- 您現在的位置：買賣IC網 > PDF目錄384030 > TPS76133DBV (Texas Instruments, Inc.) LOW-POWER 100-mA LOW-DROPOUT LINEAR REGULATORS PDF資料下載
參數資料
| 型號： | TPS76133DBV |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | LOW-POWER 100-mA LOW-DROPOUT LINEAR REGULATORS |
| 中文描述： | 低功耗100毫安低壓降線性穩壓器 |
| 文件頁數： | 9/11頁 |
| 文件大小： | 198K |
| 代理商： | TPS76133DBV |
TPS76130, TPS76132, TPS76133, TPS76138, TPS76150
LOW-POWER 100-mA LOW-DROPOUT LINEAR REGULATORS
SLVS178A – DECEMBER 1998 – REVISED FEBRUARY 1999
9
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
1
3
5
TPS761xx
IN
EN
OUT
2
CI = 1
μ
F
Co = 4.7
μ
F
GND
Figure 17. TPS761xx Typical Application
over current protection
The over current protection circuit forces the TPS761xx into a constant current output mode when the load is
excessive or the output is shorted to ground. Normal operation resumes when the fault condition is removed.
NOTE:
An overload or short circuit may also activate the over temperature protection if the fault
condition persists.
over temperature protection
The thermal protection system shuts the TPS761xx down when the junction temperature exceeds 160
°
C. The
device recovers and operates normally when the temperature drops below 150
°
C.
input capacitor
A 1-
μ
F or larger ceramic decoupling capacitor with short leads connected between IN and GND is
recommended. The decoupling capacitor may be omitted if there is a 1
μ
F or larger electrolytic capacitor
connected between IN and GND and located reasonably close to the TPS761xx. However, the small ceramic
device is desirable even when the larger capacitor is present, if there is a lot of high frequency noise present
in the system.
output capacitor
Like all low dropout regulators, the TPS761xx requires an output capacitor connected between OUT and GND
to stabilize the internal control loop. The minimum recommended capacitance value is 4.7
μ
F and the ESR
(equivalent series resistance) must be between 0.1
and 10
. Solid tantalum electrolytic, aluminum
electrolytic, and multilayer ceramic capacitors are all suitable, provided they meet the requirements described
above. Most of the commercially available 4.7-
μ
F surface-mount solid-tantalum capacitors, including devices
from Sprague, Kemet, and Nichicon, meet the ESR requirements stated above. Multilayer ceramic capacitors
should have minimum values of 4.7
μ
F over the full operating temperature range of the equipment.
enable (EN)
A logic zero on the enable input shuts the TPS761xx off and reduces the supply current to less than 1
μ
A. Pulling
the enable input high causes normal operation to resume. If the enable feature is not used, EN should be
connected to IN to keep the regulator on all of the time. The EN input must not be left floating.
reverse current path
The power transistor used in the TPS761xx has an inherent diode connected between IN and OUT as shown
in the functional block diagram. This diode conducts current from the OUT terminal to the IN terminal whenever
IN is lower than OUT by a diode drop. This condition does not damage the TPS761xx provided the current is
limited to 150 mA.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS76150DBV | LOW-POWER 100-mA LOW-DROPOUT LINEAR REGULATORS |
| TPS76627 | "Single Output LDO |
| TPS76627D | ULTRA LOW QUIESCENT CURRENT 250-mA LOW-DROPOUT VOLTAGE REGULATORS |
| TPS76801Q | TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS(快速瞬變反應1A低壓差線性穩壓器) |
| TPS76825Q | Fast-Transient-Response 1-A Low-Dropout Voltage Regulators(快速瞬變反應1A低壓差2.5V線性穩壓器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS76133DBVR | 功能描述:低壓差穩壓器 - LDO 100mA 3.3V LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS76133DBVRG4 | 功能描述:低壓差穩壓器 - LDO Low Power 100-mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS76133DBVT | 功能描述:低壓差穩壓器 - LDO 100mA 3.3V LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS76133DBVTG4 | 功能描述:低壓差穩壓器 - LDO Low Power 100-mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS76138DBVR | 功能描述:低壓差穩壓器 - LDO 100mA 3.8V LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。