- 您現在的位置：買賣IC網 > PDF目錄371199 > X24165PI Hot Swap Controller IC; Hot Swap Controller Type:Negative Voltage; Controlled Voltage Min:-10V; Controlled Voltage Max:-80V; Number of Controlled Voltages:1; Package/Case:8-SOIC; Power Good Output:Active High PDF資料下載
參數資料
| 型號： | X24165PI |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Hot Swap Controller IC; Hot Swap Controller Type:Negative Voltage; Controlled Voltage Min:-10V; Controlled Voltage Max:-80V; Number of Controlled Voltages:1; Package/Case:8-SOIC; Power Good Output:Active High |
| 中文描述： | 先進的2線串行E2PROM區塊可鎖定的保護 |
| 文件頁數： | 3/17頁 |
| 文件大小： | 79K |
| 代理商： | X24165PI |
X24165
3
DEVICE OPERATION
The X24165 supports a bidirectional bus oriented pro-
tocol. The protocol defines any device that sends data
onto the bus as a transmitter, and the receiving device
as the receiver. The device controlling the transfer is a
master and the device being controlled is the slave.
The master will always initiate data transfers, and pro-
vide the clock for both transmit and receive operations.
Therefore, the X24165 will be considered a slave in all
applications.
Clock and Data Conventions
Data states on the SDA line can change only during
SCL LOW. SDA state changes during SCL HIGH are
reserved for indicating start and stop conditions. Refer
to Figures 1 and 2.
Start Condition
All commands are preceded by the start condition,
which is a HIGH to LOW transition of SDA when SCL is
HIGH. The X24165 continuously monitors the SDA and
SCL lines for the start condition and will not respond to
any command until this condition has been met.
SCL
SDA
DATA STABLE
DATA
CHANGE
6551 ILL F04
SCL
SDA
START BIT
STOP BIT
6551 ILL F05
Figure 1. Data Validity
Figure 2. Definition of Start and Stop
Notes:
(5) Typical values are for T
(6) t
WR
is the minimum cycle time from the system perspective when polling techniques are not used. It is the maximum time the
device requires to perform the internal write operation.
A
= 25
°
C and nominal supply voltage (5V)
相關PDF資料 |
PDF描述 |
|---|---|
| X24165PM | Hot Swap Controller IC; Hot Swap Controller Type:Negative Voltage; Controlled Voltage Min:-10V; Controlled Voltage Max:-80V; Number of Controlled Voltages:1; Package/Case:8-SOIC; Power Good Output:Active High |
| X24165S | Hot Swap Controller IC; Hot Swap Controller Type:Negative Voltage; Controlled Voltage Min:-10V; Controlled Voltage Max:-80V; Number of Controlled Voltages:1; Package/Case:8-SOIC; Power Good Output:Active Low |
| X24165SI | Advanced 2-Wire Serial E2PROM with Block Lock Protection |
| X24165SM | Advanced 2-Wire Serial E2PROM with Block Lock Protection |
| X24165V | Advanced 2-Wire Serial E2PROM with Block Lock Protection |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X24165PI-2.7 | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:Advanced 2-Wire Serial E2PROM with Block Lock Protection |
| X24165PIG | 制造商:ICMIC 制造商全稱:IC MICROSYSTEMS 功能描述:Advanced 2-Wire Serial E2PROM with Block LockTM Protection |
| X24165PIG-2.7 | 制造商:ICMIC 制造商全稱:IC MICROSYSTEMS 功能描述:Advanced 2-Wire Serial E2PROM with Block LockTM Protection |
| X24165PM | 制造商:ICMIC 制造商全稱:IC MICROSYSTEMS 功能描述:Advanced 2-Wire Serial E2PROM with Block LockTM Protection |
| X24165PM-2.7 | 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:Advanced 2-Wire Serial E2PROM with Block Lock Protection |
發布緊急采購，3分鐘左右您將得到回復。