- 您現在的位置：買賣IC網 > PDF目錄16425 > XR17C158CV-0A-EVB (Exar Corporation)EVAL BOARD FOR XR17C158-A 144TQF PDF資料下載
參數資料
| 型號： | XR17C158CV-0A-EVB |
| 廠商： | Exar Corporation |
| 文件頁數： | 50/67頁 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD FOR XR17C158-A 144TQF |
| 標準包裝： | 1 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁
XR17C158
xr
5V PCI BUS OCTAL UART
REV. 1.4.3
54
5.0 PROGRAMMING EXAMPLES
These examples are for devices with top mark date codes of "GC YYWW" and older.
5.1
UNLOADING RECEIVE DATA USING THE SPECIAL RECEIVE FIFO DATA WITH STATUS
It is suggested that before starting to read the Special Receive FIFO Data with Status to unload data from any
UART channel (address 0x180 for channel 0), do a dummy write to the Device ID (DVID) register in the Config-
uration Register of the device. The DVID register is a read-only register, so writing to it will not affect any of the
settings of the UART. The Special Receive FIFO Data with Status register can then be read multiple times sub-
sequently without any byte-swapping problem as long as no other register (except the Device ID register) is ac-
cessed in between data unload. If you must read or write to another register, make that dummy write to the
DVID register again and continue with data unloading.
A step by step procedure describing the sequence for a target channel is shown below. From the receive data
service routine:
Do a dummy write to Device ID (DVID) register. Address 0x8D in BYTE alignment or address 0x8C in DWORD
alignment.
Read the data byte and its associated error status from ‘Special Receive FIFO Data with Status’ register of the target
channel until done or empty when one of the LSR status byte bit-0=0.
NOTE: If you must do other Read/Write operations to other register(s) during data unloading, repeat steps 1 &
2 to continue unloading data plus status from the ‘Special Receive FIFO Data with Status’ register of the target
channel.
Some Examples of using the Special Receive FIFO Data with Status:
EXAMPLE I: POLLING
.....................
Read LSR
Write DVID
Read Special Receive FIFO Data with Status (address 0x180 for channel 0, etc)
Read Special Receive FIFO Data with Status (address 0x180 for channel 0, etc)*
....................
EXAMPLE 2: INTERRUPT SERVICE USING INTERRUPT INFORMATION IN DEVICE CONFIGURATION REGISTER SET
.....................
Read Global Interrupt Register INT0 (address 0x080)
Read INT1 through INT3 registers to identify interrupting channel (address 0x081 through 0x083)
Write DVID
Read Special Receive FIFO Data with Status (address 0x180 for channel 0, etc)
Read Special Receive FIFO Data with Status (address 0x180 for channel 0, etc)*
Read Special Receive FIFO Data with Status (address 0x180 for channel 0, etc)
................
EXAMPLE 3: INTERRUPT SERVICE USING INTERRUPT INFORMATION IN INDIVIDUAL CHANNEL’S REGISTERS
................
Read Global Interrupt Register INT0 (address 0x080)
Read ISR register of interrupting channel
Write DVID
Read Special Receive FIFO Data with Status (address 0x180 for channel 0, etc)
Read Special Receive FIFO Data with Status (address 0x180 for channel 0, etc)*
Read Special Receive FIFO Data with Status (address 0x180 for channel 0, etc)
................
* In case some other registers need to be accessed in between ‘Special Receive FIFO Data with Status’ reads,
a ‘Write DVID’ instruction has to be inserted before resuming ‘Special Receive FIFO Data with Status’ read
operation.
相關PDF資料 |
PDF描述 |
|---|---|
| SK221M025ST | CAP ALUM 220UF 25V 20% RADIAL |
| M3TTK-1436J | IDC CABLE - MSD14K/MC14G/MSD14K |
| CDB42L51 | BOARD EVAL FOR CS42L51 CODEC |
| GMM11DRKI | CONN EDGECARD 22POS DIP .156 SLD |
| UPJ1J151MHD6TO | CAP ALUM 150UF 63V 20% RADIAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR17C158CV-F | 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR17C158CVTR-F | 制造商:Exar Corporation 功能描述:UART 8-CH 64Byte FIFO 5V 144-Pin LQFP T/R 制造商:Exar Corporation 功能描述:XR17C158CVTR-F |
| XR17C158IV | 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR17C158IV-F | 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR17C158IVTR-F | 制造商:Exar Corporation 功能描述:UART 8-CH 64Byte FIFO 5V 144-Pin LQFP T/R 制造商:Exar Corporation 功能描述:XR17C158IVTR-F |
發布緊急采購，3分鐘左右您將得到回復。