- 您現在的位置：買賣IC網 > PDF目錄98283 > TPS61045DRBR (TEXAS INSTRUMENTS INC) 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8 PDF資料下載
參數資料
| 型號： | TPS61045DRBR |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.45 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | 3 X 3 MM, GREEN, PLASTIC, SON-8 |
| 文件頁數： | 4/21頁 |
| 文件大?。?/td> | 582K |
| 代理商： | TPS61045DRBR |
V
O +
1.233 V
1 )
R1
R2
C
FF [
1
2
p
fs
20
R1
1
D
O
P
O
P
O
s(ILOAD)
O
F
IN
I
L
V
I
ESR
C
f
V
÷
÷
=
-
+
÷
÷
+
-
÷
è
IN
P
V
I
= 375 m A +
x 100 ns
L
SLVS440B – JANUARY 2003 – REVISED MARCH 2009
www.ti.com
To reduce the overall operating quiescent current in battery powered applications a high impedance voltage
divider must be used with a typical value for R2 of
≤ 200 k and a maximum value for R1 of 2.2 M.
Some applications may not need the digital interface to program the output voltage. In this case the output DO
can be left open as shown in Figure 18 and the output voltage is calculated as for any standard boost converter:
In such a configuration a high impedance voltage divider must also be used to minimize ground current and a
typical value for R2 of
≤ 200 k and a maximum value for R1 of 2.2 M are recommended.
A feed-forward capacitor (C(FF)), across the upper feedback resistor (R1), is required to provide sufficient
overdrive for the error comparator. Without a feed-forward capacitor or a too small feed-forward capacitor value,
the device shows double pulses or a pulse burst instead of single pulses at the switch node (SW). This can
cause higher output voltage ripple. If a higher output voltage ripple is acceptable, the feedforward capacitor can
be left out too.
The lower the switching frequency of the converter, the larger the feed-forward capacitor value needs to be. A
good starting point is the use of a 10 pF feed-forward capacitor. As a first estimation, the required value for the
feed-forward capacitor can be calculated at the operation point:
with:
R1 = upper resistor of voltage divider
fS = switching frequency of the converter at the nominal load current. (For the calculation of the switching
frequency see previous section)
For C(FF) choose a value which comes closest to the calculation result.
The larger the feed-forward capacitor, the worse the line regulation of the device. Therefore, the feed-forward
capacitor must be selected as small as possible if good line regulation is of concern.
OUTPUT CAPACITOR SELECTION
For better output voltage filtering a low ESR output capacitor is recommended. Ceramic capacitors have low
ESR values but depending on the application, tantalum capacitors can also be used. See Table 4 and the
TYPICAL APPLICATIONS for the selection of the output capacitor.
Assuming the converter does not show double pulses or pulse bursts on the switch node (SW) the output voltage
ripple is calculated as:
with:
IP = peak current as described in the previous section peak current control
L = selected inductor value
IO(LOAD)= Nominal load current
fS(ILoad) = switching frequency at the nominal load current as calculated previously.
VF = rectifier diode forward voltage (typically 0.3 V)
CO = selected output capacitor
ESR = output capacitor ESR value
12
Copyright 2003–2009, Texas Instruments Incorporated
Product Folder Link(s): TPS61045
相關PDF資料 |
PDF描述 |
|---|---|
| TPS61080DRCR | 1 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61081DRCTG4 | 1.3 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61080DRCTG4 | 0.5 A SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61093DSK | 1.5 A SWITCHING REGULATOR, 1400 kHz SWITCHING FREQ-MAX, PDSO10 |
| TPS61122PWRG4 | 1.6 A BATTERY CHARGE CONTROLLER, 600 kHz SWITCHING FREQ-MAX, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS61045DRBRG4 | 功能描述:LED顯示驅動器 28-V 85% Eff Boost Converter RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube |
| TPS61045DRBT | 功能描述:LED顯示驅動器 28-V 85% Eff Boost Converter RoHS:否 制造商:Micrel 數位數量:5 片段數量: 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-44 工作電源電壓:4.75 V to 11 V 最大電源電流:10 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝:Tube |
| TPS61045DRBTG4 | 功能描述:LED照明驅動器 28-V 85% Eff Boost Converter RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| TPS61045EVM-231 | 功能描述:電源管理IC開發工具 TPS61045-231 Eval Mod RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS61046EVM-682 | 功能描述:TPS61046 - DC/DC, Step Up 2, Non-Isolated Outputs Evaluation Board 制造商:texas instruments 系列:- 零件狀態:有效 主要用途:DC/DC，步升 輸出和類型:2，非隔離 功率 - 輸出:- 電壓 - 輸出:12V，5 V ~ 28 V 電流 - 輸出:100mA，20mA 電壓 - 輸入:1.8 V ~ 5.5 V 穩壓器拓撲:升壓 頻率 - 開關:1MHz 板類型:完全填充 所含物品:板 使用的 IC/零件:TPS61046 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。