參數資料
型號: TPS78628DCQ
廠商: Texas Instruments, Inc.
英文描述: ULTRALOW-NOISE, HIGH PSRR, FAST RF 1.5 A LOW-DROPOUT LINEAR REGULATORS
中文描述: 超低噪聲,高PSRR,快速射頻1.5低壓差線性穩壓器
文件頁數: 10/17頁
文件大小: 559K
代理商: TPS78628DCQ
www.ti.com
Programming the TPS78601 Adjustable LDO
Regulator
The output voltage of the TPS78601 adjustable
regulator is programmed using an external resistor
divider as shown in Figure 25. The output voltage is
calculated using Equation 1:
C1
(3 x 10
–7
) x (R1
(R1 x R2)
R2)
(3)
VO
Vref
1
R1
R2
(1)
Regulator Protection
The TPS786xx PMOS-pass transistor has a built-in
back diode that conducts reverse current when the
input voltage drops below the output voltage (e.g.,
during power down). Current is conducted from the
output to the input and is not internally limited. If
extended reverse voltage operation is anticipated,
external limiting might be appropriate.
R1
VO
Vref
1
R2
(2)
OUTPUT VOLTAGE
PROGRAMMING GUIDE
OUTPUT
VOLTAGE
R1
R2
C1
GND
NR
FB
IN
OUT
EN
V
IN
V
OUT
R1
C1
R2
0.01
μ
F
TPS78601
1
μ
F
1.8 V
3.6V
14.0 k
57.9 k
30.1 k
30.1 k
33 pF
15 pF
2.2
μ
F
TPS78601, TPS78618
TPS78625, TPS78628
TPS78630, TPS78633
SLVS389D–SEPTEMBER 2002–REVISED OCTOBER 2004
The suggested value of this capacitor for several
resistor ratios is shown in the table below. If this
capacitor is not used (such as in a unity-gain con-
figuration), then the minimum recommended output
capacitor is 2.2 μF instead of 1 μF.
where:
V
REF
= 1.2246 V typ (the internal reference
voltage)
Resistors R1 and R2 should be chosen for approxi-
mately 40-μA divider current. Lower value resistors
can be used for improved noise performance, but the
device wastes more power. Higher values should be
avoided, as leakage current at FB increases the
output voltage error. The recommended design pro-
cedure is to choose R2 = 30.1 k
to set the divider
current at 40 μA, C1 = 15 pF for stability, and then
calculate R1 using Equation 2:
The TPS786xx features internal current limiting and
thermal protection. During normal operation, the
TPS786xx limits output current to approximately 2.8
A. When current limiting engages, the output voltage
scales back linearly until the overcurrent condition
ends. While current limiting is designed to prevent
gross device failure, care should be taken not to
exceed the power dissipation ratings of the package.
If the temperature of the device exceeds approxi-
mately 165
°
C, thermal-protection circuitry shuts it
down. Once the device has cooled down to below
approximately 140
°
C, regulator operation resumes.
In order to improve the stability of the adjustable
version, it is suggested that a small compensation
capacitor be placed between OUT and FB. The
approximate value of this capacitor can be calculated
using Equation 3:
Figure 25. TPS78601 Adjustable LDO Regulator Programming
10
相關PDF資料
PDF描述
TPS72216DBVR LOW INPUT VOLTAGE, CAP FREE 50-mA LOW-DROPOUT LINEAR REGULATORS
TPS72215DBVR LOW INPUT VOLTAGE, CAP FREE 50-mA LOW-DROPOUT LINEAR REGULATORS
TPS7418DR VOLT REGULATOR|FIXED|+1.8V|CMOS|SOP|8PIN|PLASTIC
TPS7430DR VOLT REGULATOR|FIXED|+3V|CMOS|SOP|8PIN|PLASTIC
TPS76527 "Single Output LDO
相關代理商/技術參數
參數描述
TPS78628DCQG4 功能描述:低壓差穩壓器 - LDO High PSRR Fast RF High-Enable 1.5A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
TPS78628DCQR 功能描述:低壓差穩壓器 - LDO High PSRR Fast RF High-Enable 1.5A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
TPS78628DCQRG4 功能描述:低壓差穩壓器 - LDO High PSRR Fast RF High-Enable 1.5A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
TPS78628KTTR 功能描述:低壓差穩壓器 - LDO High PSRR Fast RF High-Enable 1.5A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
TPS78628KTTRG3 功能描述:低壓差穩壓器 - LDO High PSRR Fast RF High-Enable 1.5A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20