- 您現在的位置：買賣IC網 > PDF目錄385033 > TSOP34156UH1 (Vishay Intertechnology,Inc.) IR Receiver Modules for Remote Control Systems PDF資料下載
參數資料
| 型號： | TSOP34156UH1 |
| 廠商： | Vishay Intertechnology,Inc. |
| 英文描述： | IR Receiver Modules for Remote Control Systems |
| 中文描述： | 紅外接收器模塊遠程控制系統 |
| 文件頁數： | 5/7頁 |
| 文件大?。?/td> | 177K |
| 代理商： | TSOP34156UH1 |
VISHAY
TSOP341..UH1
Vishay Semiconductors
Document Number 82255
Rev. 1.1, 26-Nov-03
www.vishay.com
5
Suitable Data Format
The circuit of the TSOP341..UH1 is designed in that
way that unexpected output pulses due to noise or
disturbance signals are avoided. A bandpass filter, an
integrator stage and an automatic gain control are
used to suppress such disturbances.
The distinguishing mark between data signal and dis-
turbance signal are carrier frequency, burst length
and duty cycle.
The data signal should fulfill the following conditions:
Carrier frequency should be close to center fre-
quency of the bandpass (e.g. 38 kHz).
Burst length should be 6 cycles/burst or longer.
After each burst which is between 6 cycles and 70
cycles a gap time of at least 10 cycles is necessary.
For each burst which is longer than 1.8 ms a corre-
sponding gap time is necessary at some time in the
data stream. This gap time should have at least same
length as the burst.
Up to 2200 short bursts per second can be received
continuously.
Some examples for suitable data format are: NEC
Code, Toshiba Micom Format, Sharp Code, RC5
Code, RC6 Code, RCMM Code, R-2000 Code,
RECS-80 Code.
When a disturbance signal is applied to the
TSOP341..UH1 it can still receive the data signal.
However the sensitivity is reduced to that level that no
unexpected pulses will occur.
Some examples for such disturbance signals which
are suppressed by the TSOP341..UH1 are:
DC light (e.g. from tungsten bulb or sunlight)
Continuous signal at 38 kHz or at any other fre-
quency
Signals from fluorescent lamps with electronic bal-
last (an example of the signal modulation is in the fig-
ure below).
Figure 13. Sensitivity vs. Supply Voltage
0.0
0.1
0.2
0.3
0.4
0.5
0.6
0.7
0.8
0.9
1.0
2.0
2.5
3.0
V
S
– Supply Voltage ( V )
3.5
4.0
4.5
5.0
5.5
6.0
17185
E
2
e
Figure 14. IR Signal from Fluorescent Lamp with low Modulation
0
5
10
15
20
Time ( ms )
16920
I
IR Signal from fluorescent
lamp with low modulation
相關PDF資料 |
PDF描述 |
|---|---|
| TSOP34430SB1F | IR Receiver Modules for Remote Control Systems |
| TSOP34433SB1F | IR Receiver Modules for Remote Control Systems |
| TSOP34436SB1F | IR Receiver Modules for Remote Control Systems |
| TSOP34437SB1F | IR Receiver Modules for Remote Control Systems |
| TSOP34438SB1F | IR Receiver Modules for Remote Control Systems |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSOP34333 | 制造商:Vishay Semiconductors 功能描述:3V IR RECEIVER 33KHZ SIDE VIEW - Rail/Tube |
| TSOP34336 | 制造商:Vishay Intertechnologies 功能描述:IR RECEIVER SMALL AGC3 36KHZ 制造商:Vishay Intertechnologies 功能描述:IR RECEIVER, SMALL AGC3, 36KHZ 制造商:Vishay Intertechnologies 功能描述:IR Remote Receiver 36KHz 45m 制造商:Vishay 功能描述:IR SENSOR IC 36KHZ -E3 PM2 VI1F |
| TSOP34336SB1 | 制造商:Vishay Semiconductors 功能描述: |
| TSOP34336SI1F | 制造商:Vishay Semiconductors 功能描述: |
| TSOP34336SS1F | 制造商:Vishay Intertechnologies 功能描述:IR Receiver Modules 36 kHz |
發布緊急采購，3分鐘左右您將得到回復。