-EVALZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 14/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL FOR AD8310 |
| 設計資源： | AD8310 Gerber Files |
| 標準包裝： | 1 |
| 每 IC 通道數： | 1 - 單 |
| 放大器類型： | 對數 |
| 輸出類型： | 單端 |
| -3db帶寬： | 900MHz |
| 電流 - 輸出 / 通道： | 500µA |
| 工作溫度： | -40°C ~ 85°C |
| 電流供應（主 IC）： | 8mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 5.5 V |
| 板類型： | 完全填充 |
| 已供物品： | 板 |
| 已用 IC / 零件： | AD8310 |
| 其它名稱： | Q3794486 Q4192743 |
AD8310
Rev. F | Page 21 of 24
Table 6. Evaluation Board Setup Options
Component
Function
Default Condition
TP1, TP2
Supply and Ground Vector Pins.
Not applicable
SW1
Device Enable. When in Position A, the ENBL pin is connected to +VS, and the AD8310 is in normal
operating mode. When in Position B, the ENBL pin is connected to ground, putting the device into
sleep mode.
SW1 = A
R1/R4
SMA Connector Grounds. Connects common of INHI and INLO SMA connectors to ground. They
can be used to isolate the generator ground from the evaluation board ground. See Figure 28.
R1 = R4 = 0 Ω
C1, C2, R3
Input Interface. R3 (52.3 Ω) combines with the AD8310’s 1 kΩ input impedance to give an overall
broadband input impedance of 50 Ω. C1, C2, and the AD8310’s input impedance combine to set a
high-pass input corner of 32 kHz. Alternatively, R3, C1, and C2 can be replaced by an inductor and
matching capacitors to form an input matching network. See the Input Matching section for details.
R3 = 52.3 Ω,
C1 = C2 = 0.01 μF
C3
RSSI (Video) Bandwidth Adjust. The addition of C3 (farads) lowers the RSSI bandwidth of the
AD8310’s output according to the following equation:
CFILT = 1/(2π × 3 kΩ Video Bandwidth) 2.1 pF
C3 = open
C4, C5, R5
Supply Decoupling. The normal supply decoupling of 0.01 μF (C4) can be augmented by a larger
capacitor in C5. An inductor or small resistor can be placed in R5 for additional decoupling.
C4 = 0.01 μF,
C5 = open, R5 = 0 Ω
R6
Output Source Impedance. In cable-driving applications, a resistor (typically 50 Ω or 75 Ω) can be
placed in R6 to give the circuit a back-terminated output impedance.
R6 = 0 Ω
W1, W2, C6, R7
Output Loading. Resistors and capacitors can be placed in C6 and R7 to load-test VOUT. Jumper W1
and Jumper W2 are used to connect or disconnect the loads.
C6 = R7 = open,
W1 = W2 = installed
C7
Offset Compensation Loop. A capacitor in C7 reduces the corner frequency of the offset control
loop in low frequency applications.
C7 = open
相關PDF資料 |
PDF描述 |
|---|---|
| ISL60002BIH312Z-TK | IC VREF SERIES PREC SOT-23-3 |
| NCP571MN10TBGEVB | BOARD EVAL NCP571MN 1.0V |
| AD8225-EVALZ | BOARD EVAL FOR AD8225 INSTR AMP |
| EBM15DCCT | CONN EDGECARD 30POS R/A .156 SLD |
| EVAL-INAMP-62RZ | BOARD EVAL FOR AD620 SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8311 | 制造商:AD 制造商全稱:Analog Devices 功能描述:50 dB GSM PA Controller |
| AD8311ACBZ-P2 | 制造商:Analog Devices 功能描述:GSM PA CNTRLR 6PIN WLCSP - Tape and Reel |
| AD8311ACBZ-P7 | 功能描述:IC CTRLR PWR AMP 2.5GHZ 6WLCSP RoHS:是 類別:RF/IF 和 RFID >> RF 電源控制器 IC 系列:- 標準包裝:3,000 系列:- RF 型:GSM 頻率:450MHz ~ 2GHz 特點:四頻帶 封裝/外殼:8-VFBGA 供應商設備封裝:8-MicroSMD（1.51x1.51） 包裝:帶卷 (TR) 其它名稱:LMV243BLX |
| AD8311-EVAL | 制造商:Analog Devices 功能描述:50 DB GSM PA CNTRLR - Bulk |
| AD8312 | 制造商:AD 制造商全稱:Analog Devices 功能描述:100 MHz-2.7 GHz, 45 dB RF Log Detector |
發布緊急采購，3分鐘左右您將得到回復。