REV. 1.0.3 HIGH PERFORMANCE DUART WITH 16-BYTE FIFO 4.11 Baud Rate Generator Registers (DLL, DLM and DLD) - Read/Write
參數資料
型號： XR16V2552IJ-F
廠商： Exar Corporation
文件頁數： 27/46頁
文件大小： 0K
描述： IC UART FIFO 16B DUAL 44PLCC
標準包裝： 27
特點： *
通道數： 2，DUART
FIFO's： 16 字節
規程： RS232，RS422
電源電壓： 2.25 V ~ 3.6 V
帶自動流量控制功能： 是
帶IrDA 編碼器/解碼器： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
帶CMOS： 是
安裝類型： 表面貼裝
封裝/外殼： 44-LCC（J 形引線）
供應商設備封裝： 44-PLCC（16.59x16.59）
包裝： 管件
XR16V2552
33
REV. 1.0.3
HIGH PERFORMANCE DUART WITH 16-BYTE FIFO
4.11
Baud Rate Generator Registers (DLL, DLM and DLD) - Read/Write
These registers make-up the value of the baud rate divisor. The concatenation of the contents of DLM and
DLL is a 16-bit value is then added to DLD[3:0]/16 to achieve the fractional baud rate divisor. DLD must be
enabled via EFR bit-4 before it can be accessed. See Table 13 below and SEE”PROGRAMMABLE BAUD
DLD[5:4]: Sampling Rate Select
These bits select the data sampling rate. By default, the data sampling rate is 16X. The maximum data rate will
double if the 8X mode is selected and will quadruple if the 4X mode is selected. See Table 13 below.
TABLE 13: SAMPLING RATE SELECT
SAMPLING RATE
0
16X
0
1
8X
1
X
4X
DLD[7:6]: Reserved
4.12
Alternate Function Register (AFR) - Read/Write
This register is used to select specific modes of MF# operation and to allow both UART register sets to be
written concurrently.
AFR[0]: Concurrent Write Mode
When this bit is set, the CPU can write concurrently to the same register in both UARTs. This function is
intended to reduce the dual UART initialization time. It can be used by the CPU when both channels are
initialized to the same state. The external CPU can set or clear this bit by accessing either register set. When
this bit is set, the channel select pin still selects the channel to be accessed during read operations. The user
should ensure that LCR Bit-7 of both channels are in the same state before executing a concurrent write to the
registers at address 0, 1, or 2.
Logic 0 = No concurrent write (default).
Logic 1 = Register set A and B are written concurrently with a single external CPU I/O write operation.
AFR[2:1]: MF# Output Select
These bits select a signal function for output on the MF# A/B pins. These signal function are described as:
OP2#, BAUDOUT#, or RXRDY#. Only one signal function can be selected at a time.
BIT-2
BIT-1
MF# FUNCTION
0
OP2# (default)
0
1
BAUDOUT#
1
0
RXRDY#
1
Reserved
AFR[7:3]: Reserved
All are initialized to logic 0.
4.13
Device Identification Register (DVID) - Read Only
This register contains the device ID (0x02 for XR16V2552). Prior to reading this register, DLL and DLM should
be set to 0x00 (DLD = 0xXX).
DLD[5]
DLD[4]
相關PDF資料
PDF描述
XR16V2650IM-F IC UART FIFO 32B DUAL 48TQFP
XR16V2651IM-F IC UART FIFO 32B DUAL 48TQFP
XR16V2652IJ-F IC UART FIFO 32B DUAL 44PLCC
XR16V2750IL-F IC UART FIFO 64B DUAL 32QFN
XR16V2751IM-F IC UART FIFO 64B DUAL 48TQFP
相關代理商/技術參數
參數描述
XR16V2552IJTR-F 制造商:Exar Corporation 功能描述:UART 2-CH 16Byte FIFO 2.5V/3.3V 44-Pin PLCC T/R 制造商:Exar Corporation 功能描述:XR16V2552IJTR-F
XR16V2552IL 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述:
XR16V2552IL-0B-EB 功能描述:UART 接口集成電路 Supports V2552 32pin QFN, PCI Interface RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR16V2552IL32 制造商:EXAR 制造商全稱:EXAR 功能描述:HIGH PERFORMANCE DUART WITH 16-BYTE FIFO
XR16V2552IL-F 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*