0.8 × VREF
參數資料
型號: AD7715ARU-5
廠商: Analog Devices Inc
文件頁數: 18/40頁
文件大小: 0K
描述: IC ADC 16BIT SIGMA-DELTA 16TSSOP
標準包裝: 1
位數: 16
采樣率(每秒): 500
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 9.5mW
電壓電源: 模擬和數字
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 16-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 16-TSSOP
包裝: 管件
輸入數目和類型: 1 個差分,單極;1 個差分,雙極
配用: EVAL-AD7715-3EBZ-ND - BOARD EVALUATION FOR AD7715
AD7715
Rev. D | Page 25 of 40
If the part is used in unipolar mode with a required span of
0.8 × VREF/GAIN, then the offset range which the system
calibration can handle is from 1.05 × VREF/GAIN to +0.25 ×
VREF/GAIN. If the part is used in unipolar mode with a required
span of VREF/GAIN, then the offset range which the system
calibration can handle is from 1.05 × VREF/GAIN to +0.05 ×
VREF/GAIN. Similarly, if the part is used in unipolar mode and
required to remove an offset of 0.2 × VREF/GAIN, then the span
range which the system calibration can handle is 0.85 ×
VREF/GAIN.
If the part is used in bipolar mode with a required span of ±0.4 ×
VREF/GAIN, then the offset range which the system calibration
can handle is from 0.65 × VREF/GAIN to +0.65 × VREF/GAIN. If
the part is used in bipolar mode with a required span of ±VREF/
GAIN, then the offset range which the system calibration can
handle is from 0.05 × VREF/GAIN to +0.05 × VREF/GAIN.
Similarly, if the part is used in bipolar mode and required to
remove an offset of ±0.2 × VREF/GAIN, then the span range
which the system calibration can handle is ±0.85 × VREF/GAIN.
Power-Up and Calibration
On power-up, the AD7715 performs an internal reset that sets
the contents of the internal registers to a known state. There are
default values loaded to all registers after a power-on or reset.
The default values contain nominal calibration coefficients for
the calibration registers. However, to ensure correct calibration
for the device a calibration routine should be performed after
power-up.
The power dissipation and temperature drift of the AD7715
are low, and no warm-up time is required before the initial
calibration is performed. However, if an external reference is
being used, this reference must have stabilized before calibration is
initiated. Similarly, if the clock source for the part is generated
from a crystal or resonator across the MCLK pins, the start-up
time for the oscillator circuit should elapse before a calibration
is initiated on the part (see the Clocking and Oscillator Circuit
section).
相關PDF資料
PDF描述
MIC2550YTS TR IC USB TRANSCEIVER 14-TSSOP
VI-23W-MX-F1 CONVERTER MOD DC/DC 5.5V 75W
SP3243EEY-L/TR IC TXRX RS232 INTELLIGNT 28TSSOP
LTC2289CUP#TRPBF IC ADC DUAL 10BIT 80MSPS 64QFN
VI-23V-MX-F4 CONVERTER MOD DC/DC 5.8V 75W
相關代理商/技術參數
參數描述
AD7715ARU-5REEL 功能描述:IC ADC 16BIT SIGMA-DELTA 16TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
AD7715ARU-5REEL7 制造商:Analog Devices 功能描述:ADC Single Delta-Sigma 19.2ksps 16-bit Serial 16-Pin TSSOP T/R
AD7715ARUZ-3 功能描述:IC ADC 16BIT SIGMA-DELTA 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率(每秒):20M 數據接口:并聯 轉換器數目:2 功率耗散(最大):155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP(7x7) 包裝:Digi-Reel® 輸入數目和類型:4 個單端,單極;2 個差分,單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6
AD7715ARUZ-31 制造商:AD 制造商全稱:Analog Devices 功能描述:3 V/5 V, 450 ??A 16-Bit, Sigma-Delta ADC
AD7715ARUZ-3REEL7 功能描述:IC ADC 16BIT SIGMA-DELTA 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極