- 您現在的位置：買賣IC網 > PDF目錄16924 > AD8310-EVALZ (Analog Devices Inc)BOARD EVAL FOR AD8310 PDF資料下載
參數資料
| 型號： | AD8310-EVALZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL FOR AD8310 |
| 設計資源： | AD8310 Gerber Files |
| 標準包裝： | 1 |
| 每 IC 通道數： | 1 - 單 |
| 放大器類型： | 對數 |
| 輸出類型： | 單端 |
| -3db帶寬： | 900MHz |
| 電流 - 輸出 / 通道： | 500µA |
| 工作溫度： | -40°C ~ 85°C |
| 電流供應（主 IC）： | 8mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 5.5 V |
| 板類型： | 完全填充 |
| 已供物品： | 板 |
| 已用 IC / 零件： | AD8310 |
| 其它名稱： | Q3794486 Q4192743 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁
AD8310
Rev. F | Page 19 of 24
APPLICATIONS INFORMATION
The AD8310 is highly versatile and easy to use. It needs only a
few external components, most of which can be immediately
accommodated using the simple connections shown in the
Using the AD8310 section.
A few examples of more specialized applications are provided
in the following sections. See the AD8307 data sheet for more
applications (note the slightly different pin configuration).
CABLE-DRIVING
For a supply voltage of 3 V or greater, the AD8310 can drive a
grounded 100 Ω load to 2.5 V. If reverse-termination is required
when driving a 50 Ω cable, it should be included in series with
the output, as shown in Figure 37. The slope at the load is then
12 mV/dB. In some cases, it might be permissible to operate the
cable without a termination at the far end, in which case the
slope is not lowered. Where a further increase in slope is
desirable, the scheme shown in Figure 34 can be used.
AD8310
VOUT
50
Ω
50
Ω
01084-037
Figure 37. Output Response of Cable-Driver Application
DC-COUPLED INPUT
It might occasionally be necessary to provide response to dc
inputs. Because the AD8310 is internally dc-coupled, there is no
reason why this cannot be done. However, its differential inputs
must be positioned at least 2 V above the COM potential for
proper biasing of the first stage. Usually, the source is a single-
sided ground-referenced signal, so level-shifting and a single-
ended-to-differential conversion must be provided to correctly
drive the AD8310’s inputs.
Figure 38 shows how a level-shift to midsupply (2.5 V in this
example) and a single-ended-to-differential conversion can be
accomplished using the AD8138 differential amplifier. The four
499 Ω resistors set up a gain of unity. An output common-mode
(or bias) voltage of 2.5 is achieved by applying 2.5 V from a supply-
differential outputs of the AD8138 directly drive the 1.1 kΩ
input impedance of the AD8310.
5V
0.01 F
μ
SIGNAL
INPUT
AD8138
0.1
μF
5V
499
Ω
499
Ω
499
Ω
499
Ω
10k
Ω
0.1
μF
5V
10k
Ω
NC
INHI ENBL BFIN VPOS
INLO COMM OFLT VOUT
AD8310
12
34
87
65
VOUT
5V
3.01k
Ω
1.87k
Ω
50
Ω
2.5V
NC = NO CONNECT
01084-
038
Figure 38. DC-Coupled Log Amp
In this application the offset voltage of the AD8138 must be
trimmed. The internal offset compensation circuitry of the
AD8310 is disabled by applying a nominal voltage of ~1.9 V to
the OFLT pin, so the trim on the AD8138 is effectively trimming
the offsets of both devices. The trim is done by grounding the
circuit’s input and slightly varying the gain resistors on the
inverting input of the AD8138 (a 50 Ω potentiometer is used in
this example) until the voltage on the AD8310’s output reaches
a minimum.
After trimming, the lower end of the dynamic range is limited
by the broadband noise at the output of the AD8138, which is
approximately 425 μV p-p. A differential low-pass filter can be
added between the AD8138 and the AD8310 when the very fast
pulse response of the circuit is not required.
INPUT LEVEL (mV)
0.1
R
SSI
OU
TPU
T
(
V
)
1
0.7
0.9
1.1
1.3
1.5
1.7
1.9
2.1
10
100
1000
2.3
2.5
2.7
01084-039
Figure 39. Transfer Function of DC-Coupled Log Amp Application
相關PDF資料 |
PDF描述 |
|---|---|
| ISL60002BIH312Z-TK | IC VREF SERIES PREC SOT-23-3 |
| NCP571MN10TBGEVB | BOARD EVAL NCP571MN 1.0V |
| AD8225-EVALZ | BOARD EVAL FOR AD8225 INSTR AMP |
| EBM15DCCT | CONN EDGECARD 30POS R/A .156 SLD |
| EVAL-INAMP-62RZ | BOARD EVAL FOR AD620 SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8311 | 制造商:AD 制造商全稱:Analog Devices 功能描述:50 dB GSM PA Controller |
| AD8311ACBZ-P2 | 制造商:Analog Devices 功能描述:GSM PA CNTRLR 6PIN WLCSP - Tape and Reel |
| AD8311ACBZ-P7 | 功能描述:IC CTRLR PWR AMP 2.5GHZ 6WLCSP RoHS:是 類別:RF/IF 和 RFID >> RF 電源控制器 IC 系列:- 標準包裝:3,000 系列:- RF 型:GSM 頻率:450MHz ~ 2GHz 特點:四頻帶 封裝/外殼:8-VFBGA 供應商設備封裝:8-MicroSMD（1.51x1.51） 包裝:帶卷 (TR) 其它名稱:LMV243BLX |
| AD8311-EVAL | 制造商:Analog Devices 功能描述:50 DB GSM PA CNTRLR - Bulk |
| AD8312 | 制造商:AD 制造商全稱:Analog Devices 功能描述:100 MHz-2.7 GHz, 45 dB RF Log Detector |
發布緊急采購，3分鐘左右您將得到回復。