- 您現在的位置：買賣IC網 > PDF目錄1979 > AD5760BCPZ (Analog Devices Inc)IC DAC VOLT OUT 16BIT 24LFCSP PDF資料下載
參數資料
| 型號： | AD5760BCPZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 17/28頁 |
| 文件大小： | 0K |
| 描述： | IC DAC VOLT OUT 16BIT 24LFCSP |
| 標準包裝： | 1 |
| 設置時間： | 2.5µs |
| 位數： | 16 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 電壓電源： | 模擬和數字，雙 ± |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 24-LFCSP-VQ EP（4x5） |
| 包裝： | 托盤 |
| 輸出數目和類型： | 1 電壓，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD5760
Data Sheet
Rev. D | Page 24 of 28
AD5760 FEATURES
POWER-ON TO 0 V
The AD5760 contains a power-on reset circuit that, as well as
resetting all registers to their default values, controls the output
voltage during power-up. Upon power-on, the DAC is placed in
tristate (its reference inputs are disconnected), and its output is
clamped to AGND through a ~6 k resistor. The DAC remains
in this state until programmed otherwise via the control register.
This is a useful feature in applications where it is important to
know the state of the DAC output while it is in the process of
powering up.
CONFIGURING THE AD5760
After power-on, the AD5760 must be configured to put it into
normal operating mode before programming the output. To
do this, the control register must be programmed. The DAC
is removed from tristate by clearing the DACTRI bit, and the
output clamp is removed by clearing the OPGND bit. At this
point, the output goes to VREFN unless an alternative value is
first programmed to the DAC register.
DAC OUTPUT STATE
The DAC output can be placed in one of three states, controlled
by the DACTRI and OPGND bits of the control register, as
shown in Table 15.
Table 15. Output State Truth Table
DACTRI
OPGND
Output State
0
Normal operating mode.
0
1
Output is clamped via ~6 k to AGND.
1
0
Output is in tristate.
1
Output is clamped via ~6 k to AGND.
OUTPUT AMPLIFIER CONFIGURATION
There are a number of different ways that an output amplifier
can be connected to the AD5760, depending on the voltage
references applied and the desired output voltage span.
Unity-Gain Configuration
Figure 50 shows an output amplifier configured for unity gain.
In this configuration, the output spans from VREFN to VREFP.
A1
6.8k 6.8k
R1
RFB
VREFP
RFB
INV
VOUT
16-BIT
DAC
VREFN
AD5760
AD8675
ADA4898-1
ADA4004-1
09650-
052
Figure 50. Output Amplifier in Unity-Gain Configuration
A second unity-gain configuration for the output amplifier is
one that removes an offset from the input bias currents of the
amplifier. It does this by inserting a resistance in the feedback
path of the amplifier that is equal to the output resistance of the
DAC. The DAC output resistance is 3.4 k. By connecting R1
and RFB in parallel, a resistance equal to the DAC resistance is
available on chip. Because the resistors are all on one piece of
silicon, they are temperature coefficient matched. To enable this
mode of operation, the RBUF bit of the control register must be
set to Logic 1. Figure 51 shows how the output amplifier is
connected to the AD5760. In this configuration, the output
amplifier is in unity gain, and the output spans from VREFN to
VREFP. This unity-gain configuration allows a capacitor to be
placed in the amplifier feedback path to improve dynamic
performance.
VREFP
RFB
INV
VOUT
10pF
16-BIT
DAC
VREFN
AD5760
AD8675
ADA4898-1
ADA4004-1
RFB
6.8k
R1
6.8k
09650-
053
Figure 51. Output Amplifier in Unity-Gain with Amplifier Input Bias Current
Compensation
相關PDF資料 |
PDF描述 |
|---|---|
| AD5762RCSUZ-REEL7 | IC DAC 16BIT QUAD VOUT 32-TQFP |
| AD5763CSUZ-REEL7 | DAC 16BIT DUAL 5V 2LSB 32-TQFP |
| AD5764CSUZ | IC DAC 16BIT QUAD VOUT 32TQFP |
| AD5764RBSUZ | IC DAC 16BIT QUAD VOUT 32-TQFP |
| AD5781BRUZ-REEL7 | IC DAC 18BIT SRL 20TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5760BCPZ-REEL7 | 功能描述:數模轉換器- DAC 16B +/-0.5 LSB INL VOut RoHS:否 制造商:Analog Devices 轉換器數量:4 DAC 輸出端數量:4 轉換速率: 分辨率:12 bit 接口類型:Serial (I2C) 穩定時間: 最大工作溫度:+ 105 C 安裝風格: 封裝 / 箱體:TSSOP 封裝:Reel |
| AD5761ACPZ-RL7 | 功能描述:IC DAC 16BIT 1CH 8LSB 16LFCSP 制造商:analog devices inc. 系列:- 零件狀態:在售 位數:16 數模轉換器數:1 建立時間:12.5μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部 電壓 - 電源，模擬:4.5 V ~ 30 V， -16.5V 電壓 - 電源，數字:1.7 V ~ 5.5 V INL/DNL（LSB）:±8（最大），±1（最大） 架構:R-2R 工作溫度:-40°C ~ 125°C 標準包裝:1 |
| AD5761ARUZ | 功能描述:16 Bit Digital to Analog Converter 1 16-TSSOP 制造商:analog devices inc. 系列:- 包裝:管件 零件狀態:有效 位數:16 數模轉換器數:1 建立時間:12.5μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部 電壓 - 電源，模擬:4.5 V ~ 30 V， -16.5V 電壓 - 電源，數字:1.7 V ~ 5.5 V INL/DNL（LSB）:±8（最大），±1（最大） 架構:R-2R 工作溫度:-40°C ~ 125°C 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商器件封裝:16-TSSOP 標準包裝:96 |
| AD5761ARUZ-RL7 | 功能描述:16 Bit Digital to Analog Converter 1 16-TSSOP 制造商:analog devices inc. 系列:- 包裝:帶卷（TR） 零件狀態:有效 位數:16 數模轉換器數:1 建立時間:12.5μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部 電壓 - 電源，模擬:4.5 V ~ 30 V， -16.5V 電壓 - 電源，數字:1.7 V ~ 5.5 V INL/DNL（LSB）:±8（最大），±1（最大） 架構:R-2R 工作溫度:-40°C ~ 125°C 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商器件封裝:16-TSSOP 標準包裝:1,000 |
| AD5761BCPZ-RL7 | 功能描述:16 Bit Digital to Analog Converter 1 16-LFCSP-WQ (3x3) 制造商:analog devices inc. 系列:- 包裝:帶卷（TR） 零件狀態:有效 位數:16 數模轉換器數:1 建立時間:12.5μs 輸出類型:Voltage - Buffered 差分輸出:無 數據接口:SPI 參考類型:外部 電壓 - 電源，模擬:4.5 V ~ 30 V， -16.5V 電壓 - 電源，數字:1.7 V ~ 5.5 V INL/DNL（LSB）:±2（最大），±1（最大） 架構:R-2R 工作溫度:-40°C ~ 125°C 封裝/外殼:16-WFQFN 裸露焊盤，CSP 供應商器件封裝:16-LFCSP-WQ（3x3） 標準包裝:1,500 |
發布緊急采購，3分鐘左右您將得到回復。