- 您現在的位置：買賣IC網 > PDF目錄244229 > TPS62122DRV (TEXAS INSTRUMENTS INC) SWITCHING REGULATOR, PDSO6 PDF資料下載
參數資料
| 型號： | TPS62122DRV |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, PDSO6 |
| 封裝： | 2 X 2 MM, GREEN, PLASTIC, SON-6 |
| 文件頁數： | 9/33頁 |
| 文件大?。?/td> | 5549K |
| 代理商： | TPS62122DRV |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
OUT
ON
IN
V
T
=
1.3 s
V
(
)
IN
OUT
LPFMpeak
ON
V
I
=
T
L
-
www.ti.com
SLVSAD5 – JULY 2010
DETAILED DESCRIPTION
OPERATION
The TPS6212x synchronous step down converter family uses an unique hysteretic PFM/PWM controller scheme
which enables switching frequencies of up to 800kHz, excellent transient response and AC load regulation at
operation with small output capacitors.
At high load currents the converter operates in quasi fixed frequency PWM mode operation and at light loads in
PFM (Pulse Frequency Modulation) mode to maintain highest efficiency over the full load current range. In PFM
Mode, the device generates a single switch pulse to ramp the inductor current and charge the output capacitor,
followed by a sleep period where most of the internal circuits are shutdown to achieve a quiescent current of
typically 10A. During this time, the load current is supported by the output capacitor. The duration of the sleep
period depends on the load current and the inductor peak current.
A significant advantage of TPS6212x compared to other hysteretic controller topologies is its excellent DC and
AC load regulation capability in combination with low output voltage ripple over the entire load range which
makes this part well suited for audio and RF applications.
Main Control Loop
The feedback comparator monitors the voltage on the FB pin and compares it to an internal 800mV reference
voltage.
The feedback comparator trips once the FB voltage falls below the reference voltage. A switching pulse is
initiated and the high-side MOSFET switch is turned on. It remains turned on at least for the minimum On Time
TONmin of typical 700ns until the feedback voltage is above the reference voltage or the inductor current reaches
the high-side MOSFET switch current limit ILIMF. Once the high-side MOSFET switch turns off, the low-side
MOSFET switch is turned on and the inductor current ramps down. It is turned on at least for the minimum Off
Time TOFFmin of typically 60ns. The low-side MOSFET switch stays turned on until the FB voltage falls below the
internal reference and trips the FB comparator again. This will turn on the high-side MOSFET switch for a new
switching cycle.
If the feedback voltage stays above the internal reference the low-side MOSFET switch is turned on until the
zero current comparator trips and indicates that the inductor current has ramped down to zero. In this case, the
load current is much lower than the average inductor current provided during one switching cycle. The regulator
turns the low-side and high-side MOSFET switches off (high impedance state) and enters a sleep cycle with
reduced quiescent current of typically 10uA until the output voltage falls below the internal reference voltage and
the feedback comparator trips again. This is called PFM Mode and the switching frequency depends on the load
current, input voltage, output voltage and the external inductor value.
Once the high-side switch current limit comparator has tripped its threshold of ILIMF, the high-side MOSFET
switch is turned off and the low-side MOSFET switch is turned on until the inductor current has ramped down to
zero.
The minimum On Time TONmin for a single pulse can be estimated to:
(1)
Therefore the peak inductor current in PFM mode is approximately:
(2)
The transition from PFM mode to PWM mode operation and back occurs at a load current of approximately
ILPFMpeak.
With:
TON: high-side MOSFET switch on time [s]
VIN: Input voltage [V]
VOUT: Output voltage [V]
L : Inductance [H]
ILPFMpeak : PFM inductor peak current [mA]
Copyright 2010, Texas Instruments Incorporated
17
相關PDF資料 |
PDF描述 |
|---|---|
| TC151A4316EOA713 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC151B1622EOA723 | 0.25 A SWITCHING REGULATOR, 50 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC161B3517EOA713 | 0.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC161B1719EOA723 | 0.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, PDSO8 |
| TC161B3321EOA723 | 0.25 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS62122DRVR | 功能描述:直流/直流開關轉換器 15V75mA96% Eff Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS62122DRVT | 功能描述:直流/直流開關轉換器 15V75mA96% Eff Step-Down Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| TPS62122DRVT | 制造商:Texas Instruments 功能描述:IC SYNC BUCK DC/DC CONTROLLER 800KHZ 制造商:Texas Instruments 功能描述:IC, SYNC BUCK DC/DC CONTROLLER, 800KHZ, 6-SON |
| TPS62122EVM-586 | 功能描述:電源管理IC開發工具 TPS62122 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS62122EVM-586 | 制造商:Texas Instruments 功能描述:EVAL BOARD, TPS62122, BUCK CONVERTER |
發布緊急采購，3分鐘左右您將得到回復。