- 您現在的位置：買賣IC網 > PDF目錄98307 > TWL2213CAPFBR (TEXAS INSTRUMENTS INC) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQFP48 PDF資料下載
參數資料
| 型號： | TWL2213CAPFBR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQFP48 |
| 封裝： | PLASTIC, TQFP-48 |
| 文件頁數： | 15/33頁 |
| 文件大?。?/td> | 498K |
| 代理商： | TWL2213CAPFBR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
TWL2213CA
POWER SUPPLY MANAGEMENT IC AND
Li-Ion BATTERY CHARGE CONTROL
SLVS280 – MARCH 2001
22
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
control register—FCR1 (1BH)
BIT
NAME
DESCRIPTION
7
CHGSTR
Set this bit to 1 to start the charger operation. This bit is cleared if the charger is terminated. (Refer to status
register table below for terminated conditions)
6
ADC
ENABLE
Set this bit to 1 to enable ADC operation, 0 to stop.
5
ADC
Function
Set this bit to 1 to have ADC operate continuously. Set to 0 to have ADC to operate one cycle only.
4
ADBV
Set this bit to 1 to enable the VBAT input channel to ADC. 0: disable.
3
VTS
Set this bit to 1 to enable the VTS input channel to ADC. 0: disable.
2
ADCIN1
Set this bit to 1 to enable the ADCIN1 input channel.
1
ADCIN2
Set this bit to 1 to enable the ADCIN2 input channel.
0
IRQ
Status of IRQ pin (refer to IRQ operation section).
ADC has four input channels (ADBV, VTS, ADCIN1, ADCIN2). Each channel can be enabled or disabled
individually. The selected channel must be enabled before ADC FUNCTION and ADC ENABLE bits are
enabled, the channel is included in the ADC operation.
IRQ control/status
TWL2213 uses the IRQ signal to inform the external controller about the exception condition of the VCHG input
and the charger status. Bit0 reflects the state of the IRQ signal. IRQ occurs in the following five conditions:
1.
VCHG returns to operating range from non_operating range.
2.
VCHG goes out of range from operating range.
3.
Battery error—occurs only during the charging cycle.
4.
Battery temperature out of range—occurs only during the charging cycle. The charger is suspended
temporarily. IRQ is cleared when the temperature returns to normal and the charger resumes automatically.
5.
Charge complete.
The controller must clear the IRQ signal by writing 0 to Bit0 in the interrupt service routine, except in the VBOT
condition. The controller may miss the next interrupt if it fails to write the 0. In VBOT condition, TWL2213 clears
the IRQ when the condition goes away.
status register description—SR (1CH)
SR shows the status of the charger. The external controller reads the SR to track the state of the charging
condition.
相關PDF資料 |
PDF描述 |
|---|---|
| TWL2214CAGQER | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PBGA48 |
| TWL2214CAPFB | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQFP48 |
| TX810IRHHT | SPECIALTY ANALOG CIRCUIT, PQCC36 |
| TX810IRHHR | SPECIALTY ANALOG CIRCUIT, PQCC36 |
| TZA1031HL | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TWL2214CA | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Power Supply Management IC and Li-Ion Battery Charge Control |
| TWL2214CAPFB | 制造商:Rochester Electronics LLC 功能描述:POWER SUPPLY MANAGEMENT IC:LION - Bulk 制造商:Texas Instruments 功能描述:CHGR LI-ION/LI-POL 150MA 2.8V 48TQFP - Tape and Reel |
| TWL2214CAPFBR | 制造商:Rochester Electronics LLC 功能描述:POWER SUPPLY MANAGEMENT IC:LION - Bulk 制造商:Texas Instruments 功能描述:CHGR LI-ION/LI-POL 150MA 2.8V 48TQFP - Tape and Reel |
| TWL2217CGGMR | 制造商:Texas Instruments 功能描述: |
| TWL2217CZQER | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。