- 您現在的位置：買賣IC網 > PDF目錄376453 > XR16C850CM (EXAR CORP) UART with 128-byte FIFO’s FIFO Counters and Half-duplex Control PDF資料下載
參數資料
| 型號： | XR16C850CM |
| 廠商： | EXAR CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | UART with 128-byte FIFO’s FIFO Counters and Half-duplex Control |
| 中文描述： | 1 CHANNEL(S), 2.25M bps, SERIAL COMM CONTROLLER, PQFP48 |
| 封裝： | 7 X 7 MM, 1 MM HEIGHT, TQFP-48 |
| 文件頁數： | 12/55頁 |
| 文件大?。?/td> | 331K |
| 代理商： | XR16C850CM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁
XR16C850
12
Rev. 1.20
or “mark” condition). The inactive state (no data) for
the Infrared decoder interface is a logic 0. MCR bit-
6 selects the standard modem or infrared interface.
During the local loopback mode, the RX pin is
disconnected and TX data is internally connected to
the RX input, see figure 12.
TX / IRTX
11
13
8
8
O
Transmit Data - This pin provides the serial transmit
data from the 850. Two user selectable interface
options are available. The first user option supports
a standard modem interface. The second option
provides an Infrared encoder interface, see figures 2
and 3. When using the standard serial interface, the
TX signal will be a logic 1 during reset, idle (no data),
or when the transmitter is disabled. The inactive
state (no data) for the Infrared encoder interface is a
logic 0. MCR bit-6 selects the standard serial or
infrared interface. During the local loopback mode,
the TX pin is disconnected and TX data is internally
connected to the RX input, see figure 12.
CLKSEL
-
-
13
14
I
Clock Select Bit (internal pull-up). - The 1X or 4X pre-
scaleable clock is selected by this pin. The 1X clock
is selected when CLKSEL is a logic 1 (connected to
VCC) or the 4X is selected when CLKSEL is a logic
0 (connected to GND). MCR bit-7 can override the
state of this pin following reset or initialization (see
MCR bit-7). This pin is not available on 40 and 44 pin
packages which provide MCR bit-7 selection only.
-DMA
-
-
-
20
I
DMA mode enable (internal pull-up). DMA mode is
enabled when this pin is connected to GND. TC, -
DACK, DRQ functions are activated when DMA
mode is selected. TX and RX DMA mode can then
be selected by register EMSR bit 2. Connect this
pin to VCC when DMA mode is not used.
Symbol
Pin
Signal
type
Pin Description
40
44
48
52
SYMBOL DESCRIPTION
相關PDF資料 |
PDF描述 |
|---|---|
| XR16C850CP | UART with 128-byte FIFO’s FIFO Counters and Half-duplex Control |
| XR16C850CQ | UART with 128-byte FIFO’s FIFO Counters and Half-duplex Control |
| XR16C850 | UART with 128-byte FIFO’s FIFO Counters and Half-duplex Control |
| XR16C854 | QUAD UART WITH RX/TX FIFO COUNTERS,128-BYTE FIFO |
| XR16C854CJ | QUAD UART WITH RX/TX FIFO COUNTERS,128-BYTE FIFO |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR16C850CM-0A-EVB | 功能描述:UART 接口集成電路 Supports C850 48 ld TQFP, ISA Interface RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR16C850CM-F | 功能描述:UART 接口集成電路 UARTW/128BYTE FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR16C850CMTR-F | 功能描述:UART 接口集成電路 UART w/128 Bytes FIFO & IrDA RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR16C850CP | 制造商:EXAR 制造商全稱:EXAR 功能描述:UART with 128-byte FIFO’s FIFO Counters and Half-duplex Control |
| XR16C850CQ | 制造商:EXAR 制造商全稱:EXAR 功能描述:UART with 128-byte FIFO’s FIFO Counters and Half-duplex Control |
發布緊急采購，3分鐘左右您將得到回復。