參數資料
型號: 932S203YFT
廠商: INTEGRATED DEVICE TECHNOLOGY INC
元件分類: 時鐘產生/分配
英文描述: 133.3 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
封裝: 0.300 INCH, GREEN, MO-118, SSOP-56
文件頁數: 4/18頁
文件大?。?/td> 243K
代理商: 932S203YFT
IDTTM Frequency Generator with 133MHz Differential CPU Clocks
0601G—01/26/10
ICS932S203
Frequency Generator with 133MHz Differential CPU Clocks
12
General SMBus serial interface information
The information in this section assumes familiarity with SMBus programming.
For more information, contact ICS for an SMBus software program.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D2
(H)
ICS clock will acknowledge
Controller (host) sends a dummy command code
ICS clock will acknowledge
Controller (host) sends a dummy byte count
ICS clock will acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 5
ICS clock will acknowledge each byte one at a time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D3
(H)
ICS clock will acknowledge
ICS clock will send the byte count
Controller (host) acknowledges
ICS clock sends first byte (Byte 0) through byte 6
Controller (host) will need to acknowledge each byte
Controller (host) will send a stop bit
1.
The ICS clock generator is a slave/receiver, SMBus component. It can read back the data stored in the latches for
verification. Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator SMBus interface, the protocol is set to use only "Block-Writes" from the controller. The
bytes must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete byte
has been transferred. The Command code and Byte count shown above must be sent, but the data is ignored for those
two bytes. The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
Notes:
Controller (Host)
IC S (Slave/R eceiver)
Start Bit
Address
D2
(H )
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Stop Bit
How to Write:
Controller (Host)
IC S (Slave/R eceiver)
Start Bit
Address
D3
(H )
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Stop Bit
How to Read:
相關PDF資料
PDF描述
932S203YFLN 133.3 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
932S208DG 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
932S208DGLFT 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
932S208DGT 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
932S208DFLF 400 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
相關代理商/技術參數
參數描述
932S203YGLXT 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:Frequency Generator with 133MHz Differential CPU Clocks
932S208DFLF 功能描述:時鐘合成器/抖動清除器 SERVER MAIN CLOCK RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
932S208DFLFT 功能描述:時鐘合成器/抖動清除器 SERVER MAIN CLOCK RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
932S208DGLF 功能描述:時鐘合成器/抖動清除器 SERVER MAIN CLOCK RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel
932S208DGLFT 功能描述:時鐘合成器/抖動清除器 SERVER MAIN CLOCK RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel