參數資料
型號: TUA6045-2
廠商: INFINEON TECHNOLOGIES AG
元件分類: 調諧器
英文描述: 3-BAND, VIDEO TUNER, QCC48
封裝: VQFN-48
文件頁數: 36/64頁
文件大?。?/td> 890K
代理商: TUA6045-2
Data Sheet
41
Revision 3.1, 2006-12-19
TUA 6045-2
TAIFUN 3
Reference
5.2
Bus Interface
Table 7
Pin Function
IF =36 MHz,
unless stated otherwise.
2) The RF frequency range is defined by the oscillator frequency range and the intermediate frequency (IF).
3) Local oscillator FM modulation resulting from I
2C communication is measured at the IF output using a
modulation analyzer with a peak to peak detector ((P
+ + P-) / 2) and a post detection filter 20 Hz - 100 kHz. The
I
2C messages are sent to the tuner in such a way that the tuner is addressed but the content of the PLL registers
are not altered. The refresh interval between each data set shall be 20 ms to 1 s.
4) (N+5) -1 MHz is defined as the input level of channel N+5, at frequency 1 MHz lower, causing 100 kHz FM
sidebands 30 dB below the wanted carrier.
5) Impedance measured with differential 2-port measurement at input or output. Input and output pins directly
connected to measurement equipment with 50
strip lines.
6) Limits are related to the tank circuit used in the application board. Frequency bands may be adjusted by the
choice of external components.
7) The supply ripple susceptibility is a sideband measurement using a spectrum analyzer connected to the IF
output. An unmodulated RF signal with a level of 80 dBV is applied to the test board RF input. A sinewave
signal with a defined frequency is superposed onto the supply voltage (see Figure 16 "Ripple susceptibility
measurement" on Page 62). The specified value is the worst case in the frequency range.
8) This is the level of divider interferences close to the IF frequency. For example channel S3: f
OSC = 158.15 MHz,
1/4 f
OSC = 39.5375 MHz. The rejection has to be greater than 60 dB for an SAW driver output of 100 dBV.
9) Crystal oscillator interference means the 4 MHz sidebands caused by the crystal oscillator. The rejection has
to be greater than 60 dB for an SAW driver output of 100 dBV.
10) The reference frequency rejection is the level of reference frequency sidebands (e.g. 62.5 kHz) related to the
carrier. The rejection has to be greater than 60 dB for an SAW driver output of 100dBV.
11) Channel S02 beat is the interfering product of f
RFpix, fIF and fOSC of channel S02, fBEAT = 37.35 MHz. The possible
mechanisms are f
OSC - 2 x fIF or 2 x fRFpix - fOSC.
Pin Designation
BUSMODE
SDA / Data
SCL / Clock
CAS / EN
Function
bus mode
select
serial data
clock
I
2C: chip address
select, 3-W: enable
I
2C mode
0
data in/out
clock in
four chip addresses
1)
3-Wire mode
1 or open
0: chip is addressed
相關PDF資料
PDF描述
TVP5010CPFP COLOR SIGNAL DECODER, PDSO80
TVP5010PFP COLOR SIGNAL DECODER, PQFP80
TVP5020CPFP COLOR SIGNAL DECODER, PQFP80
TVP5020 COLOR SIGNAL DECODER, PQFP80
TVP5022 COLOR SIGNAL DECODER, PQFP80
相關代理商/技術參數
參數描述
TUA60452XT 制造商:Infineon Technologies AG 功能描述:Tuners TV 1.492GMHz 48-Pin VQFN
TUA6045XT 制造商:Infineon Technologies AG 功能描述:GREEN, TERRESTRIAL
TUA6100 制造商:未知廠家 制造商全稱:未知廠家 功能描述:
TUA6100B6 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Components for Satellite Receiver Units
TUA6110XS 制造商:未知廠家 制造商全稱:未知廠家 功能描述:RF Mixer