參數資料
型號: U2480B
英文描述: Automotive Lamp Outage Monitor
中文描述: 汽車燈中斷監視器
文件頁數: 4/8頁
文件大?。?/td> 343K
代理商: U2480B
U2480B
TELEFUNKEN Semiconductors
Rev. A1, 22-Oct-97
4 (8)
Functional Description
Comparators
The voltage threshold of all internal comparators has a
typical value of Vth = 10 mV.
A voltage drop accross the shunt of Vsh
wVth means no
fault in the lamp circuit and the output is disabled.
In the event of a voltage drop Vsh
vVth, the output sup-
plies the current IO, and the pilot lamp is activated by the
external transistor.
The output is reliably disabled for a voltage at the refer-
ence pin of the comparators of VminRef
v 1/3 VS
The typical values of the input currents are 25
mA and are
equally large at the switch-over instant, thus making it
possible to connect protective resistors in series. The
internal threshold is independent of the value of the
protective resistor as long as all resistors of a comparator
have the same value.
Fuse Monitoring
It is possible to monitor the fuses of the lamp circuits by
means of an EXCLUSIVE OR function between K1 and
K3 and between K5 and K6.
If the Ref pin of K1 (orK5) is low and the Ref pin of K2
(or K6) is simultaneously high, or vice versa, a fault is
indicated.
Simultaneous failure of both fuses is not detected.
A fuse is faulty if the input voltage at the pin Ref falls
below the voltage VminRef (1/3 VS).
Time Delay
A fault is indicated only if it is present for td = 1.2
"0.2 s.
If an OK pulse
w100 ms occurs during this time, time
counting is reset to ”0”. An OK pulse is generated if the
comparators K1 to K8 and the input BL do not signal a
fault.
A periodic fault signal (period of less than 1 s) is indicated
only if the mark-to-space ratio is
w10/1, whereby the
pulse time corresponds to an item of fault information.
The time delay until the fault is indicated exceeds the time
td = 1.2 s in this case.
Storage
A failure in the break light circuit which is present for
longer than td is stored.
A voltage of VBL
v 0.15 VS which is present at the input
BL for longer than td leads to fault indication with
storage. This allows the possibility of additional flashing
monitoring.
A voltage of VBL
w 0.2 VS and of VBL v 0.65 VS which
is present at the input BL for longer than td leads to fault
indication without storage. It is thus possible to extend the
scope of monitoring beyond 11 lamps by means of
additional comparators ICs.
A voltage of VBL
w 0.7 VS at the input BL does not cause
a fault signal.
The turn indicator and the brake light memory is
maintained by VS (terminal 15)
Power-on Reset
When VBatt (terminal 15) is applied to Pin VS, a brief
signal is produced which generates the power-on reset. As
a result, the turn indicator, the brake light memory and the
counters are reset.
Outputs
A fault signal at the comparators K1 to K8 or at the
comparator Pin BL enables the output so that current IO
can flow. The output blocking voltage (VS – Vout) is
typically 1 V.
Threshold Testing without Time Delay td
To connect the input comparators directly to the output
pin, a voltage of 6 V at Pin OSC is necessary (omit ROSC
and COSC).
Absolute Maximum Ratings
Parameters
Symbol
Value
Unit
Supply voltage
VS, VBatt
16.5
V
Pulse current (2 ms)
IS
1.1
A
Short circuit current (reversed battery)
ISC
170
mA
Output current
Iout
–12
mA
Ambient temperature range
Tamb
–40 to +100
°C
相關PDF資料
PDF描述
U2861B-M Mono FM Sound Demodulator for TV Systems
U2861B-MFPG3 Mono FM Sound Demodulator for TV Systems
U2894B-AFSG3 Modulation PLL for GSM, DCS and PCS Systems
U3900BM Programmable Telephone Audio Processor
U3900BM-AFN Programmable Telephone Audio Processor
相關代理商/技術參數
參數描述
U2481B 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Automotive Lamp Outage Monitor
U2-482 制造商:OTTO Engineering Inc 功能描述:U2-096 WITH MIL CONNMS3476W12-3P
U2482B 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Automotive Lamp Outage Monitor
U249 制造商:BURNDY 功能描述:U-DIE
U2-493 制造商:OTTO Engineering Inc 功能描述:S/A U2-124,EXCPT W/