參數資料
型號: A1184LUA
廠商: Allegro MicroSystems, Inc.
元件分類: 霍爾效應傳感器
英文描述: Standard Two-Wire Field-Programmable Chopper-Stabilized Unipolar Hall-Effect Switches
中文描述: 標準的二線現場可編程斬波穩定單極霍爾效應開關
文件頁數: 8/14頁
文件大小: 317K
代理商: A1184LUA
8
A1184-DS, Rev. 2
Worcester, Massachusetts 01615-0036 (508) 853-5000
www.allegromicro.com
115 Northeast Cutoff, Box 15036
Allegro MicroSystems, Inc.
Standard Two-Wire Field-Programmable Chopper-Stabilized Unipolar Hall Effect Switch
A1184
Application Information
For additional general application information, visit the Allegro
MicroSystems Web site at www. allegromicro.com.
GND
A118x
VCC
V+
0.01 uF
A
B
B
GND
ECU
Package UA Only
A
B
Maximum separation 5 mm
R
SENSE
C
BYP
Figure 3. Typical application circuit
Typical Application Circuit
The A118x family of devices must be protected by an external
bypass capacitor, C
BYP
, connected between the supply, VCC,
and the ground, GND, of the device. C
BYP
reduces both external
noise and the noise generated by the chopper-stabilization func-
tion. As shown in figure 3, a 0.01
μ
F capacitor is typical.
Installation of C
BYP
must ensure that the traces that connect it to
the A118x pins are no greater than 5 mm in length.
All high-frequency interferences conducted along the supply
lines are passed directly to the load through C
BYP
, and it serves
only to protect the A118x internal circuitry. As a result, the load
ECU (electronic control unit) must have sufficient protection,
other than C
BYP
, installed in parallel with the A118x.
A series resistor on the supply side, R
S
(not shown), in combi-
nation with C
BYP
, creates a filter for EMI pulses. (Additional
information on EMC is provided on the Allegro MicroSystems
Web site.)
When determining the minimum V
CC
requirement of the A118x
device, the voltage drops across R
S
and the ECU sense resistor,
R
SENSE
, must be taken into consideration. The typical value for
R
SENSE
is approximately 100
Ω
.
相關PDF資料
PDF描述
A1184LUA-T Standard Two-Wire Field-Programmable Chopper-Stabilized Unipolar Hall-Effect Switches
A1184LLHLT Standard Two-Wire Field-Programmable Chopper-Stabilized Unipolar Hall-Effect Switches
A1184LLHLT-T Standard Two-Wire Field-Programmable Chopper-Stabilized Unipolar Hall-Effect Switches
A1184 Two-Wire, Programmable, Chopper-Stabilized, Unipolar Hall-Effect Switch
A1184EUA Standard Two-Wire Field-Programmable Chopper-Stabilized Unipolar Hall-Effect Switches
相關代理商/技術參數
參數描述
A1184LUA-T 功能描述:IC SWITCH HALL EFFECT UNI 3-SIP RoHS:是 類別:傳感器,轉換器 >> 磁性 - 霍爾效應,數字式開關,線性,羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出(最大):- 輸出類型:數字式,PWM,8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP(0.209",5.30mm 寬) 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR
A1185 制造商:Quick 功能描述:TSOJ 13 X 10 NOZZLE FOR QUICK957/957D
A118-5 制造商:APEM 功能描述:
A1185_06 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:Ultrasensitive Two-Wire Field-Programmable Chopper-Stabilized Unipolar Hall-Effect Switches
A1185B 制造商:HAKKO Corporation 功能描述: