參數資料
型號: 82C836A-16
廠商: Electronic Theatre Controls, Inc.
英文描述: Single-Chip 386sx AT
中文描述: 單芯片386sx在
文件頁數: 69/205頁
文件大小: 3878K
代理商: 82C836A-16
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁當前第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁
programmed for all six modes, but Mode 1 and Mode 5 have limited usefulness due the
the lack of an external hardware trigger signal. Counter 2 can be operated in any of six
modes listed as follows.
Mode 0----Interrupt on terminal count
Mode 1----Hardware retriggerable one-shot
Mode 2----Rate generator
Mode 3----Square wave generator
Mode 4----Software triggered strobe
Mode 5----Hardware re-triggeralbe strobe
All three counters in the CTC are driven from a common clock TMRCLK (1.19MHz)
derived by dividing OSC1 (14.31818MHz) by 12. Counter zero output (OUT0) is
connected to IRQ0 of INTC1 (see
Section 7, Interrupt Controller
) and may be used as
an interrupt to the system for time keeping and task switching. Counter 1 is programmed
to generate pulses for use by the refresh generator. The third counter (Counter 2) is a full
function Counter/Timer. This channel can be used as an interval timer, a counter, or as a
gated rate/pulse generator (normally used as a speaker tone generator).
Counter Description
Each counter in the CTC contains a Control Register, a Status Register, a 16-bit Counting
Element (CE), a pair of 8-bit Counter Input Latches (CIL and CIH), and a pair of 8-bit
Counter Output Latches (COL and COH). Each counter also has a clock input for
loading and decrementing the CE, a mode defined GATE input for controlling the
counter (only GATE2 is controlled by I/O port 61H, bit 0), and an OUT signal. The
OUT signal’s state and function are controlled by the Counter Mode and condition of
the CE.
The Control Register stores the mode and command information used to control the
counter. The Control Register may be loaded by writing a byte, containing a pointer to
the desired counter, to thE Write Control Word address (043H). The remaining bits in
the byte contain the mode, type of command, and count format information.
The Status Register allows the software to monitor counter condition and read back the
contents of the Control Register.
The Counting Element is a loadable 16-bit synchronous down-counter. The CE is loaded
or decremented on the falling edge of TMRCLK. The CE contains the maximum count
when a zero is loaded; this is equivalent to 65536 in binary operation or 10000 in BCD.
The CE does not stop when it reaches zero. In Modes 2 and 3, the CE is reloaded. In all
other modes it wraps around to FFFFH in binary operation or 9999 in BCD.
The CE is indirectly loaded by writing one or two bytes (optional) to the Counter Input
Latches which are in turn loaded into the CE. This allows the CE to be loaded or
reloaded in one TMRCLK cycle.
The CE is also read, indirectly, by reading the contents of the Counter Output Latches.
COL and COH are transparent latches that can be read while transparent or latched.
I
Counter Description
Real Time Clock and Internal Timer Registers
6-10
Revision 3.0
P R E L I M I N A R Y
Chips and Technologies, Inc.
相關PDF資料
PDF描述
82C836A-20 Single-Chip 386sx AT
82C836B Single-Chip 386sx AT
82C862 FireLink USB Dual Controller Quad Port USB
82C931 Plug and Play Integrated Audio Controller
82S09 576-BIT BIPOLAR RAM (64 X 9)
相關代理商/技術參數
參數描述
82C836A-20 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Chip 386sx AT
82C836B 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Chip 386sx AT
82C83H 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS Octal Latching Inverting Bus Driver
82C84 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS Clock Generator Driver
82C84A 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS Clock Generator Driver