- 您現在的位置：買賣IC網 > PDF目錄10296 > AD7793BRUZ-REEL (Analog Devices Inc)IC ADC 24BIT 3CH LP 16-TSSOP PDF資料下載
參數資料
| 型號： | AD7793BRUZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 21/33頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 24BIT 3CH LP 16-TSSOP |
| 設計資源： | Fully Isolated Input Module Based on AD7793 and ADuM5401(CN0066) Fully Isolated Input Module Based on AD7793, ADuM5401, and a High Performance In-Amp (CN0067) |
| 標準包裝： | 2,500 |
| 位數： | 24 |
| 采樣率（每秒）： | 500 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 2.5mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 3 個差分，單極；3 個差分，雙極 |
| 配用： | EVAL-AD7793EBZ-ND - BOARD EVALUATION FOR AD7793 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
AD7792/AD7793
Rev. B | Page 27 of 32
The ground planes of the AD7792/AD7793 should be allowed
to run under the AD7792/AD7793 to prevent noise coupling.
The power supply lines to the AD7792/AD7793 should use as
wide a trace as possible to provide low impedance paths and
reduce the effects of glitches on the power supply line. Fast
switching signals such as clocks should be shielded with digital
ground to avoid radiating noise to other sections of the board,
and clock signals should never be run near the analog inputs.
Avoid crossover of digital and analog signals. Traces on
opposite sides of the board should run at right angles to each
other. This reduces the effects of feedthrough through the
board. A microstrip technique is by far the best, but it is not
always possible with a double-sided board. In this technique,
the component side of the board is dedicated to ground planes,
and signals are placed on the solder side.
Good decoupling is important when using high resolution
ADCs. AVDD should be decoupled with 10 μF tantalum in
parallel with 0.1 μF capacitors to GND. DVDD should be
decoupled with 10 μF tantalum in parallel with 0.1 μF
capacitors to the system’s DGND plane, with the system’s
AGND to DGND connection being close to the
AD7792/AD7793.
To achieve the best from these decoupling components, they
should be placed as close as possible to the device, ideally right
up against the device. All logic chips should be decoupled with
0.1 μF ceramic capacitors to DGND.
相關PDF資料 |
PDF描述 |
|---|---|
| MS27497E10A13S | CONN RCPT 13POS WALL MNT W/SCKT |
| AD7813YNZ | IC ADC 10BIT PARALLEL 16-DIP |
| AD7708BRZ-REEL7 | IC ADC 16BIT R-R 8/10CH 28SOIC |
| CS3100A-14S-78P | CONN RCPT 2POS WALL MNT W/PINS |
| AD7366BRUZ-5-RL7 | IC ADC 12BIT DUAL BIPO 24-TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7793BRUZ-REEL1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:3-Channel, Low Noise, Low Power, 16-/24-Bit ?￡-?? ADC with On-Chip In-Amp and Reference |
| AD7794 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, 24-Bit Sigma-Delta ADC with In-Amp and Embedded Reference (6 Channel) |
| AD7794_07 | 制造商:AD 制造商全稱:Analog Devices 功能描述:6-Channel, Low Noise, Low Power, 24-/16-Bit ?￡-?? ADC with On-Chip In-Amp and Reference |
| AD7794BRU | 功能描述:IC ADC 24BIT 6CH LP 24-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
| AD7794BRU-REEL | 功能描述:IC ADC 24BIT 6CH LP 24-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
發布緊急采購，3分鐘左右您將得到回復。