參數資料
型號: tua 6012XS
廠商: SIEMENS AG
英文描述: 2 Band TV Tuner(兩波段電視調諧器)
中文描述: 2波段電視調諧器(兩波段電視調諧器)
文件頁數: 12/31頁
文件大?。?/td> 420K
代理商: TUA 6012XS
TUA 6012
TUA 6014
Semiconductor Group
12
1998-09-01
The software-switched ports P0, P1, P2 and P3 are general-purpose open-collector
outputs. The test bit T1 = 1, switches the test signals
f
ref
(4 MHz / reference divider ratio)
and
C
y
(divided input signal) to P0 and P1 respectively. P0, P1 are bidirectional.
The lock detector resets the lock flag FL when the width of the charge pump current
pulses is greater than the period of the crystal oscillator (i.e. 250 ns). Hence, when
FL = 1, the maximum deviation of the input frequency from the programmed frequency
is given by
f
= ±
I
P
(
K
VCO
/
f
Q
) (
C
1
+
C
2
) / (
C
1
C
2
)
where
I
P
is the charge pump current,
K
VCO
the VCO gain,
f
Q
the crystal oscillator
frequency and
C
1
,
C
2
the capacitances in the loop filter (see ”Application Circuits” on
page 27). As the charge pump pulses at 62.5 kHz (=
f
ref
), it takes a maximum of 16
μ
s
for FL to be reset after the loop has lost lock state.
Once FL has been reset, it is set only if the charge pump pulse width is less than 250 ns
for eight consecutive
f
ref
periods. Therefore it takes between 128 and 144
μ
s for FL to be
set after the loop regains lock.
2.3
Data is exchanged between the processor and the PLL via the
I
2
C Bus. The clock is
generated by the processor (input SCL), while pin SDA functions as an input or output
depending on the direction of the data (open collector, external pull-up resistor). Both
inputs have hysteresis and a low-pass characteristic, which enhance the noise immunity
of the
I
2
C Bus.
The data from the processor pass through an
I
2
C-Bus controller. Depending on their
function the data are subsequently stored in registers. If the bus is free, both lines will be
in the marking state (SDA, SCL are HIGH). Each telegram begins with the start condition
and ends with the stop condition. Start condition: SDA goes LOW, while SCL remains
HIGH. Stop condition: SDA goes HIGH while SCL remains HIGH. All further information
transfer takes place during SCL = LOW, and the data is forwarded to the control logic on
the positive clock edge.
The table ”Bit Allocation” (see ”Bit Allocation Read/Write” on page 13) should be referred
to the following description. All telegrams are transmitted byte-by-byte, followed by a
ninth clock pulse, during which the control logic returns the SDA line to LOW
(acknowledge condition). The first byte is comprised of seven address bits. These are
used by the processor to select the PLL from several peripheral components (chip
select). The LSB bit (R/W) determines whether data are written into (R/W = 0) or read
from (R/W = 1) the PLL.
In the data portion of the telegram during a WRITE operation, the MSB bit of the first or
third data byte determines whether a divider ratio or control information is to follow. In
I
2
C-Bus Interface
相關PDF資料
PDF描述
tua 6014-K Single Chip for Terrestrial Television(電視調諧芯片)
tua 6014-S Single Chip for Terrestrial Television(電視調諧芯片)
tua 6014XS Single Chip for Terrestrial Television(電視調諧芯片)
tua 6100 Direct Conversion IC for Digital QPSK Satellite Signals(對于數字QPSK衛星信號的直接轉換芯片)
tua 6110 SAT Mixer-Oscillator-PLL(衛星混頻器-振蕩器-鎖相環電路)
相關代理商/技術參數
參數描述
TUA6014-K 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Components for Entertainment Electronics
TUA6014-S 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Components for Entertainment Electronics
TUA6014XS 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Components for Entertainment Electronics
TUA6020 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:2 Band TV Tuner Mixer-Oscillator-PLL with balanced IF-Amplifier
TUA6020XT 制造商:Infineon Technologies AG 功能描述:TV Tuner Mixer-Oscillator-PLL with balanced IF-Amplifier 28-Pin TSSOP