- 您現在的位置：買賣IC網 > PDF目錄359785 > VN380SP (意法半導體) Smart Solenoid Driver Solid State Relay(智能螺線管驅動器(固態繼電器)) PDF資料下載
參數資料
| 型號： | VN380SP |
| 廠商： | 意法半導體 |
| 英文描述： | Smart Solenoid Driver Solid State Relay(智能螺線管驅動器(固態繼電器)) |
| 中文描述： | 智能電磁驅動固態繼電器（智能螺線管驅動器（固態繼電器）） |
| 文件頁數： | 5/9頁 |
| 文件大?。?/td> | 89K |
| 代理商： | VN380SP |
FUNCTIONAL DESCRIPTION
-
CURRENT CUT OFF
When the load current rise above the current cut off level, S1 is automatically switched off and the
devices operates in recirculation mode (S2 active).S1is latched off until Agoes low and highagain.
This default is not displayed by diagnostic flag.
-
OPEN LOAD
If the load current is below the open load current level, the flag of the open load block is activated but
this default is displayed by the diagnosticoutput on the falling edge of input B and the diagnosticoutput
is latched at low level untilinput A goes low and high again. In case an open load is detected during an
active phase of input B, but disappears before a falling edge of input B, this default is not dispayed by
the diagnosticflag (see open load waveforms).
-
THERMAL SHUTDOWN
The device is internally protected against over temperaturesby the thermal circuit protection. When the
device junction temperature exceeds the protectionlimit, S1 is automatically switched off. Therefore the
device operates in recirculation mode (S2 active). S1 remain latched off until V
pwr1
goes low and high
again. This default is not dispayed by the diagnosticflag.
OVERVOLTAGE
During the ON state of S1 switch, if V
pwr1
or V
pwr2
is rising above the threshold detection S1 is
automaticallyswitched off, thereforethe device operatesin recirculation mode.
FIGURE 1: SWITCHING PARAMETER TEST CONDITIONS
VN380
5/9
相關PDF資料 |
PDF描述 |
|---|---|
| VNV14N04 | Fully Autoprotected Power MOSFET(全自動保護功率MOSFET) |
| VND5N07 | "OMNIFET": Fully Autoprotected Power MOSFET(全自動保護功率MOSFET) |
| V358Y | General Purpose, Input/Output Rail-to-Rail Low Power Operational Amplifiers |
| VIPER100A-E | SMPS PRIMARY I.C. |
| VIPER100ASP-E | SMPS PRIMARY I.C. |
相關代理商/技術參數 |
參數描述 |
|---|---|
| VN380SP13TR | 功能描述:固態繼電器-PCB安裝 VIPOWER RoHS:否 制造商:Omron Electronics 控制電壓范圍: 負載電壓額定值:40 V 負載電流額定值:120 mA 觸點形式:1 Form A (SPST-NO) 輸出設備:MOSFET 封裝 / 箱體:USOP-4 安裝風格:SMD/SMT |
| VN380SP-E | 功能描述:電源開關 IC - 配電 Standard Function High Side Switch RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| VN380SPTR-E | 功能描述:電源開關 IC - 配電 Standard Function High Side Switch RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| VN4 | 制造商:Carlo Gavazzi 功能描述:Sensor, Conductive Level Probe, 4 Electrodes, Nylon, 2 Meter PVC Cable |
| VN4012 | 制造商:SUPERTEX 制造商全稱:SUPERTEX 功能描述:N-Channel Enhancement-Mode Vertical DMOS FETs |
發布緊急采購，3分鐘左右您將得到回復。