- 您現在的位置：買賣IC網 > PDF目錄10007 > XRT82D20IWTR-F (Exar Corporation)IC LIU E1 SGL 28SOJ PDF資料下載
參數資料
| 型號： | XRT82D20IWTR-F |
| 廠商： | Exar Corporation |
| 文件頁數： | 17/27頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIU E1 SGL 28SOJ |
| 標準包裝： | 1,000 |
| 類型： | 線路接口裝置（LIU） |
| 驅動器/接收器數： | 1/1 |
| 規程： | E1 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-BSOJ |
| 供應商設備封裝： | 28-SOJ |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
XRT82D20
23
SINGLE CHANNEL E1 LINE INTERFACE UNIT
REV. 1.0.8
2.0
DIAGNOSTIC FEATURES
In order to support diagnostic operations, the XRT82D20 supports the following loop-back modes:
Local Loopback
Remote Loopback
Digital Loopback
Each of these loop-back modes will be discussed below.
2.1
The Local Loop-Back Mode
When the XRT82D20 is configured to operate in the Local Loop-Back Mode, the XRT82D20 will ignore any
signals that are input to the RTIP and RRing input pins. The Transmitting Terminal Equipment will transmit
data into the XRT82D20 via the TPOS, TNEG and TClk input pins. This data will be processed through the
Transmit Terminal Input Interface and the Pulse Shaping circuit. Finally, this data will be output to the line via
the TTIP and TRing output pins. Additionally, this data (which is being output via the TTIP and TRing output
pins) will be looped back into the Receiver block. As a consequence, this data will also be processed through
the entire Receive Section of the XRT82D20. After this post-loop-back data has been processed through the
Receive Section it will output, to the Near-End Receiving Terminal Equipment via the RPOS and RNEG output
pins.
Figure 18, illustrates the path that the data takes (within the XRT82D20), when the chip is configured to
operate in the Local Loop-Back Mode.
The user can configure the XRT82D20 to operate in the Local Loop-Back Mode, by pulling the LLoop input pin
(pin 9) to GND.
FIGURE 18. ILLUSTRATION OF THE ANALOG LOCAL LOOP-BACK WITHIN THE XRT82D20
HDB3
Encoder
Peak
Detector
Local
Loopback
LOS
Detect
Data
Slicer
Data &
Timing
Recovery
HDB3
Decoder
Tx Pulse
Shaper
MUX
Line
Driver
TClk
TPOS
TNEG
RClk
RPOS
RNEG
TTIP
TRing
RLOS
RTIP
RRing
MClk
Timing
Generator
Jitter Attenuator
相關PDF資料 |
PDF描述 |
|---|---|
| VE-BNR-MX-B1 | CONVERTER MOD DC/DC 7.5V 75W |
| MS27499E12A3SB | CONN RCPT 3POS BOX MNT W/SCKT |
| MS27468T23B55P | CONN RCPT 55POS JAM NUT W/PINS |
| MS27467E19B32SD | CONN PLUG 32POS STRAIGHT W/SCKT |
| MS27499E12B3SC | CONN RCPT 3POS BOX MNT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT82L24 | 制造商:EXAR 制造商全稱:EXAR 功能描述:QUAD E1 LINE TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT82L24A | 制造商:EXAR 制造商全稱:EXAR 功能描述:QUAD E1 LINE TRANSCEIVER WITH CLOCK RECOVERY AND JITTER ATTENUATOR |
| XRT82L24AES | 功能描述:外圍驅動器與原件 - PCI 4 CH E1 LIU SH RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT82L24AIV | 功能描述:外圍驅動器與原件 - PCI Four ChannelE1 LIU RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT82L24AIV-F | 功能描述:網絡控制器與處理器 IC Four ChannelE1 LIU RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。