- 您現在的位置：買賣IC網 > PDF目錄3513 > AD8290ACPZ-R7 (Analog Devices Inc)IC SENSOR AMP CMOS G-50 16-LFCSP PDF資料下載
參數資料
| 型號： | AD8290ACPZ-R7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SENSOR AMP CMOS G-50 16-LFCSP |
| 產品培訓模塊： | Current Sense Amplifiers |
| 標準包裝： | 1 |
| 放大器類型： | 電流檢測 |
| 電路數： | 1 |
| -3db帶寬： | 250kHz |
| 電流 - 輸入偏壓： | 100pA |
| 電流 - 電源： | 1.2mA |
| 電壓 - 電源，單路/雙路(±)： | 2.6 V ~ 5.5 V，±1.3 V ~ 2.75 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-UFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 16-LFCSP-UQ |
| 包裝： | 標準包裝 |
| 其它名稱： | AD8290ACPZ-R7DKR |
AD8290
Rev. B | Page 16 of 20
APPLICATIONS INFORMATION
TYPICAL CONNECTIONS
Figure 45 shows the typical connections for single-supply
operation when used with a sensor bridge.
CURRENT EXCITATION
the IOUT pin. The formula for the excitation current IOUT is
IOUT = (900/RSET) mA
where RSET is the resistor between Pin 10 (GND) and Pin 11
(RSET).
The AD8290 is internally set by the factory to provide the
current excitation described by the previous formula (within the
3 kΩ, resulting in a corresponding IOUT of 1300 μA to 300 μA,
respectively.
ENABLE/DISABLE FUNCTION
Pin 3 (ENBL) provides the enabling/disabling function of the
AD8290 to conserve power when the device is not needed. A
Logic 1 turns the part on and allows it to operate normally. A
Logic 0 disables the output and excitation current and reduces
the quiescent current to less than 10 μA.
The turn-on time upon switching Pin 3 high is dominated
by the output filters. When the device is disabled, the output
becomes high impedance, enabling the muxing application of
multiple AD8290 instrumentation amplifiers.
OUTPUT FILTERING
Filter Capacitor CFILTER is required to limit the amount of
switching noise present at the output. The recommended
bandwidth of the filter created by CFILTER and an internal
100 kΩ is 235 Hz. Select CFILTER based on
CFILTER = 1/(235 × 2 × π × 100 kΩ) = 6.8 nF
For bandwidths greater than 10 Hz, an additional single-pole
RC filter of 235 Hz is required on the output, which is also
recommended when driving an ADC requiring an antialiasing
filter. Internal to the AD8290 is a series 10 kΩ resistor at the
output (R3 in Figure 43) and using an external 68 nF capacitor
to ground produces an RC filter of 235 Hz on the output as well.
These two filters produce an overall bandwidth of approximately
160 Hz for the output signal.
In addition, when driving low impedances, the internal series
10 kΩ resistor creates a voltage divider at the output. If it is
necessary to access the output of the internal amplifier prior
to the 10 kΩ resistor, it is available at the CF2 pin.
For applications with low bandwidths (<10 Hz), only the first
filter capacitor (CFILTER) is required. In this case, the high
frequency noise from the auto-zero amplifier (output amplifier)
is not filtered before the following stage.
CLOCK FEEDTHROUGH
The AD8290 uses two synchronized clocks to perform
autocorrection. The input voltage-to-current amplifiers
are corrected at 60 kHz.
Trace amounts of these clock frequencies can be observed at
the output. The amount of feedthrough is dependent upon the
gain because the autocorrection noise has an input- and output-
referred term. The correction feedthrough is also dependent
upon the values of the external capacitors, C2 and CFILTER.
06
74
5-
0
25
CBRIDGE
NOTES
LAYOUT CONSIDERATIONS:
1. KEEP C1 CLOSE TO PIN 2 AND PIN 10.
2. KEEP RSET CLOSE TO PIN 11.
NC = NO CONNECT
ENBL
VOUT
VOUT
VCC
VINP
VINN
IOUT
RSET
GND
AD8290
4
3
2
10
11
15
14
13
C1
0.1F
CF2
CF1
5
6
C2
68nF
RSET
692 TO 3k
5.0V
NC
16
1
12
9
7
8
CFILTER
6.8nF
Figure 45. Typical Single-Supply Connections
相關PDF資料 |
PDF描述 |
|---|---|
| AD8221ARZ-R7 | IC AMP INST PREC LN 18MA 8SOIC |
| MMS-129-02-L-DH | CONN RCPT 2MM 58POS DL HORZ SMD |
| TSW-137-23-S-S | CONN HEADER 37POS .100" SGL GOLD |
| TSW-147-14-T-D | CONN HEADER 94POS .100" DUAL TIN |
| MMS-102-02-L-DH | CONN RCPT 2MM 4POS DL HORZ SMD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8290ACPZ-RL | 功能描述:IC AMP CS CMOS LP 16LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
| AD8293 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Noise, Low Gain Drift, G = 2000 Instrumentation Amplifier |
| AD8293G160 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Cost, Zero-Drift In-Amp with Filter and Fixed Gain |
| AD8293G160ARJZ-R2 | 功能描述:IC AMP INST R-R LDRIFT SOT23-8 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:160 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:10 V/µs 增益帶寬積:9MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:250µV 電流 - 電源:730µA 電流 - 輸出 / 通道:28mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:管件 |
| AD8293G160ARJZ-R7 | 功能描述:IC AMP INST R-R LDRIFT SOT23-8 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
發布緊急采購，3分鐘左右您將得到回復。