
CHAPTER 1 INTRODUCTION
20
User’s Manual U15195EJ5V0UD
DMA controller
4-channel configuration
Transfer unit:
Maximum transfer count: 65,536 (2
Transfer type:
Transfer modes:
Transfer subjects:
Transfer requests:
Next address setting function
8 bits/16 bits
16
)
2-cycle transfer
Single transfer, single-step transfer, block transfer
Memory
Memory, Memory
I/O, I/O
I/O
On-chip peripheral I/O, software
I/O lines
Input ports: 6
I/O ports:
47
Timer/counter function
16-bit timer for 3-phase sine wave PWM inverter control: 2 channels
16-bit up/down counter/timer for 2-phase encoder input: 1 channel
General-purpose 16-bit timer/counter: 2 channels
General-purpose 16-bit timer/event counter: 1 channel
16-bit interval timer: 1 channel
Serial interface
Asynchronous serial interface (UART): 2 channels
Clocked serial interface (CSI): 2 channels
Of the four channels, two channels are used for both CSI and UART and therefore
one or the other function must be selected.
A/D converter
10-bit resolution A/D converter: 6 channels + 8 channels (2 units)
Regulator
Two power supplies, one for the internal CPU and one for the peripheral interface, are
not necessary. A 5 V single-power-supply system can be configured by connecting an
N-ch transistor (2SD1950 (VL standard product, surface mount type) or 2SD1581
(independent type) is recommended). If a 3.3 V power supply is available, it can be
directly connected to the REGIN pin.
Clock generator
Multiplication function (
×
1,
×
2.5,
×
5,
×
10) using PLL clock synthesizer
Divide-by-2 function using external clock input
Power-saving function
HALT, IDLE, and software STOP modes
Package
100-pin plastic LQFP (fine pitch) (14
×
14)
100-pin plastic QFP (14
×
20)
CMOS technology
Fully static circuits