- 您現在的位置：買賣IC網 > PDF目錄3454 > AD8052AR (Analog Devices Inc)IC OPAMP VF R-R DUAL LDIST 8SOIC PDF資料下載
參數資料
| 型號： | AD8052AR |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/25頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP VF R-R DUAL LDIST 8SOIC |
| 標準包裝： | 98 |
| 放大器類型： | 電壓反饋 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 170 V/µs |
| -3db帶寬： | 110MHz |
| 電流 - 輸入偏壓： | 1.4µA |
| 電壓 - 輸入偏移： | 1800µV |
| 電流 - 電源： | 4.8mA |
| 電流 - 輸出 / 通道： | 45mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 12 V，±1.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 管件 |
AD8051/AD8052/AD8054
Rev. J | Page 18 of 24
LAYOUT CONSIDERATIONS
The specified high speed performance of the AD8051/AD8052/
AD8054 requires careful attention to board layout and component
selection. Proper RF design techniques and low parasitic
component selection are necessary.
The PCB should have a ground plane covering all unused
portions of the component side of the board to provide a low
impedance path. The ground plane should be removed from the
area near the input pins to reduce parasitic capacitance.
Chip capacitors should be used for supply bypassing. One end
should be connected to the ground plane and the other within
3 mm of each power pin. An additional large (4.7 μF to 10 μF)
tantalum electrolytic capacitor should be connected in parallel,
but not necessarily so close, to supply current for fast, large
signal changes at the output.
The feedback resistor should be located close to the inverting
input pin to keep the parasitic capacitance at this node to a
minimum. Parasitic capacitance of less than 1 pF at the inverting
input can significantly affect high speed performance.
Stripline design techniques should be used for long signal traces
(greater than about 25 mm). These should be designed with a
characteristic impedance of 50 Ω or 75 Ω and be properly
terminated at each end.
ACTIVE FILTERS
Active filters at higher frequencies require wider bandwidth op
amps to work effectively. Excessive phase shift produced by
lower frequency op amps can significantly affect active filter
performance.
Figure 46 shows an example of a 2 MHz biquad bandwidth filter
that uses three op amps of an AD8054. Such circuits are
sometimes used in medical ultrasound systems to lower the
noise bandwidth of the analog signal before analog-to-digital
conversion.
Note that the unused amplifier’s inputs should be tied to ground.
12
13
14
2
1
6
5
7
9
10
8
AD8054
3
AD8054
R6
1k
R4
2k
R3
2k
R5
2k
R2
2k
R1
3k
C1
50pF
C2
50pF
VIN
BAND-PASS
FILTER OUTPUT
01062-
046
Figure 46. 2 MHz Biquad Band-Pass Filter Using AD8054
The frequency response of the circuit is shown in Figure 47.
FREQUENCY (Hz)
0
–10
–20
–30
–40
GA
IN
(
d
B
)
10k
100k
1M
10M
100M
01
06
2-
04
7
Figure 47. Frequency Response of 2 MHz Band-Pass Biquad Filter
相關PDF資料 |
PDF描述 |
|---|---|
| RC0805FR-071M47L | RES 1.47M OHM 1/8W 1% 0805 SMD |
| PEC31DAHN | CONN HEADER .100 DUAL STR 62POS |
| 929715-03-09-I | CONN HEADER .100 DUAL STR 18POS |
| 94654-104HLF | BERGSTIK II DR STRAIGHT RET |
| 86453-504 | MINITEK II R/A HDR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8052AR TUBE | 制造商:Analog Devices 功能描述:AMP DUAL HSPEED RRO/P (TUBE98) SMD |
| AD8052AR-EBZ | 功能描述:BOARD EVAL FOR AD8052AR RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8052ARM | 功能描述:IC OPAMP VF R-R DUAL LDIST 8MSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| AD8052ARM-EBZ | 功能描述:BOARD EVAL FOR AD8052ARM RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8052ARM-REEL | 功能描述:IC OPAMP VF R-R DUAL LDIST 8MSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。