- 您現在的位置：買賣IC網 > PDF目錄385013 > TPS7418DR (Texas Instruments, Inc.) VOLT REGULATOR|FIXED|+1.8V|CMOS|SOP|8PIN|PLASTIC PDF資料下載
參數資料
| 型號： | TPS7418DR |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | VOLT REGULATOR|FIXED|+1.8V|CMOS|SOP|8PIN|PLASTIC |
| 中文描述： | 電壓調節器|定額| 1.8 |的CMOS |?？苵 8引腳|塑料 |
| 文件頁數： | 12/14頁 |
| 文件大小： | 249K |
| 代理商： | TPS7418DR |
TPS7415, TPS7418, TPS7425, TPS7430, TPS7433
FAST-TRANSIENT-RESPONSE USING SMALL OUTPUT CAPACITOR
200-mA LOW-DROPOUT VOLTAGE REGULATORS
SLVS212 – DECEMBER 1999
12
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
regulator protection (continued)
The TPS74xx also features internal current limiting and thermal protection. During normal operation, the
TPS74xx limits output current to approximately 500 mA. When current limiting engages, the output voltage
scales back linearly until the overcurrent condition ends. While current limiting is designed to prevent gross
device failure, care should be taken not to exceed the power dissipation ratings of the package. If the
temperature of the device exceeds 150
°
C(typ), thermal-protection circuitry shuts it down. Once the device has
cooled below 130
°
C (typ), regulator operation resumes.
power dissipation and junction temperature
Specified regulator operation is assured to a junction temperature of 125
°
C; the maximum junction temperature
should be restricted to 125
°
C under normal operating conditions. This restriction limits the power dissipation
the regulator can handle in any given application. To ensure the junction temperature is within acceptable limits,
calculate the maximum allowable dissipation, P
D(max)
, and the actual dissipation, P
D
, which must be less than
or equal to P
D(max)
.
The maximum-power-dissipation limit is determined using the following equation:
PD(max)
TJmax
TA
RJA
Where
T
J
max
is the maximum allowable junction temperature.
R
θ
JA
is the thermal resistance junction-to-ambient for the package, i.e., 172
°
C/W for the 8-terminal
SOIC.
T
A
is the ambient temperature.
The regulator dissipation is calculated using:
PD
VI
VO
IO
Power dissipation resulting from quiescent current is negligible. Excessive power dissipation will trigger the
thermal protection circuit.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS7430DR | VOLT REGULATOR|FIXED|+3V|CMOS|SOP|8PIN|PLASTIC |
| TPS76527 | "Single Output LDO |
| TPS76527D | ULTRA-LOW QUIESCIENT CURRENT 150-mA LOW-DROPOUT VOLTAGE REGULATORS |
| TPS76750Q | FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS |
| TPS76701Q | FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS7418DRG4 | 功能描述:低壓差穩壓器 - LDO Transient Response 200-mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS74201EVM-118 | 功能描述:電源管理IC開發工具 LDO REGULATOR RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS74201KTWR | 功能描述:低壓差穩壓器 - LDO Sgl Output LDO 1.5A Adj 0.8 to 3.3V RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS74201KTWRG3 | 功能描述:低壓差穩壓器 - LDO Sgl Output LDO 1.5A Adj 0.8 to 3.3V RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS74201KTWT | 功能描述:低壓差穩壓器 - LDO Sgl Output LDO 1.5A Adj 0.8 to 3.3V RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。