- 您現在的位置：買賣IC網 > PDF目錄384066 > μPD75P0116 (NEC Corp.) 4 Bit RISC Microcontrollers(4 位單片微控制器) PDF資料下載
參數資料
| 型號： | μPD75P0116 |
| 廠商： | NEC Corp. |
| 英文描述： | 4 Bit RISC Microcontrollers(4 位單片微控制器) |
| 中文描述： | 4位RISC微控制器（4位單片微控制器） |
| 文件頁數： | 60/62頁 |
| 文件大小： | 309K |
| 代理商： | ΜPD75P0116 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁當前第60頁第61頁第62頁
m
PD75P0116
60
NOTES FOR CMOS DEVICES
1
PRECAUTION AGAINST ESD FOR SEMICONDUCTORS
Note: Strong electric field, when exposed to a MOS device, can cause destruction
of the gate oxide and ultimately degrade the device operation. Steps must be
taken to stop generation of static electricity as much as possible, and quickly
dissipate it once, when it has occurred. Environmental control must be
adequate. When it is dry, humidifier should be used. It is recommended to
avoid using insulators that easily build static electricity. Semiconductor
devices must be stored and transported in an anti-static container, static
shielding bag or conductive material. All test and measurement tools includ-
ing work bench and floor should be grounded. The operator should be
grounded using wrist strap. Semiconductor devices must not be touched with
bare hands. Similar precautions need to be taken for PW boards with
semiconductor devices on it.
2
HANDLING OF UNUSED INPUT PINS FOR CMOS
Note: No connection for CMOS device inputs can be cause of malfunction. If no
connection is provided to the input pins, it is possible that an internal input
level may be generated due to noise, etc., hence causing malfunction. CMOS
device behave differently than Bipolar or NMOS devices. Input levels of CMOS
devices must be fixed high or low by using a pull-up or pull-down circuitry.
Each unused pin should be connected to V
DD
or GND with a resistor, if it is
considered to have a possibility of being an output pin. All handling related
to the unused pins must be judged device by device and related specifications
governing the devices.
3
STATUS BEFORE INITIALIZATION OF MOS DEVICES
Note: Power-on does not necessarily define initial status of MOS device. Production
process of MOS does not define the initial operation status of the device.
Immediately after the power source is turned ON, the devices with reset
function have not yet been initialized. Hence, power-on does not guarantee
out-pin levels, I/O settings or contents of registers. Device is not initialized
until the reset signal is received. Reset operation must be executed immedi-
ately after power-on for devices having reset function.
相關PDF資料 |
PDF描述 |
|---|---|
| μPD75P3116 | 4 Bit Single Chip Microcontrollers(4位單片微控制器) |
| μPD75P3216 | 4 Bit Single Chip Microcontrollers(4位單片微控制器) |
| μPD780206 | 8 Bit Single Chip Microcontrollers(8位單片微控制器) |
| μPD780208 | 8 Bit Single Chip Microcontrollers |
| μPD780204 | 8 Bit Single Chip Microcontrollers(8位單片微控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PD75R-103K | 功能描述:固定電感器 10uH 10% .08ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| PD75R-104K | 功能描述:固定電感器 100uH 10% .5ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| PD75R-104K/R500 | 制造商:API Delevan 功能描述:PD75R series 100 uH 10 % 740 mA SMT Power Choke |
| PD75R-123K | 功能描述:固定電感器 12uH 10% .085ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| PD75R-123K TR 500 | 制造商:API Delevan 功能描述:POWER CHOKE 12 UH 10% SMD |
發布緊急采購，3分鐘左右您將得到回復。