- 您現在的位置：買賣IC網 > PDF目錄385049 > X84129-1.8 (IC MICROSYSTEMS Sdn. Bhd.) レPort Saver EEPROM PDF資料下載
參數資料
| 型號： | X84129-1.8 |
| 廠商： | IC MICROSYSTEMS Sdn. Bhd. |
| 英文描述： | レPort Saver EEPROM |
| 中文描述： | レ港口節電器的EEPROM |
| 文件頁數： | 5/18頁 |
| 文件大?。?/td> | 152K |
| 代理商： | X84129-1.8 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
X84161/641/129
5
Low Power Operation
The device enters an idle state, which draws minimal cur-
rent when:
—an illegal sequence is entered. The following are the
more common illegal sequences:
Read/Write/Write—any time
Read/Write ‘1’—When writing the address or
writing data.
Write ‘1’—when reading data
Read/Read/Write ‘1’—after data is written to
device, but before entering the NV write sequence.
—the device powers-up;
—a nonvolatile write operation completes.
While a sequential read is in progress, the device
remains in an active state. This state draws more current
than the idle state, but not as much as during a read
itself. To go back to the lowest power condition, an invalid
condition is created by writing a ‘1’ after the last bit of a
read operation.
Write Protection
The following circuitry has been included to prevent
inadvertent nonvolatile writes:
—The internal Write Enable latch is reset upon
power-up.
—A reset sequence must be issued to set the internal
write enable latch before starting a write sequence.
—A special “start nonvolatile write” command sequence
is required to start a nonvolatile write cycle.
—The internal Write Enable latch is reset automatically
at the end of a nonvolatile write cycle.
—The internal Write Enable latch is reset and remains
reset as long as the WP pin is LOW, which blocks all
nonvolatile write cycles.
—The internal Write Enable latch resets on an invalid
write operation.
SYMBOL TABLE
WAVEFORM
INPUTS
OUTPUTS
Must be
steady
Will be
steady
May change
from LOW to
HIGH
May change
from HIGH to
LOW
Will change
from LOW to
HIGH
Will change
from HIGH to
LOW
Don’t Care:
Changes
Allowed
N/A
Changing:
State Not
Known
Center Line
is High
Impedance
相關PDF資料 |
PDF描述 |
|---|---|
| X84129-2.5 | レPort Saver EEPROM |
| X84129G | レPort Saver EEPROM |
| X84129G-1.8 | レPort Saver EEPROM |
| X84129G-2.5 | レPort Saver EEPROM |
| X84129I | レPort Saver EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X84129-2.5 | 制造商:ICMIC 制造商全稱:IC MICROSYSTEMS 功能描述:レPort Saver EEPROM |
| X84129G | 制造商:ICMIC 制造商全稱:IC MICROSYSTEMS 功能描述:レPort Saver EEPROM |
| X84129G-1.8 | 制造商:ICMIC 制造商全稱:IC MICROSYSTEMS 功能描述:レPort Saver EEPROM |
| X84129G-2.5 | 制造商:ICMIC 制造商全稱:IC MICROSYSTEMS 功能描述:レPort Saver EEPROM |
| X84129I | 制造商:ICMIC 制造商全稱:IC MICROSYSTEMS 功能描述:レPort Saver EEPROM |
發布緊急采購，3分鐘左右您將得到回復。