參數資料
型號: AD7734BRUZ
廠商: Analog Devices Inc
文件頁數: 15/32頁
文件大?。?/td> 0K
描述: IC ADC 24BIT 4-CH 28-TSSOP
標準包裝: 50
位數: 24
采樣率(每秒): 15.4k
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 100mW
電壓電源: 模擬和數字
工作溫度: -40°C ~ 105°C
安裝類型: 表面貼裝
封裝/外殼: 28-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 28-TSSOP
包裝: 管件
輸入數目和類型: 4 個單端,單極;4 個單端,雙極
產品目錄頁面: 779 (CN2011-ZH PDF)
配用: EVAL-AD7734EBZ-ND - BOARD EVALUATION FOR AD7734
AD7734
Data Sheet
Rev. A | Page 22 of 32
DIGITAL INTERFACE DESCRIPTION
HARDWARE
The AD7734 serial interface can be connected to the host
device via the serial interface in several different ways.
The CS pin can be used to select the AD7734 as one of several
circuits connected to the host serial interface. When CS is high,
the AD7734 ignores the SCLK and DIN signals and the DOUT
pin goes to the high impedance state. When the CS signal is not
used, connect the CS pin to DGND.
The RDY pin can be polled for high-to-low transition or can
drive the host device interrupt input to indicate that the
AD7734 has finished the selected operation and/or new data
from the AD7734 is available. The host system can also wait a
designated time after a given command is written to the device
before reading. Alternatively, the AD7734 status can be polled.
When the RDY pin is not used in the system, it should be left as
an open circuit. (Note that the RDY pin is always an active
digital output, i.e., it never goes into a high impedance state.)
The RESET pin can be used to reset the AD7734. When not
used, connect this pin to DVDD.
The AD7734 interface can be reduced to just two wires
connecting the DIN and DOUT pins to a single bidirectional
data line. The second signal in this 2-wire configuration is the
SCLK signal. The host system should change the data line
direction with reference to the AD7734 timing specification
(see the Bus Relinquish Time in Table 2). The AD7734 cannot
operate in the continuous read mode in 2-wire serial interface
configuration.
All the digital interface inputs are Schmitt-Triggered; therefore,
the AD7734 interface features higher noise immunity and can
be easily isolated from the host system via optocouplers.
Figure 13, Figure 14, and Figure 15 outline some of the possible
host device interfaces: SPI without using the CS signal
(Figure 13), a DSP interface (Figure 14), and a 2-wire
configuration (Figure 15).
SCLK
DIN
DOUT
CS
RDY
RESET
DGND
DVDD DVDD
AD7734
SCK
MOSI
MISO
INT
68HC11
SS
Figure 13. AD7734 to Host Device Interface, SPI
SCLK
DIN
DOUT
CS
RDY
RESET
DVDD
AD7734
SCLK
DT
DR
INT
TFS
RFS
ADSP-2105
Figure 14. AD7734 to Host Device Interface, DSP
SCLK
DIN
DOUT
CS
RESET
DGND
DVDD
AD7734
P3.1/TXD
P3.0/RXD
8xC51
Figure 15. AD7734 to Host Device Interface, 2-Wire Configuration
相關PDF資料
PDF描述
UMK105CH180JW-F CAP CER 18PF 50V 5% C0H 0402
AD7714ARSZ-3 IC ADC 24BIT SIGMA-DELTA 28SSOP
UMK105CH150KW-F CAP CER 15PF 50V 10% C0H 0402
AD7893ARZ-3 IC ADC 12BIT SRL T/H LP 8SOIC
UMK105CH150JW-F CAP CER 15PF 50V 5% C0H 0402
相關代理商/技術參數
參數描述
AD7734BRUZ 制造商:Analog Devices 功能描述:IC 24BIT ADC SMD 7734 TSSOP28
AD7734BRUZ-REEL 功能描述:IC ADC 24BIT 4CH SIG-DEL 28TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
AD7734BRUZ-REEL7 功能描述:IC ADC 24BIT 4CH SIG-DEL 28TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極
AD7738 制造商:Analog Devices 功能描述:- Bulk
AD7738BRU 功能描述:IC ADC 24BIT 8-CH 28-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率(每秒):300k 數據接口:并聯 轉換器數目:1 功率耗散(最大):75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC(0.295",7.50mm 寬) 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端,單極;1 個單端,雙極