- 您現在的位置：買賣IC網 > PDF目錄25563 > 9DB1233AGLF (INTEGRATED DEVICE TECHNOLOGY INC) 9DB SERIES, PLL BASED CLOCK DRIVER, 12 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO64 PDF資料下載
參數資料
| 型號： | 9DB1233AGLF |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘及定時 |
| 英文描述： | 9DB SERIES, PLL BASED CLOCK DRIVER, 12 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO64 |
| 封裝： | 6.10 MM, 0.50 MM PITCH, ROHS COMPLIANT, MO-153, TSSOP-64 |
| 文件頁數： | 12/15頁 |
| 文件大小： | 181K |
| 代理商： | 9DB1233AGLF |
IDT Twelve Output Differential Buffer for PCIe Gen3
9DB1233
Twelve Output Differential Buffer for PCIe Gen3
6
1675B—11/08/10
Electrical Characteristics - Clock Input Parameters
TA = TCOM; Supply Voltage VDD = 3.3 V +/-5%
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS NOTES
Input High Voltage - DIF_IN
VIHDIF
Differential inputs
(single-ended measurement)
600
800
1150
mV
1
Input Low Voltage - DIF_IN
VILDIF
Differential inputs
(single-ended measurement)
VSS - 300
0
300
mV
1
Input Common Mode
Voltage - DIF_IN
VCOM
Common Mode Input Voltage
300
1000
mV
1
Input Amplitude - DIF_IN
VSWING
Peak to Peak value
300
1450
mV
1
Input Slew Rate - DIF_IN
dv/dt
Measured differentially
0.4
8
V/ns
1,2
Input Leakage Current
IIN
VIN = VDD , VIN = GND
-5
5
uA
1
Input Duty Cycle
dtin
Measurement from differential wavefrom
45
55
%
1
Input Jitter - Cycle to Cycle
JDIFIn
Differential Measurement
0
125
ps
1
1 Guaranteed by design and characterization, not 100% tested in production.
2Slew rate measured through +/-75mV window centered around differential zero
Electrical Characteristics - DIF 0.7V Current Mode Differential Outputs
TA = TCOM; Supply Voltage VDD = 3.3 V +/-5%
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS NOTES
Slew rate
Trf
Scope averaging on
1
2.4
4
V/ns
1, 2, 3
Slew rate matching
Trf
Slew rate matching, Scope averaging on
20
%
1, 2, 4
Voltage High
VHigh
660
800
850
1
Voltage Low
VLow
-150
20
150
1
Max Voltage
Vmax
850
1150
1
Min Voltage
Vmin
-300
1
Vswing
Scope averaging off
300
mV
1, 2
Crossing Voltage (abs)
Vcross_abs
Scope averaging off
250
550
mV
1, 5
Crossing Voltage (var)
-Vcross
Scope averaging off
140
mV
1, 6
2 Measured from differential waveform
5 Vcross is defined as voltage where Clock = Clock# measured on a component test board and only applies to the differential rising edge (i.e.
Clock rising and Clock# falling).
6 The total variation of all Vcross measurements in any particular system. Note that this is a subset of V_cross_min/max (V_cross absolute)
allowed. The intent is to limit Vcross induced modulation by setting V_cross_delta to be smaller than V_cross absolute.
mV
Statistical measurement on single-ended signal
using oscilloscope math function. (Scope averaging
on)
Measurement on single ended signal using absolute
value. (Scope averaging off)
mV
1Guaranteed by design and characterization, not 100% tested in production. IREF = VDD/(3xR
R). For RR = 475
(1%), IREF = 2.32mA. IOH =
6 x IREF and VOH = 0.7V @ ZO=50 (100 differential impedance).
3 Slew rate is measured through the Vswing voltage range centered around differential 0V. This results in a +/-150mV window around
differential 0V.
4 Matching applies to rising edge rate for Clock and falling edge rate for Clock#. It is measured using a +/-75mV window centered on the
average cross point where Clock rising meets Clock# falling. The median cross point is used to calculate the voltage thresholds the
oscilloscope is to use for the edge rate calculations.
Electrical Characteristics - Current Consumption
TA = TCOM; Supply Voltage VDD = 3.3 V +/-5%
PARAMETER
SYMBOL
CONDITIONS
MIN
TYP
MAX
UNITS NOTES
Operating Supply Current
IDD3.3OP
All outputs active @100MHz, CL = Full load;
300
375
mA
1
IDD3.3PD
All diff pairs driven
mA
1
IDD3.3PDZ
All differential pairs tri-stated
21
24
mA
1
1Guaranteed by design and characterization, not 100% tested in production.
Powerdown Current
NA
相關PDF資料 |
PDF描述 |
|---|---|
| 9DB1904BKLFT | 9DB SERIES, PLL BASED CLOCK DRIVER, 19 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQCC72 |
| 9DB1933AKLF | 9DB SERIES, PLL BASED CLOCK DRIVER, 19 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQCC72 |
| 9DB1933AKLFT | 9DB SERIES, PLL BASED CLOCK DRIVER, 19 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PQCC72 |
| 9DB202CGLF | 9DB SERIES, PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO20 |
| 9DB202CFLF | 9DB SERIES, PLL BASED CLOCK DRIVER, 2 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 9DB1233AGLFT | 功能描述:時鐘緩沖器 12 OUTPUT PCIE GEN3 BUFFER RoHS:否 制造商:Texas Instruments 輸出端數量:5 最大輸入頻率:40 MHz 傳播延遲（最大值）: 電源電壓-最大:3.45 V 電源電壓-最小:2.375 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LLP-24 封裝:Reel |
| 9DB1904B | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:19 Output Differential Buffer for PCIe Gen2 and QPI |
| 9DB1904BKLF | 功能描述:時鐘緩沖器 19 OUTPUT PCIE GEN2 BUFFER w/QPI RoHS:否 制造商:Texas Instruments 輸出端數量:5 最大輸入頻率:40 MHz 傳播延遲（最大值）: 電源電壓-最大:3.45 V 電源電壓-最小:2.375 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LLP-24 封裝:Reel |
| 9DB1904BKLFT | 功能描述:時鐘緩沖器 19 OUTPUT PCIE GEN2 BUFFER w/QPI RoHS:否 制造商:Texas Instruments 輸出端數量:5 最大輸入頻率:40 MHz 傳播延遲（最大值）: 電源電壓-最大:3.45 V 電源電壓-最小:2.375 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LLP-24 封裝:Reel |
| 9DB1933 | 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:Nineteen Output Differential Buffer for PCIe Gen3 |
發布緊急采購，3分鐘左右您將得到回復。