- 您現在的位置：買賣IC網 > PDF目錄1982 > AD7689BCPZRL7 (Analog Devices Inc)IC ADC 16BIT 250KSPS 8CH 20LFCSP PDF資料下載
參數資料
| 型號： | AD7689BCPZRL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 18/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 16BIT 250KSPS 8CH 20LFCSP |
| 產品培訓模塊： | Power Line Monitoring Motor Control |
| 產品變化通告： | Startup Circuitry Design Improvement Change 15/April/2009 |
| 標準包裝： | 1 |
| 系列： | PulSAR® |
| 位數： | 16 |
| 采樣率（每秒）： | 250k |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 21mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 20-LFCSP-VQ |
| 包裝： | 標準包裝 |
| 輸入數目和類型： | 8 個單端，單極；4 個差分，雙極；4 個偽差分，雙極 |
| 其它名稱： | AD7689BCPZRL7DKR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Data Sheet
AD7682/AD7689
Rev. D | Page 25 of 32
The register can be written to during conversion, during acquisi-
tion, or spanning acquisition/conversion, and is updated at the end
of conversion, tCONV (maximum). There is always a one deep
delay when writing the CFG register. Note that, at power-up, the
CFG register is undefined and two dummy conversions are
required to update the register. To preload the CFG register with a
factory setting, hold DIN high for two conversions. Thus
following:
IN[7:0] unipolar referenced to GND, sequenced in order
Full bandwidth for a one-pole filter
Internal reference/temperature sensor disabled, buffer
enabled
Enables the internal sequencer
No readback of the CFG register
Table 10 summarizes the configuration register bit details. See
the Theory of Operation section for more details.
13
12
11
10
9
8
7
6
5
4
3
2
1
0
CFG
INCC
INx
BW
REF
SEQ
RB
Table 10. Configuration Register Description
Bit(s)
Name
Description
[13]
CFG
Configuration update.
0 = keep current configuration settings.
1 = overwrite contents of register.
[12:10]
INCC
Input channel configuration. Selection of pseudo bipolar, pseudo differential, pairs, single-ended, or temperature sensor. Refer
to the
Input Configurations section.
Bit 12
Bit 11
Bit 10
Function
0
Bipolar differential pairs; INx referenced to VREF/2 ± 0.1 V.
0
1
Bipolar; INx referenced to COM = VREF/2 ± 0.1 V.
0
1
Temperature sensor.
1
0
Unipolar differential pairs; INx referenced to GND ± 0.1 V.
1
0
Unipolar, INx referenced to COM = GND ± 0.1 V.
1
Unipolar, INx referenced to GND.
[9:7]
INx
Input channel selection in binary fashion.
Bit 9
Bit 8
Bit 7
Channel
Bit 9
Bit 8
Bit 7
Channel
0
IN0
0
IN0
0
1
IN1
0
1
IN1
1
0
IN2
…
1
IN3
1
IN7
[6]
BW
Select bandwidth for low-pass filter. Refer to the
Selectable Low-Pass Filter section.
0 = of BW, uses an additional series resistor to further bandwidth limit the noise. Maximum throughput must also be reduced to .
1 = full BW.
[5:3]
REF
Reference/buffer selection. Selection of internal, external, external buffered, and enabling of the on-chip temperature sensor.
Refer to the
Voltage Reference Output/Input section.
Bit 5
Bit 4
Bit 3
Function
0
Internal reference, REF = 2.5 V output,
temperature enabled.
0
1
Internal reference, REF = 4.096 V output,
temperature enabled.
0
1
0
External reference, temperature enabled.
0
1
External reference, internal buffer, temperature enabled.
1
0
External reference, temperature disabled.
1
External reference, internal buffer, temperature disabled.
[2:1]
SEQ
Channel sequencer. Allows for scanning channels in an IN0 to IN[7:0] fashion. Refer to the
Channel Sequencer section.
Bit 2
Bit 1
Function
0
Disable sequencer.
0
1
Update configuration during sequence.
1
0
Scan IN0 to IN[7:0] (set in CFG[9:7]), then temperature.
1
Scan IN0 to IN[7:0] (set in CFG[9:7]).
[0]
RB
Read back the CFG register.
0 = read back current configuration at end of data.
1 = do not read back contents of configuration.
1 X = don’t care.
相關PDF資料 |
PDF描述 |
|---|---|
| AD7690BCPZRL | IC ADC 18BIT 400KSPS 10-LFCSP |
| AD7691BCPZRL7 | IC ADC 18BIT SAR 250KSPS 10LFCSP |
| AD7693BRMZRL7 | IC ADC 16BIT 500KSPS 10-MSOP |
| AD7694ARMZ | IC ADC 16BIT SAR 250KSPS 8MSOP |
| AD7699BCPZRL7 | IC ADC 8CH 16BIT 500KSPS 20LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD768ACHIPS | 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit, 30 MSPS D/A Converter |
| AD768AF/QMLR | 制造商:Analog Devices 功能描述: |
| AD768AR | 功能描述:IC DAC 16BIT 30MSPS 28-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 設置時間:1µs 位數:8 數據接口:串行 轉換器數目:8 電壓電源:雙 ± 功率耗散（最大）:941mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC W 包裝:帶卷 (TR) 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。