參數資料
型號: TPS62240DDC
廠商: Texas Instruments, Inc.
英文描述: 2.25 MHz 300 mA Step Down Converter in 2x2SON/TSOT23 Package
中文描述: 2.25兆赫300毫安降壓轉換器2x2SON/TSOT23包
文件頁數: 17/29頁
文件大小: 859K
代理商: TPS62240DDC
www.ti.com
V
IN
GND
EN
FB
SW
TPS62243DRV
L
1
2.2 H
μ
C
IN
4.7 μF
C
OUT
10 F
μ
V
OUT
1.8V
Up to 300mA
MODE
V
IN
2.0V to 6V
OUTPUT VOLTAGE SETTING
The output voltage can be calculated to:
V
OUT
V
REF
1
R
1
R
2
with an internal reference voltage V
REF
typical 0.6 V.
OUTPUT FILTER DESIGN (INDUCTOR AND OUTPUT CAPACITOR)
The TPS62240 is designed to operate with inductors in the range of 1.5
μ
H to 4.7
μ
H and with output capacitors in
the range of 4.7
μ
F to 22
μ
F. The part is optimized for operation with a 2.2
μ
H inductor and 10
μ
F output capacitor.
Inductor Selection
TPS62240, TPS62242, TPS62243
SLVS762B–JUNE 2007–REVISED SEPTEMBER 2007
Figure 30. TPS62243 Fixed 1.8 V
To minimize the current through the feedback divider network, R
2
should be 180 k
or 360 k
. The sum of R
1
and R
2
should not exceed ~1M
, to keep the network robust against noise.
An external feed forward capacitor C
1
is required for optimum load transient response. The value of C
1
should be
in the range between 22pF and 33pF.
Route the FB line away from noise sources, such as the inductor or the SW line.
Larger or smaller inductor values can be used to optimize the performance of the device for specific operation
conditions. For stable operation, the L and C values of the output filter may not fall below 1
μ
H effective
Inductance and 3.5
μ
F effective capacitance. Selecting larger capacitors is less critical because the corner
frequency of the L-C filter moves to lower frequencies with fewer stability problems.
The inductor value has a direct effect on the ripple current. The selected inductor has to be rated for its dc
resistance and saturation current. The inductor ripple current (
Δ
I
L
) decreases with higher inductance and
increases with higher V
I
or V
O
.
The inductor selection has also impact on the output voltage ripple in PFM mode. Higher inductor values will lead
to lower output voltage ripple and higher PFM frequency, lower inductor values will lead to a higher output
voltage ripple but lower PFM frequency.
Equation 1
calculates the maximum inductor current in PWM mode under static load conditions. The saturation
current of the inductor should be rated higher than the maximum inductor current as calculated with
Equation 2
.
This is recommended because during heavy load transient the inductor current will rise above the calculated
value.
Copyright 2007, Texas Instruments Incorporated
Submit Documentation Feedback
17
Product Folder Link(s):
TPS62240 TPS62242 TPS62243
相關PDF資料
PDF描述
TPS62240DRV 2.25 MHz 300 mA Step Down Converter in 2x2SON/TSOT23 Package
TPS62290DRV Half Bridge Gate Driver; Package: 8-SO-8; Container: Tape & Reel
TPS71025PW LOW-DROPOUT VOLTAGE REGULATOR
TPS71025Y LOW-DROPOUT VOLTAGE REGULATOR
TPS715 50 mA, 24 V, 3.2 uA Supply Current Low-Dropout Linear Regulator
相關代理商/技術參數
參數描述
TPS62240DDCR 功能描述:直流/直流開關調節器 2.25MHz 300mA Step- Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62240DDCRG4 功能描述:直流/直流開關調節器 2.25MHz 300mA Step- Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62240DDCT 功能描述:直流/直流開關調節器 2.25MHz 300mA Step- Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62240DDCTG4 功能描述:直流/直流開關調節器 2.25MHz 300mA Step- Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5
TPS62240DRVR 功能描述:直流/直流開關調節器 2.25MHz 300mA Step- Down Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5