- 您現在的位置：買賣IC網 > PDF目錄300046 > TW13-D784-001 (Skyworks Solutions Inc.) 250 - 2700 MHz Linear, Low Current Power Amplifier Driver PDF資料下載
參數資料
| 型號： | TW13-D784-001 |
| 廠商： | Skyworks Solutions Inc. |
| 英文描述： | 250 - 2700 MHz Linear, Low Current Power Amplifier Driver |
| 中文描述： | 250 - 2700 MHz的線性，低電流功率放大器驅動器 |
| 文件頁數： | 9/11頁 |
| 文件大?。?/td> | 153K |
| 代理商： | TW13-D784-001 |
PRELIMINARY DATA SHEET SKY65008
Skyworks Solutions, Inc. Phone [781] 376-3000 Fax [781] 376-3100 sales@skyworksinc.com www.skyworksinc.com
200292A Skyworks Proprietary and Confidential information Products and Product Information are Subject to Change Without Notice April 21, 2005
7
Evaluation Board Description
The Skyworks SKY65008 Evaluation Board is used to test the
performance of the SKY65008 power amplifier driver. An
assembly drawing for the Evaluation Board is shown in Figure 10
and the layer detail is provided in Figure 11.
Circuit Design Configurations
The following design considerations are general in nature and
must be followed regardless of final use or configuration.
1. Paths to ground should be made as short as possible.
2. The ground pad of the SKY65008 power amplifier has special
electrical and thermal grounding requirements. This pad is the
main thermal conduit for heat dissipation. Since the circuit
board acts as the heat sink, it must shunt as much heat as
possible from the amplifier. As such, design the connection to
the ground pad to dissipate the maximum wattage produced
to the circuit board. Multiple vias to the grounding layer are
required.
NOTE: Junction temperature (TJ) of the device increases with a
poor connection to the slug and ground. This reduces the
lifetime of the device.
A suggested matching circuit is shown in Figure 12 with
component values listed in Table 5.
Testing Procedure
Use the following procedure to set up the SKY65008 Evaluation
Board for testing:
1. Connect a 3.3 V supply to VCC. If available, enable the current
limiting function of the power supply to 240 mA.
2. Connect a signal generator to the RF signal input port. Set it to
the desired RF frequency at a power level of –15 dBm or less
to the Evaluation Board but do NOT enable the RF signal.
3. Connect a spectrum analyzer to the RF signal output port.
4. Enable the power supply.
5. Enable the RF signal.
6. Take measurements.
CAUTION: If any of the output signals exceed the rated
maximum values, the SKY65008 Evaluation Board
can be permanently damaged.
GND
VCC
GND
R3
R2
R1
C7
C1 C2
C3
C8
C9
C5
C6
C4
L2
L1
J1 (RF In)
JP1
J2 (RF Out)
S446
Figure 10. Evaluation Board Assembly Drawing
相關PDF資料 |
PDF描述 |
|---|---|
| TW13-D786-001 | 250 - 2700 MHz Linear, Low Current Power Amplifier Driver |
| TW13-D787-001 | 250 - 2700 MHz Linear, Low Current Power Amplifier Driver |
| TX-1900-DCE-4161-666M514300 | TCXO, CLOCK, 666.5143 MHz, PECL OUTPUT |
| TX-3200-EBJ-156X-FREQ | TCXO, CLOCK, 1 MHz - 77.76 MHz, TTL OUTPUT |
| TX-3200-EBP-256X-10M0000000 | TCXO, CLOCK, 10 MHz, TTL OUTPUT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TW13-D786-001 | 制造商:SKYWORKS 制造商全稱:SKYWORKS 功能描述:250 - 2700 MHz Linear, Low Current Power Amplifier Driver |
| TW13-D787-001 | 制造商:SKYWORKS 制造商全稱:SKYWORKS 功能描述:250 - 2700 MHz Linear, Low Current Power Amplifier Driver |
| TW14 | 功能描述:導熱接口產品 Thermal Washer TO220 (10 per Pkg) RoHS:否 制造商:Panasonic Electronic Components 類型:Thermal Graphite Sheets 材料:Graphite Polymer Film 長度:180 mm 寬度:115 mm 厚度:0.07 mm 工作溫度范圍: |
| TW-140-180-062-T | 制造商:MISCELLANEOUS 功能描述: |
| TW-14-01-G-D-120-005 | 制造商:Samtec Inc 功能描述:CONN BD STACKER HDR 28 POS 2MM SLDR ST TH - Bulk |
發布緊急采購，3分鐘左右您將得到回復。