- 您現在的位置：買賣IC網 > PDF目錄9450 > AD7400YRWZ-REEL (Analog Devices Inc)IC MODULATOR SIGMA-DELTA 16-SOIC PDF資料下載
參數資料
| 型號： | AD7400YRWZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 6/20頁 |
| 文件大小： | 0K |
| 描述： | IC MODULATOR SIGMA-DELTA 16-SOIC |
| 標準包裝： | 1,000 |
| 類型： | 調制器 |
| 分辨率（位）： | 16 b |
| 采樣率（每秒）： | 10M |
| 數據接口： | 串行 |
| 電壓電源： | 單電源 |
| 電源電壓： | 4.5 V ~ 5.25 V |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 16-SOIC W |
| 包裝： | 帶卷 (TR) |
AD7400
Data Sheet
Rev. G | Page 14 of 20
DIFFERENTIAL INPUTS
The analog input to the modulator is a switched capacitor
design. The analog signal is converted into charge by highly
linear sampling capacitors. A simplified equivalent circuit
diagram of the analog input is shown in Figure 23. A signal
source driving the analog input must be able to provide the
charge onto the sampling capacitors every half MCLKOUT cycle
and settle to the required accuracy within the next half cycle.
φA
φB
1k
VIN–
φA
φB
1k
VIN+
2pF
φA
MCLKOUT
04718-
027
Figure 23. Analog Input Equivalent Circuit
Because the AD7400 samples the differential voltage across its
analog inputs, low noise performance is attained with an input
circuit that provides low common-mode noise at each input.
The amplifiers used to drive the analog inputs play a critical role in
attaining the high performance available from the AD7400.
When a capacitive load is switched onto the output of an op
amp, the amplitude momentarily drops. The op amp tries to
correct the situation and, in the process, hits its slew rate limit.
This nonlinear response, which can cause excessive ringing, can
lead to distortion. To remedy the situation, a low-pass RC filter
can be connected between the amplifier and the input to the
AD7400. The external capacitor at each input aids in supplying
the current spikes created during the sampling process, and the
resistor isolates the op amp from the transient nature of the load.
The recommended circuit configuration for driving the differential
inputs to achieve best performance is shown in Figure 24. A
capacitor between the two input pins sources or sinks charge
to allow most of the charge that is needed by one input to be
effectively supplied by the other input. The series resistor again
isolates any op amp from the current spikes created during the
sampling process. Recommended values for the resistors and
capacitor are 22 and 47 pF, respectively.
R
VIN–
R
VIN+
C
AD7400
04718-
028
Figure 24. Differential Input RC Network
相關PDF資料 |
PDF描述 |
|---|---|
| MS27497T24B1P | CONN RCPT 128POS WALL MNT W/PINS |
| AD7400YRWZ | IC MODULATOR SIGMA-DELTA 16-SOIC |
| MS27474E16A35PB | CONN RCPT 55POS JAM NUT W/PINS |
| MS27497E20F41SA | CONN RCPT 41POS WALL MNT W/SCKT |
| MS27474T18B11S | CONN RCPT 11POS JAM NUT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7400YRWZ-REEL7 | 功能描述:IC MODULATOR SIGMA-DELTA 16-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD7401 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Isolated Sigma-Delta Modulator |
| AD7401_0612 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Isolated Sigma-Delta Modulator |
| AD7401A | 制造商:AD 制造商全稱:Analog Devices 功能描述:Isolated Sigma-Delta Modulator |
| AD7401AYRWZ | 功能描述:IC MODULATOR SIGMA-DELTA 16SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
發布緊急采購，3分鐘左右您將得到回復。