- 您現在的位置：買賣IC網 > PDF目錄10351 > AD7453ARTZ-REEL7 (Analog Devices Inc)IC ADC 12BIT DFF 600KSPS SOT23-8 PDF資料下載
參數資料
| 型號： | AD7453ARTZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/21頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT DFF 600KSPS SOT23-8 |
| 設計資源： | Measuring -48 V High-Side Current Using AD629, AD8603, AD780, and AD7453 (CN0100) |
| 標準包裝： | 1 |
| 位數： | 12 |
| 采樣率（每秒）： | 555k |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 7.25mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-8 |
| 供應商設備封裝： | SOT-23-8 |
| 包裝： | 標準包裝 |
| 輸入數目和類型： | 1 個偽差分，單極 |
| 其它名稱： | AD7453ARTZ-REEL7DKR |
AD7453
Rev. B | Page 15 of 20
MODES OF OPERATION
The mode of operation of the AD7453 is selected by controlling
the logic state of the CS signal during a conversion. There are
two possible modes of operation, normal mode and power-
down mode. The point at which CS is pulled high after the
conversion has been initiated determines whether the AD7453
enters power-down mode. Similarly, if already in power-down,
CS controls whether the device returns to normal operation or
remains in power-down. These modes of operation are designed
to provide flexible power management options. These options
can be chosen to optimize the power dissipation/ throughput
rate ratio for differing application requirements.
NORMAL MODE
This mode is intended for fastest throughput rate performance.
The user does not have to worry about any power-up times with
the AD7453 remaining fully powered up all the time. Figure 24
shows the general diagram of the operation of the AD7453 in
this mode. The conversion is initiated on the falling edge of CS,
as described in the Serial Interface section. To ensure that the
part remains fully powered up, CS must remain low until at
least 10 SCLK falling edges have elapsed after the falling edge
of CS.
If CS is brought high any time after the 10th SCLK falling edge
but before the 16th SCLK falling edge, the part remains powered
up but the conversion is terminated and SDATA goes back into
three-state. Sixteen serial clock cycles are required to complete
the conversion and access the complete conversion result. CS
may idle high until the next conversion, or may idle low until
some time prior to the next conversion. Once a data transfer is
complete, i.e., when SDATA has returned to three-state, another
conversion can be initiated after the quiet time, tQUIET, has
elapsed by again bringing CS low.
110
CS
SCLK
SDATA
16
4 LEADING ZEROS + CONVERSION RESULT
03155-A
-024
Figure 24. Normal Mode Operation
POWER-DOWN MODE
This mode is intended for use in applications where slower
throughput rates are required—the ADC is powered down
between each conversion, or a series of conversions may be
performed at a high throughput rate and the ADC is then
powered down for a relatively long duration between these
bursts of several conversions. When the AD7453 is in power-
down mode, all analog circuitry is powered down. For the
AD7453 to enter power-down mode, the conversion process
must be interrupted by bringing CS high anywhere after the
second falling edge of SCLK and before the 10th falling edge of
SCLK, as shown in Figure 25.
Once CS has been brought high in this window of SCLKs, the
part enters power-down, the conversion that was initiated by
the falling edge of CS is terminated, and SDATA goes back into
three-state. The time from the rising edge of CS to SDATA
Specifications). If CS is brought high before the second SCLK
falling edge, the part remains in normal mode and does not
power down. This avoids accidental power-down due to glitches
on the CS line.
To exit this mode of operation and power up the AD7453 again,
a dummy conversion is performed. On the falling edge of CS,
the device begins to power up, and continues to power up as
long as CS is held low until after the falling edge of the 10th
SCLK. The device is fully powered up after 1 s has elapsed and,
as shown in Figure 26, valid data results from the next
conversion.
If CS is brought high before the 10th falling edge of SCLK, the
AD7453 again goes back into power-down. This avoids
accidental power-up due to glitches on the CS line or an
inadvertent burst of eight SCLK cycles while CS is low. So
although the device may begin to power up on the falling edge
of CS, it again powers down on the rising edge of CS as long as
it occurs before the 10th SCLK falling edge.
1
10
CS
SCLK
SDATA
THREE-STATE
2
03155-A
-025
Figure 25. Entering Power-Down Mode
相關PDF資料 |
PDF描述 |
|---|---|
| VE-B5D-MW-S | CONVERTER MOD DC/DC 85V 100W |
| MAX3227CDBG4 | IC RS232 3V5.5V 15KVESD 16-SSOP |
| LTC1199IS8#TRPBF | IC ADC 10BIT 450KHZ W/SD 8-SOIC |
| MAX9719DEBE+T | IC AMP AUDIO PWR 1.4W AB 16UCSP |
| AD7993BRU-1REEL | IC ADC 10BIT 4CHAN I2C 16TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7453BRT-R2 | 制造商:Analog Devices 功能描述:ADC Single SAR 555ksps 12-bit Serial 8-Pin SOT-23 T/R 制造商:Rochester Electronics LLC 功能描述:12-BIT P/DIFF I/PUT, 600KSPS ADC I.C. - Bulk |
| AD7453BRT-REEL7 | 制造商:Analog Devices 功能描述:ADC Single SAR 555ksps 12-bit Serial 8-Pin SOT-23 T/R |
| AD7453BRTZ-R2 | 功能描述:IC ADC 12BIT 555KSPS SOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| AD7453BRTZ-REEL7 | 功能描述:IC ADC 12BIT W/DIFF INP SOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7457 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Power, Pseudo Differential, 100 kSPS 12-Bit ADC in an 8-Lead SOT-23 |
發布緊急采購，3分鐘左右您將得到回復。