- 您現在的位置：買賣IC網 > PDF目錄98286 > TPS65562RGT (TEXAS INSTRUMENTS INC) BATTERY CHARGE CONTROLLER, PQCC16 PDF資料下載
參數資料
| 型號： | TPS65562RGT |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | BATTERY CHARGE CONTROLLER, PQCC16 |
| 封裝： | PLASTIC, QFN-16 |
| 文件頁數： | 14/16頁 |
| 文件大小： | 534K |
| 代理商： | TPS65562RGT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁
www.ti.com
PRINCIPLES OF OPERATION
CHG
(VOUT)
XFULL
F_ON
G_IGBT
(ENA)
~~
tim
eA
tim
eB
tim
eC
tim
eD
tim
eE
tim
eF
tim
eG
tim
eH
tim
eI
tim
eJ
Start/Stop Charging
Indicate Charging Status
SLVS775 – JUNE 2007
Figure 4. Whole Operation Sequence Chart
TPS65562 has one internal enable latch, F1, that holds the charge enable (ON/OFF status) of the device (see
Figure 4).
The only way to start charging is to input CHG
↑ (see time A/C/H in Figure 4). Each time CHG↑ is applied, the
TPS65562 starts charging.
There are three trigger events to stop charging:
1. Forced stop by inputting CHG = L from the controller (see timeB in Figure 4).
2. Automatic stop by detecting a full charge. VOUT reaches the target value (see TimeD in Figure 4).
3. Protected stop by detecting an overcurrent function (OVDS) trigger at SW pin (see TimeI in Figure 4).
When the charging operation is complete, the TPS65562 drives the charge completion indicator pin, XFULL, to
GND. A controller can detect the status of the device as a logic signal when connected through a pullup resister,
R1 (see Figure 1).
The XFULL output enables the controller to detect the OVDS protection status. If OVDS protection occurs,
XFULL never goes L during CHG = H. Therefore, the controller detects OVDS protection by measuring the time
from CHG high to XFULL low. If the time to XFULL low is longer than the maximum designed charge time, then
an OVDS protection occurred.
The device starts charging at timeH, and OVDS protection occurs at TimeI (see Figure 5). At TimeI, XFULL
stays H. At TimeJ, the controller detects OVDS protection through the expiration of a timer ends and then sets
CHG to low to terminate the operation.
7
相關PDF資料 |
PDF描述 |
|---|---|
| TPS65810RTQ | 9-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC56 |
| TPS65810RTQT | 9-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC56 |
| TPS65820RSHTG4 | 8-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC56 |
| TPS65910RSLT | POWER SUPPLY SUPPORT CKT, PQCC48 |
| TPS65920A2ZCHR | SPECIALTY CONSUMER CIRCUIT, PBGA139 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS65562RGTR | 功能描述:功率驅動器IC Integr Photo Flash Charger & IGBT Drvr RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS65562RGTRG4 | 功能描述:功率驅動器IC Photo flash charger w/ IGBT driver RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS65562RGTT | 功能描述:功率驅動器IC Integr Photo Flash Charger & IGBT Drvr RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS65562RGTTG4 | 功能描述:功率驅動器IC Photo flash charger w/ IGBT driver RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| TPS65563ARGTR | 功能描述:功率驅動器IC Integr Photo Flash Charger & IGBT Drvr RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。